Question about Kia Rio

Open Question

Iat sensor location 2003 kia rio - Rio Kia Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 40 Answers

SOURCE: trying to locate the IAT sensor

http://www.kiatechinfo.com/index.asp

Good source for Kia its free to register NO STRINGS

Posted on Jun 01, 2009

Molson02536
  • 3854 Answers

SOURCE: locating the iat sensor on a 2003 dodge 5.9

The IAT sensor is along the intake tube before the throttle body. If your planing to buy the performance chip from EBAY or any other place, save your money. You can go to Radio shack and it will cost you less then $3.00 for the resistor needed to make your own "performance Chip" IF you like you can use and 10K ohm potentiometer wire it through to the IAT sensor wire harness so you can adjust your timing for the type of fuel you want to use or how much performance you want out of your engine. Here is a link to the installation of the resistors and the different resistor's you can use or like me use a Potentiometer. Note if the timing is to high on hot days, the knock sensor may trigger and the engine will power down 15% till next start up. Good luck and hope this helps. http://kingenterprises.net/IAT-Timing-Tricker.htm

Posted on Jun 15, 2009

morse008
  • 1111 Answers

SOURCE: iat sensor locate 2003 kia rio

wiki.answers.com/.../Where_is_the_Intake_Air_Temperature_sensor_on_2000_Kia_Rio -

Posted on Dec 05, 2009

arauzvictor1
  • 466 Answers

SOURCE: knock sensor replacement

Turn ignition off. Disconnect knock sensor 3
-
pin harness connector. Locate knock sensor, on cyli
nder block.
On Optima 2.7L engine, sensors are located on both
sides of cylinder block. . Remove knock
sensor from cylinder block. To install, reverse rem
oval procedure.

Posted on Mar 19, 2010

daves944
  • 1050 Answers

SOURCE: Where is the IAT sensor on a 2007 Kia Rio?

The IAT is built into the MAF sensor, which is right behind the air filter in the air intake hoseae007bb.jpg

Posted on May 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cam sensor location for a 2004 1.6 4 cyl. Kia Rio


The cam sensor on a 2003 Kia Rio is located on the front, driver's side of the engine, Should be the same on the 2004 ki8a reo's. God-Bless! This is for the 1.6,

May 20, 2015 | 2004 Kia Rio

1 Answer

P0113 kia rio


The error code given in the data sheet is Intake air temperature (IAT) sensor - high input and the probable cause is Wiring open circuit/short to positive, earth wire defective, IAT sensor, ECM. hope that helps

Mar 13, 2014 | 2002 Kia Rio

1 Answer

Where is the iat sensor located on a 2003 kia sorento


Intake Air Temperature (IAT) Sensor: this sensor is located in the air intake plenum assembly. This sensor is combined with the MAF sensor.

Hope helps (remember to rating this free answer).

Oct 07, 2011 | 2003 Kia Sorento

1 Answer

Where is the IAT sensor on a 2007 Kia Rio? A picture would be great.


The IAT is built into the MAF sensor, which is right behind the air filter in the air intake hoseae007bb.jpg

May 09, 2010 | 2002 Kia Rio

1 Answer

Need to locate iat sensor on 2001 kia rio


at the back of the intake maifold

May 09, 2010 | 2001 Kia Rio

1 Answer

Knock sensor replacement ....2003 kia rio....emissions ...obd II....failure...need to pass inspection...failure code P0325 (Knock sensor 1 circuit malfunction)....where vis the knock sensor located on a...


Turn ignition off. Disconnect knock sensor 3
-
pin harness connector. Locate knock sensor, on cyli
nder block.
On Optima 2.7L engine, sensors are located on both
sides of cylinder block. . Remove knock
sensor from cylinder block. To install, reverse rem
oval procedure.

Mar 19, 2010 | 2003 Kia Rio

3 Answers

Where is the knock sensor located on 2003 Kia Rio


2003 kia rio, It is located under the intake manifold. Get underneath the car, pull the oil filter...it is right above it and in clear view with the oil filter out of the way. The connector plug is up top behing the air breather on the firewall.

Dec 25, 2009 | 2003 Kia Rio

1 Answer

Iat sensor locate 2003 kia rio


wiki.answers.com/.../Where_is_the_Intake_Air_Temperature_sensor_on_2000_Kia_Rio -

Nov 22, 2009 | 2003 Kia Rio

1 Answer

I can not find where the iat sensor goes on my 2005 kia rio


The intake air temperature sensor (IAT sensor) (12A697) is located in the engine air cleaner cover. When installing, use care not to damage plastic locking tabs.
I hope this helps you

Oct 06, 2009 | 2005 Kia Rio

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75817 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...