Question about 1999 Dodge Ram 2500 4WD

Open Question

Location of the pulse intermittent wiper control on a 1999 dodge ram

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

motor1258
  • 6674 Answers

SOURCE: Location of O2 Sensors on 1996 Dodge Ram 1500 ?

Follow your exhaust manifold down from engine to exhaust pipes etc, you should see them sticking out, 3"-4" approx.length, with wires coming from them. Some are right on manifold, some further down on exhaust pipes.

Posted on Apr 15, 2009

motor1258
  • 6674 Answers

SOURCE: I am looking for the

Look around shift linkage area of transmission for a threaded in plug with 3 or so wires to it. Neutral safety & back-up are in one switch.

Posted on May 18, 2009

Audioaholic
  • 376 Answers

SOURCE: location of iat sensor on 1999 dodge ram 1500

temp charge sensor is located on the air box, or tube leading to the throtlebody.

Posted on Sep 15, 2009

  • 1596 Answers

SOURCE: 1999 dodge caravan intermittent instrument cluster

This Seems Indicative Of a Poor Connection AT The CLUSTER Or A Junction Connecter Close to the Cluster. This is Assuming you Have Ruled OUT ALL ABS COMPONENTS, LOOK at These VERY CLOSLY Because of the Small Volts These Wires Carry , the SMALLEST DEFECT WILL Cause this Type of Symptom that you have given. Please try all of the Above, I feel Confedint that athis is where your Problem Is.

Posted on Jul 16, 2010

  • 2 Answers

SOURCE: 2001 dodge caravan, intermittent part of the wipers do not work

As the intermittent wipers are based on resistance, try the easiest fixes first:1. Disconnect the negative terminal on the battery. Pull the relays for the blower motor and both wiper relays and the 30 amp fuse for the wipers. These are located under the hood in the fuse/relay box. The best way is to be careful and use a set of pliers. The reason you pull the blower relay is so that it is easier to pull the intermittent relay. Clean these off the blades of the relay with a burnishing tool (in a pinch you can use your wife's nail polisher that is like very fine sandpaper. Once the are a pretty silver color, wipe them off with some rubbing alcohol. Put them in and pull them out about 5 times into the relay socket and leave them in. Clean the blades for the fuse with a cue tip and rubbing alcohol and then put the fuse in and pull it out about 5 times then leave it in. Hook up the negative terminal and take the key to the on position and turn the wiper to the lowest position. If it works if should take about 36 seconds between strokes. 2. The next easiest is taking the cover off the top of the steering column and pulling off the wiper switch and replacing it. There are three screws that hold the cover and two that hold the switch plus the electrical connector. You can buy a used one at a "junk yard" for about $20. 3. Replace the wiper motor (takes about a couple of hours start to finish). It involves removing the wipers, the cowl (plastic cover over the wiper motor right below the windshield), loosening and lifting the scissor arms for the wiper arms and removing the motor (this involves disconnecting the power connector and feeding it back to the motor).Hopefully your issue is like 95% of the wiper issues and it is just a little bit of corrosion on the wiper relays and fuse!

Posted on Feb 06, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My intermittent wiper mode seems to only work on occasion, never consistently.


RAM 1500 Intermittent Wiper Screwed Up / broken. - YouTube

? 0:31
www.youtube.com/watch?v=bljgrhugbBI
Oct 29, 2012 - Uploaded by Jude Augusta
RAM 1500 Intermittent Wiper Screwed Up / broken. ... Update: AFTERMARKET PART (NOT the original) works PERFECTLY: (603) 758-1046 is the CITGO in Hampton, NH ... I lived with it in my 04 Ram but now there is no intermittent - its on or off. ...Replaced the wiper motor - it has the "intelligence" in it.

Oct 23, 2015 | 2004 Dodge Ram 2500

1 Answer

I have a 1999 Dodge Ram 3500 diesel slt no intermintant wipers have installed new ctm and programmed by the dealer new multifunction switch and wiper motor still only works on high no delay or lo


The motor could have a bad low winding. Intermittent always uses low.
The problem could also be a bad connector pin going to the motor low winding. If you have a schematic, you can ground the pin to see if low runs.
Hope this helps.

Apr 07, 2015 | Dodge Ram 3500 Cars & Trucks

1 Answer

Pulse intermittent wipe control location


You will find it on driver side of the instrument panel near the steering column. This module doesn't fail that often , I found the multi-function switch the cause of this problem.

Apr 21, 2014 | 1999 Dodge Ram

1 Answer

Wipers wont park 1997 dodge ram replaced wiper motor now wipers stop up high speed also dont work


be checking for proper ground to the wiper motor and fuses or relay controls..

Feb 15, 2013 | 1999 Dodge Ram 2500 4WD

1 Answer

Wiper intermittent operation/automatic stowing does not work.


Hey Anon,
I just finished replacing the intermittent (wiper motor pulse board) control on my vehicle.. it was doing exactly as you describe.. it wasn't hard.. just time consuming..

Jun 16, 2017 | 1992 Dodge Stealth

1 Answer

Where is the pulse board?


The pulse board for the windshield wipers is mounted on top of your wiper motor. It has a black plastic cover on it. It controls your speeds & intermittent wipers.

Jul 01, 2010 | 1994 GMC Sierra

1 Answer

Windshield wiper motor location


remove the cowl..
the part that the wiper arms go through, you have to take it off and the wipe motor is under that

Apr 14, 2010 | 1999 Dodge Ram

1 Answer

I have an intermittent problem with my wipers. They don't work one day and the next they do. Could this be pulse board problem or with the motor?


more than likely the pulse board loose at the wire connector. try wiggling the connector with wipers on (keeping hands away from wipers) then try tapping the motor with a small hammer.

Feb 11, 2010 | 1999 Chevrolet Tahoe

1 Answer

2005 Dodge Ram 1500 4x4 - Intermittent wiper problem


There is a fault with Wiper stalk have got same prob with my 2006 ram 1500 5.7l hemi they should change under warrenty are with mine

Oct 12, 2008 | 2002 Dodge Ram Maxi

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...