Question about 2011 GMC Acadia

Open Question

Ecm fuse keeps blowing

How danger is this because it doesn't look loke it can fix

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 58 Answers

SOURCE: ECM BATT fuse keeps blowing

That fuse provides power for the fuel pump. Either your fuel pump is blowing the fuse or there is a shorted wire.

Posted on Dec 21, 2008

Ad
  • 85 Answers

SOURCE: truck wont start keeps blowing the ecm batt fuse

You have a short (bear wire) somewhere. Trace the wire and find it.
Have a great evening

Posted on May 01, 2009

centralvalle
  • 386 Answers

SOURCE: ecm fuse keeps blowing

just fixed this problem, change your fuel pump module, fuel sending unit shorts out on fuel level swing arm blue wire... unfortinately you must replace it as unit because of the design, fuel pump and tank guage fuel level sending unit are a one peice item, fuel tank has to come out to change unit, about a $ 700.00 repair too... fuel pump module runs about 350 to 700 $ depending on aftermarket or factory, try to find one with a lifetime warranty even if it is $ 50.00 more worth it..labor is about $ 250 to $ 400 depending on shop labor rate... definate problem though I ahve no doubt, common problem on GM... please rate my help, thanks...

Posted on Aug 06, 2009

jturcotte
  • 8557 Answers

SOURCE: keeps blowing ecm fuse need

engine control module. This is the computer that tells your plugs when to spark, and how much gas injectors should spray, etc.

Posted on Sep 21, 2010

jturcotte
  • 8557 Answers

SOURCE: 1997 yukon keeps blowing ECM-1 fuse, 20 amp. Ran

Hi, here is what runs on the fuse: ECM, injectors, coil, MAP sensor, crank sensor, IAT sensor, EGR solenoid. Of these, only the EGR solenoid has a delayed operation. Recommend you disconnect the EGR solenoid to see if the fuse will hold up. The solenoid is next to the thermostat housing as shown below. If the fuse doesn't blow with the solenoid disconnected, replace the EGR solenoid. Please let me know if you have questions and thanks for using FixYa.

jturcotte_830.gif

Posted on Jan 15, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1993 grand prix.blows brake light fuse when u apply brakes


hot wire touching metal fuse blows so you don't burn up the wiring get it tested and fixed soon could be dangerous to keep putting in a new fuse

Jun 24, 2013 | 1993 Pontiac Grand Prix

1 Answer

1997 GMC Sierra, I keep blowing the ECM 1 fuse, I replaced Fuel Pump relay and Fuel Filter. Does the ECM 1 Fuse Pump the Fuel Pump, also disconnected the Fiter turned on the key and no fuel.


ecm1 is injectors not fuel pump ecm-b is fuel pump its more likely to be a faulty relay for the injectors, it would be a similiar design to this
12900_oil_sending_unit_and_fuel_pump_circuit_80-yoo05im5qhid2i2poe1uh03c-5-0.gif this is for the fuel system, relay for the injector is nearly the same.

Nov 03, 2012 | 1995 GMC Sierra C1500

2 Answers

30amp AM 2 fuse blows as soon you turn on the key & car will not start


This is common about this time on these Camrys. I own three. The AM2 fuse is blowing because a coil, capacitor, or supressor has gone bad in the distributor. To test this disconnect the two wire connectors to the distributor. Replace the AM2 fuse. Turn the ignition. If the fuse doesn't blow. The distributor.

Jul 01, 2012 | 1994 Toyota Camry

2 Answers

95 chevy blazer keep blowing the ecm fuse


If it "keeps" blowing the ECM fuse, it is because you "KEEP" replacing the fuse without diagnosing and repairing the reason the fuse is blown.

Please review these articles:

Where's The Fuse?

What Else Could Be Wrong?

What To Expect From An Online Car Expert

Jun 04, 2011 | 1995 Chevrolet Blazer

1 Answer

I have a 1990 Chevrolet C2500 Pickup. It keeps blowing the ECM fuse. Its not the ecm, its not the fuel pump, its not the fruel pump relay. What else could blow the ECM fuse?. There is no visual evidence of...


if it is the ecm b fuse thats blowing i would try disconnecting your oil sending unit and see if it still blows the fuse.i have seen the sending unit short out internally before and blow the fuse.if it is the ecm 1 fuse it is either a chaffed wire or one of your injectors shorted.

Feb 09, 2011 | 1989 Chevrolet C2500

1 Answer

MY 96 SUBURBAN 2500 7.4L SUDDENLY DIED WHILE DRIVING. AFTER I COASTED TO A STOP I TRIED TO RESTARTING BUT NO LUCK. HAVING HAD THE FUEL PUMP REPLACED BEFORE I KNEW TO LISTEN FOR THAT SOUND OF THE PUMP...


The key is to find out what is causing the ECM fuse to always blow. With just the key on try and see if any codes are set in the ECM. If not, try a new ECM. If the fuse still blows, then disconnect all accessible electrical for everything, including radios, accessories, relay boxes,etc. except the ECM. If the fuse still blows, then probably something wrong with the wiring to the ECM. If it doesn't blow then start hooking up things one at a time until it blows again. Once it blows, that is your problem.

Aug 24, 2017 | 1996 Chevrolet Suburban

1 Answer

Blown ecm fuse


unhook the ecm and check if the fuse does not blow,you will know if it is the ecm,Hope this helps

Sep 06, 2009 | 1988 Chevrolet S-10

3 Answers

Ecm fuse keeps blowing


just fixed this problem, change your fuel pump module, fuel sending unit shorts out on fuel level swing arm blue wire... unfortinately you must replace it as unit because of the design, fuel pump and tank guage fuel level sending unit are a one peice item, fuel tank has to come out to change unit, about a $ 700.00 repair too... fuel pump module runs about 350 to 700 $ depending on aftermarket or factory, try to find one with a lifetime warranty even if it is $ 50.00 more worth it..labor is about $ 250 to $ 400 depending on shop labor rate... definate problem though I ahve no doubt, common problem on GM... please rate my help, thanks...

Aug 06, 2009 | 2002 GMC Yukon XL

1 Answer

Keep blowing ECM fuse on 90 honda accord


I'm thinking the ECM is bad and grounding out, causing the car to blow the fuse. The old gas wouldn't cause this problem.

May 27, 2009 | 1990 Honda Accord

1 Answer

ECM BATT fuse keeps blowing


That fuse provides power for the fuel pump. Either your fuel pump is blowing the fuse or there is a shorted wire.

Nov 22, 2008 | 1995 GMC Jimmy

Not finding what you are looking for?
2011 GMC Acadia Logo

Related Topics:

179 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...