Question about 2006 Citroen C5 1.8

Open Question

Check engine oil level - 2006 Citroen C5 1.8

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2002 Chevrolet Malibu oil light on & valves clattering


Check the oil level on the dip stick and make it correct. This engine should have a low oil shut down feature. Possible oil pump failure. With oil at correct level, restart engine. If the oil light does not go out with engine running, shut down immediately. Severe Internal rotating component bearing damage has already occurred. look for loose oil filter or hole in oil pan.

Mar 03, 2017 | 2002 Chevrolet Malibu

2 Answers

My engine oil light comes on but my oil level is fine. I notice that if I rev my engine just a little it goes out??????


may need oil change ==filter collapse --check oil pressure sender,malfunction loose or damaged wiring ---sludge

Sep 14, 2015 | 2003 Dodge Stratus

1 Answer

Oil level on mark when engine is cold, way high when running


Are you pulling the dip stick out with the engine running to check the oil level? You are only suppose the check the level when the engine is off. Oil level is high and in accurate while engine is running due to the oil pump pumping oil around the engine. :p

Apr 07, 2014 | 1992 Honda Accord

1 Answer

Check engine oil


Needs to be checked at the dipstick,
Under the bonnet on the engine!
The warning light, on most vehicles,
Only comes on when the oil is drastically low!!!!

Jul 12, 2017 | Cars & Trucks

1 Answer

When to check the oil hot or cold?


Do it when its cold you are Right .

Mar 22, 2012 | 1998 Jaguar XJ8L

1 Answer

2005 grand Prix oil pressure light an dinging comes on


1. Check your oil level. If oil level is not ok, correct oil level and find out why oil level was low and correct the problem. (Leaks, bad PCV, Burning oil due to severe engine wear, nobody has bothered to check it for the last 3000 miles, WAY overdue for an oil change, etc.) If oil level is ok, proceed to next step.

2. Remove the oil pressure sensor and install a manual oil pressure gauge. Run engine to verify low oil pressure. If gauge shows that the oil pressure is low, overhaul or replace engine. If oil pressure is ok, replace oil pressure sending unit and retest.

Mar 06, 2012 | 2005 Pontiac Grand Prix

1 Answer

Just bought a 2006 Crossfire. The area where the (Trip Milage) is, a beep then the Oil Logo with the word HI comes on once a day at least. The Manual says the Oil has too much and the oil pan needs to be...


Yes its mentioned correct in manual.The HI indication comes on when there is about 1 quart too much oil. Get the excess oil drained.----------- CHECKING ENGINE OIL LEVEL:-------- A sensor in the oil pan allows oil level to be checked
without opening the hood. It provides an accurate measurement of oil level, whereas the low engine oil level indicator warns that oil level is definitely too low. With the vehicle parked on a level surface, the engine is warmed up and shut off for approximately five minutes.When the ignition switch is turned to the ON/RUN position, an ISO oil level icon appears in the trip odometer window and a "clock" icon in the cumulative odometer display. Pressing the knob to the left of the speedometer twice within one second displays one of the following messages:
• OK
• -1.0 Q (-1.0L)
• -1.5 Q (-1.5L)
• -2.0 Q (-2.0L)
• HI
The indicated amount of oil must be added to the engine
if the message -2.0 Q (-2.0L) blinks and a signal sounds.
The HI message indicates that the excess oil must be
removed from the pan to avoid possible engine or
catalytic converter damage. If the ISO oil level icon and
"clock" icon remain on when attempting to check oil
level and no message follows, or if the low engine oil
level warning lamp comes on, a malfunction in the
engine oil level system is indicated. A conveniently
located dipstick allows manual checking of the oil level.
If no leaks are noted, continue to drive to the nearest
service station where the engine oil should be topped to
the "full" mark on the dipstick with an approved oil.--------------------

Apr 09, 2011 | Chrysler Crossfire Cars & Trucks

3 Answers

Low oil light comes on , is it low oil pressure or low oil level


it is a combanation of both low oil level =low oil pressure check your oil level and make sure it is on the full mark and drive it to see how pressure is it could also be the oil pressure sending unit good luck

Dec 26, 2010 | 2002 Chevrolet Malibu

1 Answer

I want to check the engine oil level for previa 2.4 petrol 1995



OIL LEVEL CHECK Every time you stop for fuel, check the engine oil as follows:
  1. Park the vehicle on level ground.
  2. When checking the oil level it is best for the engine to be at operating temperature, although checking the oil immediately after a stopping will lead to a false reading. Wait a few minutes after turning off the engine to allow the oil to drain back into the crankcase.
  3. Open the hood and inspect the level of the engine oil tank. The fluid level on the tank should read between FULL or F and LOW or L.
  4. If the level is below the LOW or L line, remove the cap and add enough engine oil to reach the FULL or F line. Fig. 1: Fill the engine oil tank located under the hood first 90911p07.jpg
  5. Install the oil cap and hand tighten.
  6. After filling the oil tank, remove the engine access hole cover on the drivers side. Fig. 2: Make sure the oil tank is to the F mark 90911p15.jpg Fig. 3: The oil dipstick is located under the driver's side engine access hole cover 90911p83.jpg Fig. 4: Place your finger through the hole and pull straight up to remove 90911p84.jpg
  7. Remove the engine oil dipstick and wipe it clean.
  8. Reinsert the dipstick, push it in as far as it will go, the pull it out and look at the level on the end.
  9. If necessary, insert more oil through the oil filler cap next to the dipstick, this will completely top off the system. Fig. 5: The oil dipstick has two markings for level check 90911p85.jpg Fig. 6: To fill the crankcase, remove the engine oil filler cap 90911p86.jpg prev.gif next.gif

Nov 06, 2010 | Toyota Previa Cars & Trucks

1 Answer

MY SATURN 1 SHOWS NO OIL WHEN IT IS COLD BUT WHEN CAR IS TURNED ON IT SHOWS FULL WHY IS THIS


To check engine oil level engine needs to be off, if check while engine running, oil will splash inside oil pan and all over your dip stick giving you bad reading, Check oil level with engine off and add to full mark on oil dip stick. Running engine with low oil will cause major damage to your engine. To check transmission level engine needs to be running at normal engine temp.

Nov 16, 2009 | 2000 Saturn SL

Not finding what you are looking for?
2006 Citroen C5 1.8 Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Citroen Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14204 Answers

Are you a Citroen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...