Question about 1994 Plymouth Voyager

Open Question

1994 plymouth voyager 3.3l rough idle - 1994 Plymouth Voyager

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

leetamara
  • 702 Answers

SOURCE: 1994 plymouth voyager hood release cable broken

Get a flash light and shine it under the hood and use a screw driver to pull the latch over to one side to pop the hood open.

Posted on Jun 12, 2008

  • 1 Answer

SOURCE: 1998 Plymouth Voyager

I had the same problem. I changed out the idle air control valve and that solved the problem. Somehow the electrical connector fried out some of the pins.

Posted on Dec 22, 2008

  • 1129 Answers

SOURCE: 1994 plymouth voyager heating problems. Just

After the car warms up feel the heater hoses that go into the fire wall from the motor both should be warm if only one is warm and the other is cool the heat valve that opens the flow of antifreeze to the heater core is not functioning locate the valve (either under dash in passenger compartment or in the egine compartment) it has a vacuum line going to it and it should have vacuum when the heat is on if not replace the vacuum line or valve itself. Back flush heater core and also be sure the level of antifreeze is up to the top low antifreeze will cause no heat to occur.

Posted on Jan 05, 2010

  • 1757 Answers

SOURCE: plymouth voyager 1994 check engine

34 = Speed Control Solenoid Circuits: An Open or Shorted Condition has been detected in the Speed Control Vacuum or Vent Solenoid Circuits.
35 = Radiator Fan Relay Circuit: An Open or Shorted Condition has been detected in the Radiator Fan Relay Circuit.
That 5 at the end should have had another 5 after. Did it? 5-blinks and 5-blinks means the system has finished sending the Codes.

Posted on Jan 14, 2010

  • 1757 Answers

SOURCE: 1994 plymouth voyager serpentine belt diagram

My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.

I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.

CLICK
on the following LINK. It has the Belt Diagrams you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies...
http://www.2carpros.com/car_repair_information/year/1994/make/plymouth/model/voyager/1994_plymouth_voyager_drive_belt_routing_diagram.htm

Posted on Mar 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the fuel pressure fro 94 plymouth grand voyager


The correct pressure should be 40-50 PSI. The car will run wit lower but will lug when accelerating and not idle well.

Jan 08, 2013 | 1994 Plymouth Grand Voyager

1 Answer

What is the time belt ? why is it important to monitor it especially in used cars?


if thi plymouth voyager as a 3.3l eng it does not have a timing belt it as a timing chain does not require any maintenace as all like the good ol days ..if it as a 3.0l eng then it as a rubber timing belt that control the valve timing that reqires replacing every 80 to 100, 000 miles make sure you know what engine this van as if its a 3,3l it wi say it on top of intake or 3.5l is the same they both have chain ...3.0l does have a timing BELT

Aug 27, 2010 | 1998 Plymouth Voyager

1 Answer

Where can I find the map sensor in a 1994 plymouth voyager


For 1994 Plymouth Truck Voyager 2WD 3.0L MFI 6cyl the MAP Sensor is located under hood, passenger side, upper engine area, end of intake manifold cover, mounted next to alternator on engine.

Hope helps (remember rated this).

Jul 05, 2010 | 1994 Plymouth Voyager

1 Answer

I need to find belt diagram for my 1994 plymouth voyager.


Several engine size there...

1994 PLYMOUTH VOYAGER - V6 3.3L 201ci CNG FI N J
0ef358f.jpg

For other engines, chec DAYCO Catalogue.

Hope help with this (remember rated this help).

Mar 12, 2010 | 1994 Plymouth Voyager

1 Answer

I need a diagram for a serpentine belt


1994 PLYMOUTH VOYAGER - V6 3.3L 201ci CNG FI N J
and
1994 PLYMOUTH VOYAGER - V6 3.3L 201ci GAS FI N R

Multiple Accessory, w/o A.C.

9c2c906.jpg


Multiple Accessory, w/A.C.

7d40d1b.jpg


Hope this helped.

Feb 13, 2010 | 1994 Plymouth Voyager

1 Answer

96 plymouth voyager idles rough and dies also dies at stop signs and lights computer check shows 27. told might be idle control sensor if yes where is it located


HI BEFORE U SPEND ANY MONEY CHECK ALL OFF THE AIR INTAKE SIDE OFF ENGINE EVEN SERVO PIPE FOR LEAKS MOST COMMON THING ON THIS TYPE OFF FAULT

Oct 18, 2009 | 1995 Plymouth Voyager

1 Answer

Will a distributor from a 1994 plymouth voyager with 3.0 engine fit a 1997 plymouth voyager 3.0?


I don't think so, 1996 was the change in computer systems for all cars and trucks

May 17, 2009 | 1997 Plymouth Voyager

1 Answer

Idle problem for a plymouth grand voyager 94 3.3 v6


try this procedure it will help wit the idle, don't know about the overdrive issue.
Here is the most common cause of surges and stalls at stops and low erratic idle speed and rough idle, it is the idle speed control air-bypass valve and throttle valve (IAC for short), they get full of gunk over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Mar 12, 2009 | 1994 Plymouth Grand Voyager

1 Answer

Egr valve for plymouth voyager


I had rough idling,do not pass NOx emission?

Nov 29, 2008 | 1992 Plymouth Grand Voyager

2 Answers

1998 Plymouth Voyager


I had the same problem. I changed out the idle air control valve and that solved the problem. Somehow the electrical connector fried out some of the pins.

Oct 25, 2008 | 1998 Plymouth Grand Voyager

Not finding what you are looking for?
1994 Plymouth Voyager Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...