Question about 2008 Chrysler Pt Cruiser

Open Question

What does airbag icon look like on pt cruiser

Trouble starting feels like its going to turn off, fk=lashing icon under lrtter d

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

bunnydawg
  • 5158 Answers

SOURCE: Warning lights PT cruiser

that is likely the check engine light. if you live near an autozone they will scan it for codes (free) and that should tell you why the light came on

Posted on Mar 18, 2009

  • 1 Answer

SOURCE: 2001 PT Cruiser quit running driving down highway

I HAD THE SAME PROBLEM, I BROKE A TIMING BELT.   HAD TO REPLACE THE ENGINE.

Posted on Mar 22, 2009

  • 323 Answers

SOURCE: driver's airbag light on 2007 PT Cruiser convertable

The first code is for "driver seat track position sensor low". The module detects that the sensor input is less than or equal to 0.3 mA. The second code is referring to the first code. I have no idea what the third code is. Basically you have two different communication systems mixed. The 2001 uses the PCI bus system and the 2007 uses the CAN bus which is much faster. The first code is a CAN bus code and the second is a PCI code. As far as the airbag deploying in the event of a collision, I don't believe it will with an active code in the system. I hope this helps.

Posted on May 13, 2009

SQUIRESXX
  • 486 Answers

SOURCE: PT Cruiser passenger airbag light and bell go off without reason

HI I may have found y the airbag light goes off and on on pt cruisers. there is a pair of wires that connect to the seat air bag pod, the wires run down the seat and to a connector in th floor. after long in vestigation i found that even thou the wires have a conduit protecting them the wires run under the foam pad and over a steel bar, which caused 1 wire to be cut inside yet there was no tell tale sign from out side the sleeve, it was only when I disconected the battery and then the connector from the airbag and the floor connector removed it and run a meter on the two I found it. when i "pulled" the leads the outer sleeve stretched exposing the fault, the wire had a very clean break in it which was odd but the fault. note that only one wire powers the air bag, the other is a feed to the PCM, hence they are connected at the ends hence not easy to trace and with saftey in mind you must not put meters on the wires while connected to any part of the airbag

Posted on Dec 05, 2009

  • 5 Answers

SOURCE: 2001 PT Cruiser: How too remove crankshaft pulley 2001 PT Cruiser...

GET A 3 SPOKE PULLEY EXTRACTOR AND SCREW IN THE BOLT BUT IN THE CRANKSHAFT HOLE PUT A MUCH SMALLER SCEW SO YOU WOUNT MESS THE INSIDE UP

Posted on May 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2004 pt cruiser ran fine all day last Thursday. Then when I go to take my kids to school the next morning it wouldn't start. It cranks but doesn't start. ?????


Hi Rachel, Im AL the owner of Big As Auto Repair

Rachel, I'd feel better about helping you if we had a trouble code to start with. If you know someone that has a hand held scanner that will check the codes and post the code here or on my website below I will be able to help you with more confidence we are headed in the direction to repair your vehicle.

I will tell you that the Cam Shaft Position Sensor and Crank Shaft Position Sensor is the most common problem I find with a no start on this vehicle. BUT, it could also be fuel relayed so I'd feel much better if I had a code to go by.

When you get a code send it to my website below and I help you further. http://www.bigasautorepair.com/

May 25, 2015 | 2004 Chrysler PT Cruiser

1 Answer

Where is the G202 and G203 fuse for a 2002 PT Cruiser located


G202&G203 are grounds if I knew what you are trying to fix it would be more helpful the power side of G202 uses fuses #5&9 for the airbag system G203 uses fuses #7,10,&20 for several interior components fuse block for #5,7,9,10 left of dash interior and power distribution under hood behind battery for#20

Mar 16, 2015 | 2002 Chrysler PT Cruiser

1 Answer

Pt cruiser sputters when ac is tyrned on


chances are you have a secondary miss under these conditions try replacing your spark plugs and wires.
cheers

May 01, 2014 | 2009 Chrysler PT Cruiser

1 Answer

My airbag light and dinger goes off every few minutes in my PT Cruiser. How can I get it to stop?


you have a airbag sensor somewhere. you cant do it yourself, because it could cause all airbags to go off. take it to a place and tell them you have a bad airbag sensor

Aug 10, 2013 | 2009 Chrysler PT Cruiser

1 Answer

My airbag light goes on and won't turn off on my PT CRUISER 06


your car has several air bags and quite a few different sensors and such. you will need to have the codes pulled and diagnosed by a qualified technician.

Mar 23, 2010 | 2006 Chrysler PT Cruiser

1 Answer

I HAVE A AIR BAG LIGHT ON WITH A CODE THAT SAY PASS. SQUIB #1 SHORT CICUIT.


TAKE IT TO DEALERSHIP.FIXING AIR BAGS ON ANY KIND VECHICLE NOT SAFE IT COULD CAUSE AIRBAG DEPLOYMENT.AIRBAGS IS A DEALERSHIP FIX THEY HAVE EQUIPMENT TO TROUBLE SHOOT THE AND FIX.

Jan 12, 2010 | 2001 Chrysler PT Cruiser

1 Answer

Airbag light dings every 5mins


is your vehicle equipped with a passenger side airbag off switch you turn w/ the key?turn it on

Sep 23, 2009 | 2007 Chrysler PT Cruiser Touring Hatchback

1 Answer

Pt cruiser air bag 2002 removal


If you want to replace a airbag that's been deployed; YOU MUST REPLACE THE ENTIRE AIRBAG SYSTEM!

If you don't understand the system, you're bound to seriously injure yourself.

Take it to your dealer and let them fix it.

Jun 19, 2009 | 2006 Chrysler PT Cruiser

3 Answers

2001 PT Cruiser Limited Ed. Airbag light keeps coming on and off and chimes every time it does. Is there any way to turn it off for now, its driving me bonkers?


There may be some reasons of coming the airbag light on your PT Cruiser. Some connectors could be loose under seats or sensor of steering wheel could fail. However it is really rear. Your problem is probably caused by common problem in PT Cruisers - by broken wire on driver's seat.
Before you start doing anything disconnect a car battery. After 15 minutes remove a plastic panel from the seat (the one you can see when you open your door). Than you will see a wire in plastic cover. It connects an airbag in your seat and yellow connector under the seat. The wire breaks near to the second plastic T-shaped part (looking from the top of the seat backrest). It is located where is a pooling line and rising seat connector wire - somewhere in the center of lenght of the seat. Put the seat backrest to the vertical position, push up the black plastic cube of the line to remove it and have some room to repair the wire, cut a cloth tape. You should have ***** white and red wires. Inspect the wire about 1,5 inch from the center of the place where was the center of the T-shaped plastic keeper. The wire outside will be looking as new, but coper lines inside used to be broken. Strech slightly one by one of the 2 wires. When you find the break just cut the plastic cover in that place, remove 0,25 inch of the cover from each of cut end of wire and twist the ends or put extra 2 inch insert of the same wire. Wrap the coper wires in insulating tape neatly and tape all of the wires together with the T-shaped plastic keeper. Put on place the line udjusting a backrest of the seat, the keeper and plastic cover of the seat. Connect a battery and check it.
If you are not sure where is the place whre the wire could be broken, it is exactly 30 centimetres from the connector of the airbag. TomasS

Jun 14, 2009 | 2001 Chrysler PT Cruiser

1 Answer

How to disable the airbag light on 20006 pt cruiser


Hey,
take a look at www.airbagmodul.com

They're working in Airbag-Simulators and Occupancy Sensor-Simulators.

Regards

Gerrit

Apr 05, 2009 | 2006 Chrysler PT Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...