Question about Hyundai Motor 1998 Accent
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
i have attached the image, showing the position of crankshaft position sensor.hope its helpful for you. Please rate my solution as helpful.have a great day.
Posted on Feb 21, 2010
The CPS for these motors is located in the front of the engine and the the timing belt cover needs to be removed to gain access. If you need further instructions on removal as well as diagrams, email me at email@example.com and I will send those immediately.
Posted on Jul 13, 2010
Remove negative battery cable. Remove heat shield from starter. Remove battery cable from starter lug and single wire connector to starter solenoid. Remove starter. Above starter is CRANKSHAFT POSITION SENSOR. Disconnect sensor connector right below ignition coil assemble from top of engine. Slide sensor connector out of U-shaped bracket. Loosen 10mm bolt securing sensor. Lubricate new sensor O-ring with vaseline and install. Reverse procedure to finish job. I just did the job on my 03 Tibby 2.7liter today. Note: Make sure you press the new sensor in by hand and be sure it is seated all the way before you tighten the 10mm bolt, otherwise the sensor mounting tab make distort and crack and the sensor may not be in all the way. Good luck!
Posted on Oct 18, 2010
My online Sonata manual shows these possibilities, but does not identify which applies specifically to 2000 Sonata.
Also, when you talk to the dealership parts counter, you'll need to know whether your 2000 Sonata is (a) 4-cylinder 2.4L MFI DOHC engine, or (b) 6-cylinder 2.5L MFI DOHC engine.
Its easy to tell - just count your spark plug wires.
-- begine excerpt from 2000 Hyundai Sonata Repair guide --
The crankshaft position sensor is located next to the flywheel.
The crankshaft position sensor is located next to the flywheel/torque converter.
The camshaft position sensor is located on the engine near the timing belt cover and under the upper radiator hose.
The crankshaft position sensor is located on the driver-s side of the vehicle, down by the lower radiator hose.
The crankshaft position sensor is located on the engine near the crankshaft pulley.
The crankshaft position sensor is located at the front of the engine near the timing belt.
--- end excerpt from 2000 Hyundai Sonata repai guide ---
Posted on Jan 02, 2011
Tips for a great answer:
Jul 10, 2017 | Buick Cars & Trucks
Oct 26, 2015 | Buick Cars & Trucks
May 10, 2011 | 1998 Honda Accord
Mar 13, 2011 | 1998 GMC Sonoma
Nov 26, 2010 | 1998 Jeep Grand Cherokee
Jun 08, 2010 | 1998 Cadillac Catera
Aug 31, 2009 | 1998 Plymouth Voyager
Mar 01, 2009 | 2004 Infiniti QX4
183 people viewed this question
Usually answered in minutes!