Question about 1996 Chevrolet Camaro

Open Question

How to disable the alarm system on my 94 camaro z28

How do i disable the alarm system on my 94 camaro z28

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
localwonder
  • 6784 Answers

SOURCE: My 94 z28 camaro chuggs when i punch it

sounds like a fuel pump struggling to pass its contents. try running a treatment solution in your tank. if this fails to work, you will need a new fuel pump to correct this problem. sometimes, trash will build up in your tank and it will cause build up in the jets. you should check vacuum as well if needed.

Posted on Jan 28, 2009

Ad
  • 2 Answers

SOURCE: replace fuel pump in 94 camaro without dropping the rearend?

I wouldnt cut a hole cuz the tank is about an inch away from your body . It is possible cuz my buddy did it to his 91 TBI really slow camaro . He made a door and had to cut his metal fuel lines and use hose clamps and rubber fuel lines to put it back together . It wont work on a 4th gen unless you cut a huge hole . Its a total barefoot redneck way to do it . Ive changed 4 in my 3rd gen (autozone pumps) back in the day and 3 in my 4th gen . Its not a easy task but you will spend as much time trying to cut a hole and fish your high pressure lines out of the way and fishing the whole sending unit out of your fabricated hole not to mention its a unibody and doesnt need holes in it or GM woulda put a door in from the factory . Drop your muffler all your suspension and the two 18mm bolts from your rear control arms and drop the rearend . Everything is out of the way then its 2 15mm bolts to loosen your tank straps and pop off your fuel lines which are plastic on a 4th gen and metal on a 3rd , and your there . Pop your retainer ring change the pickup screen (sock) when you change the pump then reverse the process . It usually takes 4 or 5 hours of hardcore wrenching but it gets easy after you change a few .The exhaust was the hardest to get off for me working off jackstands with a basic tool set . Lol cut it all off and replace it with a flowmaster cat back , its way easier and you will love the sound especially with headers . Its your car but im sure that most everyone who knows how to wrench , especially f bodys like myself will agree with me . Ive had both my cars tore apart and my 96 TA is gettting a 500 horse lt1 built for it as we speak . Its sat for 3 years so ill have to change my pump again no doubt . Oh buy a good bran name pump like an original Ac Delco or a good aftermarket one from summitt

Posted on Apr 01, 2009

wyno62
  • 364 Answers

SOURCE: 94 Camaro Z28 Missfire & Backfires

I had a similar problem, took it to get diagnosed and was instructed to give them $1100 because of a faulty reading on the distributer, rather than paying $650 for a unit I found plenty available new for under $200 I bought an OEM for $189. Now the labour can be found cheaper elsewhere. I then discovered that the module may also be at fault but I would have to replace the dizzy first, Then discovered that the Air Flow meter {afm} may need to be taken off and cleaned with a carby cleaning spray, this is a do it yourself fix costing you about $8 a can of cleaner
Unscrew the units clamps and disconnect the plug, I can't stress enough, DO NOT touch the fine wires inside, spray the carbon buildup off the inside and blow/air dry, {do not rinse with water.} reinstall the unit in the reverse of which it was removed, Alternativly you may have fuel blockage in the lines, try replacing the fuel filter {cheapest fix}
Hope this helps

Posted on May 13, 2009

  • 11 Answers

SOURCE: how do you drain the gas tank on a 94 Z28 camaro

get a 1/4in or smaller diameter rigid ice machine hose thats the only way youll be able to bypass the polimer X inside the gas tank, so get about 10 ft feed it into the gas tank whille making a loop (not a knot) below the gas tank but have the tip of the hose higher than the gas cap to ensure that you dont get a mouth full of gas then lower the tube into a gas can and watch the car go empty and the gas can fill up

Posted on Oct 01, 2009

  • 5 Answers

SOURCE: hi,no more interior heat in 99 z28 camaro.I

Does your blower work? if it does,you could have a block in the line. or your water pump could be going bad, or your thermostat could be bad or misreading. Does your engine temp gauge bounce around.

Posted on Oct 03, 2009

Testimonial: "Thanks my friend! Thermostat is a brand new Hypertech 160. I'll check water pump or misreading/with HPP3"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 Camaro z28 automatic shifter


It has second gear start. To activate and provide extra traction when pulling out of snow and muddy ground. z28 have positive traction rears.

Jul 27, 2017 | 1997 Chevrolet Camaro

1 Answer

I need a diagram of a 94 camaro z28 fuel system


Here is a link that should help you. Thank you for using Fixya and good luck.
http://www.compnine.com/index.php?t=1&year=1994&majorgroup=03&supplgroup=NULL&catcode=18F&modelcode=F&makecode=C&grouptype=B&modelid=1147577278&uid=1

Nov 27, 2010 | Chevrolet Camaro Cars & Trucks

1 Answer

Starting and stalling issues in a 94 Z28


you have a egr system problem, most likely an oxy sensor. also check the intake sensors as they will corrode easily when let set without starting for awhile, this is why any mechanic will tell you to start a car daily and let it idle for a few minutes. (if it is a daily driver in your position)

Jan 21, 2010 | 1994 Chevrolet Camaro

2 Answers

'94 chevy camaro z28 losing power while driving,


check the mas air flow meter could be starting to go and not yet throwing a code.

Jan 17, 2010 | 1994 Chevrolet Camaro

1 Answer

Unable to disable my security system/alarm on my 95 Chev. Camero


yes, do some internet searching, I believe there is a control that you unplug inside the hatch on the left hand side, remove the inside plastic panel, undo the connection, wait 5 minutes then reconnect. This I have done once along time ago on a 94 model. Remember I am only here to help and wish this works for you. Good luck.

Dec 16, 2009 | 1995 Chevrolet Camaro

1 Answer

Security alarm problem


Do you have the key fob? Alot of alarms will go off if you unhook and rehook the battery. All you should have to do is disable the alarm after you unhook the battery. Is this a factory alarm or an aftermarket one?

Mar 07, 2009 | 1993 Chevrolet Camaro

Not finding what you are looking for?
1996 Chevrolet Camaro Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...