Question about 1995 Ford Explorer

1 Answer

Stop lights not working, bulbs are good, stop light on top of hatchback door works but not the L and R Tail lights.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 216 Answers

CK FOR A BAD GROUND WIRES

Posted on Apr 22, 2014

Testimonial: "Thanks! There was a loose wire on rear light housing, that could be the ground needing re-connecting. Thanks again William, sometimes the simple solution gets overlooked!"

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: Low mount stop lights not

Some of these cars have a problem with the wiring harness. Part of the harness runs into the hatch/rear door, and the moving back and forth when opening and closing it causes the harness to get damaged. I have heard rumors of a recall, but I don't know if it is true or not.

Posted on Aug 02, 2008

  • 79 Answers

SOURCE: 2004 F150 Tail light problem

I would check your Auxiliary relay box. Check the R03 relay you might need to replace it. The Auxiliary relay box is located in the engine compartment (driver side)

Posted on Jan 31, 2009

  • 10 Answers

SOURCE: 1998 F150 no tail lights or dash lights

probab;y a faulty ground problem.

Posted on Jul 16, 2009

  • 291 Answers

SOURCE: 98 ford windstar no dash and tail lights

you have to check all fuses with a test light both fuse boxes under hood and under dash... if good next to look for is the light switch itself... has any radio work been done to the lately... if so alot of times hooked up wrong will blow park fuse as one of the wires to radio is the park voltage to tell radio to dim down some

Posted on Sep 06, 2009

  • 1 Answer

SOURCE: all the running lights work minus the rear tail

I have a f-250 super duty,2001, dash& running lights don,t work, found a 15 amp fuse blown in engine compartment. fuse,s keep blowing. please help.

Posted on Apr 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Tail light doesnt turn on with headlights but works fine as a break light and turn signal, why?


in the rear lights you may have two bulbs one is the turn signal the other one is stop light / tail light the stop light / tail light has two filaments, one for the stop light (21 watt) & one for the tail light (5 watt) it is possible that the tail light filament is blown, try replacing the bulb to see if that fixes the problem,also check all the fuses as well.......hope this helps......cheers.

Aug 15, 2011 | 1994 Cadillac DeVille

1 Answer

How do you change the rear light bulbs 1988 2 door hatchback tercel


Open up the trunk, and look for any screws that would link to the tail light light, remove them, then the tail light assembly should pop off. from their remove the bulbs and install new ones, you need to know the size, check modifiedlife.com for the correct light bulb sizes.

Jun 08, 2011 | 1988 Toyota Tercel 2 Door

1 Answer

I have a 1998 honda accord. the tail lights work but when i hit the brakes the lights dont get brighter


the tail lights and stop lights are two separate bulbs or elements. You either have a blown stop light fuse or you need to replace the stop light bulb.

hope this helps.

Jan 15, 2011 | Honda Accord Cars & Trucks

2 Answers

Tail lights went out, but break lights still work....what is going on???


Bulbs have 2 filaments in them so that one bulb can do the same as two. One filament runs for brake and turn signals the other for the tail lights. You need a set of 1157 bulbs with the flat plastic ends. If new bulbs don't work you may have a wiring or switch problem, but they die at the same time a lot more than people think

Jan 14, 2011 | 1995 Pontiac Bonneville

1 Answer

Brake light dont work. 2006 chevy truck, 4.8L 2wd


Some of these had two fuses for brake lights. One for the top/center stop lamp and another for the rear left and right brake lights. Usually one said "stop" and the other said "brake" and one was in the underhood panel while the other was in the dash fuse panel. It's not uncommon to blow a brake light fuse [LR and RR] if you tow a trailer but some of these had seperate fuses for the trailer lights also. If you have a test light check both sides of the two fuses for power [ignition key on] while stepping on the brakes. It should at lest narrow your search a bit.

Jun 08, 2010 | 2006 Chevrolet Silverado 1500 2WD

3 Answers

Dash lights and tail lights not working on my 1999 chevy malibu


Hi its rob here what make and model of car is it? it sounds like the light switch is faulty but that wouldnt stop the brake lights workin try two stop and tail light bulbs then if you have stop lights your switch is at fault

May 11, 2009 | 1999 Chevrolet Malibu

2 Answers

Right brake light out; tail light works fine


most rear tail lights and turn/stop lights are the same dual filiment bulb. it is possible for your tail light to work and your brake light not to and still have a bad bulb. I would check the bulb first, your brake light works on the left yes? this would mean that the fuse is fine

Mar 31, 2009 | 2006 Dodge Stratus

1 Answer

Mazda 3 tail light on, brake light not on


The bulb actually has two seperate elements in it.
That is why the tail light works fine.

If you take the bulb out you will see the seperate elements.
Change the bulb and it should be fine.

Jan 09, 2009 | 2004 Mazda 3

1 Answer

Need fuse schematic


if the fuse was blown the stop lights on both sides would be inop, also if the stop light circuit were dead u would be unable to get the trans out of park, use a 12 volt test light and test the brake light switch at the top of the brake pedal, u can buy a test light from Autozone, kragen and others for about $5 US. If the system has power cjheck the bulb socket it may be defective, use the 12 volt test light while someone pushes the brake pedal. let me know what u find and i will give u further assistance as ness.

Dec 31, 2008 | 1999 Dodge Durango

Not finding what you are looking for?
1995 Ford Explorer Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...