Question about Cars & Trucks

Open Question

Fuse location for a 1999 harly roadkig - Cars & Trucks

Posted by on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Why does my 1999 cougar have power when all fuses are out of both fuse boxes

You have a lot of work ahead of you. Mostly taking the wiring harness apart and finding and fixing wires, What you described shouldn't happen. Yes you definetely have a short, several of them. Good luck.

Jan 12, 2015 | 1999 Mercury Cougar

1 Answer

1999 Ford f250v10 purpose of the relay fuses located under the steering column

no photos , no joy,
there are lots of options on cars,
login to and look
better ? buy a real FSM for your car, ,its all there, to the smallest details. even module locators. and full harness routings.

Jun 11, 2014 | Cars & Trucks

1 Answer

No spark to plugs 1999 ford f150 4.6l

Click on the link.
Voltage for fuse 18 comes from, pcm power relay.
Terminal 30, load side of relay is fuse protected and hot all the time. If you unplug that relay and use jumper wire between terminal 30 and 87, fuse 18 should go hot. That should mean, the control side of relay has a problem, The control side needs voltage and ground.

Jul 24, 2017 | 1999 Ford F150 Regular Cab

1 Answer

How to replace instrument panel harness connector on 1999 pontiac firebird v6

You must replace the whole dash harness, the connector is not avail separately. You will need locate the harness in a wreaking yard, a new part will not be available.

Oct 08, 2012 | 1999 Pontiac Firebird

1 Answer

The location of the brake light sensor on a lexus rx300 1999 yr the brake lights will not come on when brake is pressed i changed the bulbs the brake switch and fuses so the brake light sensor is the...

it's in the driver side of the luggage compartment, behind the panel that has the power outlet. You would need to remove the trim panel and follow the harness to get to it. Most of the time it's Gray color.

Sep 28, 2010 | 1999 Lexus RX 300

1 Answer

Where is the fuel safety shut off switch for a 1999 mercedesml320

Fuel System Pressure RELIEVING
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Locate the electric fuel pump fuse and remove it from the fuse box. NOTE: If the fuel pump fuse cannot be located, disconnect the vehicle wiring harness from the pump itself and perform the procedure.
  3. Start the engine and allow it to idle until the engine stalls from lack of fuel.
  4. Crank the engine over for an additional 15–20 seconds.
  5. Reinstall the pump fuse when repairs are completed.

Jul 21, 2010 | Mercedes-Benz ML320 Cars & Trucks

1 Answer

Trailer Wiring Harness

The trailer fuses should be located out in the engine compartment inside of the fuse/relay junction box.

That is unless the trailer connector on the vehicle and the wiring were installed by someone who used an after-market trailer connector, and if that is the case then you might find the fuses up under the dash or around the fuse/relay junction box, and the fuses will most likely be inside of in-line fuse holders that are part of the after-market wiring. Here are some diagrams that might help you out.












Jun 04, 2010 | 1999 Dodge Durango

1 Answer

Ecm 1 fuse blow when attemping to start vehicle 1999 chevorlet tahoe replaced fuel pump

So as I understand it the fuse only blew after a fuel pump job.

There is a TSB on repeated fuel pump failures with these trucks. The fix is to also replace the harness connector that plugs into the tank harness.

Unplg the harness and inspect it before you turn the key again if you suspect this.

Jan 24, 2010 | 1999 Chevrolet Tahoe

1 Answer

Location of the Horn Relay on a 2005 Ford Taurus Horn doesn't work fuse is Ok and wiring looks good, as well as the horns.

horn may be bad too.

Visual Inspection Chart Mechanical Electrical
  • Horn
  • Horn switch
  • Horn relay
  • Battery junction box (BJB) fuse 101 (60A)
  • Central junction box (CJB) fuses:
    • 216 (15A
    • 230 (15A)
  • Wiring harness
  • Loose or corroded connections
  • Speed control servo or jumper
  • Clockspring
  • Generic electronic module (GEM)

horn relay is in central junction box (fuse panel) under left side of dash.

Nov 03, 2009 | 1999 Ford Taurus

3 Answers

1999 Hyundai elantra died while driving found ecu fuse blown replaced lasted half a mile and blew again

Check your o2 sensor harness. The harness if not properly secured will rub on the axle to a point where it rubs through the insulation of the wire & shorts on the axle causing the ECU fuse (20A) to blow. Repair the harness & replace the fuse & bada bing! You should be in business! Hope that works. IF NOT follow this K.I.S.S.

Keep It Super Simple! It never fails!

Jun 04, 2009 | Hyundai Motor 1999 Elantra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides