Question about 1999 Chevrolet S-10

1 Answer

Have a 98 chevy s10 that will start but will not run

It will start but will not run. code says fuel volume regulator control circuit / open. open in the fuel volume regulator control circuit. where is at?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Filmmaker:

    Uploaded 5 video answers.

  • Chevrolet Expert
  • 162 Answers

Check the solenoid next to fuel pressure regulator on fuel rail,and the wiring to it ,or the bad relay at fuse box in engine compartment

Posted on Jun 19, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
jimbopickens
  • 56 Answers

SOURCE: 98 chevy s10 blazer turn signal

Unplug the turn signal relay from the fuse box and start you engine. Does it still make that noise?
If yes... Put the relay back in, that is not the problem.
If No...Then the relay could be bad, replace it!

PLEASE RATE THIS SOLUTION! Thank You Very Much!

Posted on Nov 25, 2008

  • 507 Answers

SOURCE: Fuel Pressure Regulator

not sure on an s10 but it should be close to the same position as a full size truck. Should be in the engine compartment, drivers side on top of the motor on the fuel rail. Held in by a snap ring or a c ring. When you buy your part, ask the salesman and they should be able to tell you for sure.

Posted on Mar 08, 2009

VREGG
  • 41 Answers

SOURCE: 98 chevy camaro wont start how do you reset fuel pump regulator ran out of gas

BLEED INJECTOR SYSTEM NOT GETTING FUEL TO ENGINE TOP.

Posted on May 08, 2009

dmfixit
  • 226 Answers

SOURCE: Have code P0001, P0171, & P0300. Need to know

P0300 Random/Multiple Cylinder Misfire Detected
P0171 System too Lean (Bank 1) - Read Our Article On Oxygen Sensor Codes For Help With This Generic Check Engine Light Code
i could only find the 2 codes for you
try here
www.engine-light-help.com
what kind of shape are your plug wires in ?

Posted on Feb 04, 2010

  • 262 Answers

SOURCE: where is the fuel regulator 98 chevy V6 pick up

The fuel pressure regulator is located under the upper intake plenumn. (The black plastic cover that sits on top of the intake manifold)
After removing this upper intake, the regulator will be on the back side of the fuel injector inlet housing.
Good luck

Posted on Apr 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mercedes 2004 ML350 Fuel Volume Rugulator Control Circuit /open code on PO 001.....car cuts out whilst driving and refuses to start until it cools down a bit...


code p 0001 refers to fuel volume regulator control---circuit open===causes ---wiring---regulator control solenoid
the indications are that the solenoid is opening circuit ( breaking the circuit ) and stops working when it gets hot internally
replacing that unit most likely will be the fix for your problem

Oct 28, 2016 | Cars & Trucks

1 Answer

We have fault codes#1 and #51 and we need to know what they mean can anyone help


Ian, P0001 fuel volume regulator control circuit/open, may be an electrical problem related to the fuel volume regulator. clear the code and see if it comes back
P0051 Oxygen sensor heater control circuit low, bank 2, sensor 1.
Normally a bad wire/plug on sensor or sensor faulty.
Check the attached links,instruction and guides to explain codes in more detail. Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
http://www.obd-codes.com/p0051
http://www.obd-codes.com/p0001
P0001 OBD II Trouble Code Fuel Volume Regulator Control Circuit Open

Apr 26, 2016 | Cars & Trucks

1 Answer

P004 code. Whats wrong and how do i fix it.


code p 0004 ( assuming that is the code you intended as there is no code p 004) refers to fuel volume regulator control--circuit high===causes ---wiring open circuit / short to positive ---regulator control solenoid

Feb 25, 2016 | 2008 Chrysler Pt Cruiser

1 Answer

What would cause you to lose fuel pressure while driving.


Chevrolet S-10 Questions - Fuel System Loses Pressure ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusJul 28, 2012 - Fuel System Loses Pressure - I have a 2003 Chevy S-10 Pick Up with the 4 ... car a few times, what essentially you are doing is priming the fuel pressure. ... A dirty fuel filter will not cause the lines to lose pressure after the engine is shut off. ... I have a 98 s10 2.2 liter and it was driving fine all day then when ...

Chevrolet S-10 Questions - My 2001 S10 has a hard starting ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusSep 16, 2012 - My 2001 S10 has a hard starting problem if the truck sits between 1 ... Vacuum leak, have you checked fuel pressure while it sits? ... Would the spider alsocause a misfire at low rpms? .... at an idle, or squeaking while driving and it gets faster as you go? ..... 1994 Chevrolet S-10 2 Dr STD Standard Cab LB.

Chevy S-10 Won't Start - Repalced Fuel Pump and Pressure ...

www.cartruckinfo.com/chevy-s10-wont-start.html
Chevrolet S-10 pickup won't run and has no fire unless I jumper the fuel pump relay. ... Once the truck starts and is running you can remove the jumper to the fuel pump ... Iwould get the fuel pressure checked to start with, because that's where the ... 93 gmc 4.3l FI runs but dies out loss of power after 5 mins of running then ...

Stalling S10: I Have a 1994 Chevy S10 2.2l It Stalls After 35 ...


Dec 10, 2015 | 1994 Chevrolet S-10

1 Answer

My 2002 kia sportage is reading code p0001 can anyone tell me the what this means


P0001 Fuel Volume Regulator Control Circuit/Open
However, this may not actually be correct on your vehicle, as seemingly error code P0001 is not used by many manufacturer's.. it's a 'generic' code.

Here's a couple of links that may be of help:

kia P0001 OBD DLC Error Code Fuel Volume Regulator Control Circuit Open

http://www.obd-codes.com/p0001

Nov 04, 2015 | 2002 Kia Sportage

1 Answer

What do i do to fix a P0004 code ona 2006 dodge magnum


code p 0004 refers to fuel volume regulator control--circuit high===causes --wiring open circuit / short to positive --regulator control solenoid
replace the regulator control solenoid

Oct 24, 2015 | Dodge Cars & Trucks

3 Answers

What does a diagnostic reading P0001 mean?


The P0001 DTC code is one of those codes that is very uncommon and is likely intermittent. Please go to obd-codes.com/pooo1, for more info on this code. its fuel volume regulator control circuit/open. God-Bless!

Jan 10, 2015 | 2002 Buick Century

1 Answer

What does P001 fuel volume regulator control circuit open means


basically it means that the regulator solenoid is unserviceable ( broken wire or burnt internally) and needs to be replaced.

Mar 08, 2014 | 1999 Dodge Ram

1 Answer

2000 chevy s10 wont keep running many scan codes


Your truck has an antitheft system called passlock. It runs thru you bcm. When this system fails, your truck will start for 1-5 seconds and then stall. The fuel enable is switched off, and injectors fail to squirt. This may be your problem and is a "bypassable" problem. This link explains.

http://vatspasslockpasskeysecurityhelp.yolasite.com/

May 17, 2012 | Cars & Trucks

1 Answer

I need 2 know what trouble codes 1, 2,and 5 are?


Hi,

Improve the Fixya.com experience for everyone by voting!


Out of the box, I'd say that you have a problem with the fuel management system. However, there's a good chance that it's something simple and inexpensive like a clogged fuel filter or water in the fuel tank.


• P0001 Fuel Volume Regulator Control Circuit/Open
• P0002 Fuel Volume Regulator Control Circuit Range/Performance
• P0005 Fuel Shutoff Valve "A" Control Circuit/Open


All the best

Ben

Jun 18, 2011 | 1996 Plymouth Neon

Not finding what you are looking for?
1999 Chevrolet S-10 Logo

188 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...