Question about 2001 Chrysler Sebring

1 Answer

ENGINE TIMING TIMING SETTING IN DIAGRAM

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 24 Answers

Autozone.com has a lot of repair info and diagrams. I'd be surprised if your timing isn't controlled by the crank position sensor signal to the computer on a 2001? If timing chain or belt is off one tooth, that would throw it off.

Posted on Apr 21, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Timing setting on diesel engine


THEIR ARE NONE.. ITS A DIESEL.. IF YOU HAVE REBUILT THE ENGINE? THEN YOU HAVE MARKS THAT HAVE TO LINE UP OTHER THAN THAT.. THE COMPUTER DOES ALL THAT.. IF YOU BREAK A SPERTINE BELT? DON'T WORRY ABOUT IT. THE COMPUTER WILL ADJUST IT.. I OWN A 99 F-350 S.D. 4X4 AND HAVE REPLACED SEVERAL BELTS AND JUST ATTACHED AND STARTED AND WENT DOWN THE ROAD.. THEIR IS NO DISBRT. ON A DIESEL.. ITS A DIESEL THE MOST SIMPLE ENGINE THEIR IS..

Dec 11, 2014 | 2011 Dodge Journey

1 Answer

I need a diagram of engine timing marks for audi A8 V6 engine 3.0L


you dont need a diagram to see the timing marks on the top/bottom pulleys,just clean them off and run a piece of chalk around the perimeter.they are a bit obvious

Sep 13, 2012 | 2005 Audi A8

1 Answer

Need to see timing diagram


timing is set by setting the bottom crankshaft's pulleys mark (it's a very small dimple on the engine side of the pulley and is VERY hard to see) - you should line it up at 12 o'clock position (there's a mark on the engine to align it). The top crankshaft's pulley will need to be set so that the 1st cylinder piston is at TDC by aligning its mark (small arrow) (you might need to rotate the crankshaft a full cycle around to its mark to obtain this). Once these are set, place the timing belt in place.

Aug 16, 2010 | 1998 Ford Escort

1 Answer

What is timing gear setting diagram, for a 1988 2.3L ford Ranger


i have yet to figure out how to transfer pictures on my computer, you can go to either the Dayco or gates belt web sight for these pictures.

Feb 28, 2010 | 1988 Ford Ranger

1 Answer

Timing Belt Broken, need Diagram for setting Engine Timing timing belt lower puling


I purchased the timing belt and pulley kit for a 1999 zr2 complete instructions came with the pulley set (Dayco brand) also bought the Haynes manual for the escort and not very good directions in it. The one that came from Dayco were very good.

Jul 10, 2009 | 1999 Ford Escort

1 Answer

Timing chain mark diagram for a 94 grand am????


Haynes lists the entire procedure for setting the position of the cams etc. Positioning of these is critical...If off by even a slight amount the valves WILL strike the pistons and destroy the engine. DO NOT use any parts made by SA Gear...They have no quality control and will deny any claim made against them. Make sure that the chain guides are in good condition and that the chain tensioner is operating properly.

Apr 15, 2009 | 1994 Pontiac Grand Am

4 Answers

Timing Belt Replacement+Diagram


How to replace engine belt 1999 ford escort

Oct 29, 2008 | 1999 Ford Escort

2 Answers

Need a picture diagram of 1999 daewoo Leganza timing belt setting or mars?


need a picture diagram for timing marks nubira 2001 2.0L

Jul 20, 2008 | 2002 Daewoo Nubira

3 Answers

Timing Belt Replacement+Diagram


No it will NOT bend valves on this particular engine, if it goes out of time. I would replace BOTH the timing belt and the drive belt at the same time, since both are very inexpensive, even from the Ford dealer. Line up both timing marks on both the cam and crank sprockets in the 12 o'clock position. The marks are very easy to see, once you remove the timing belt cover. Hope this helps.

Jun 22, 2008 | 1991 Ford Escort

Not finding what you are looking for?
2001 Chrysler Sebring Logo

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...