Question about Cars & Trucks

1 Answer

Hard starting 1994 Izuzu Rodeo only clicks have changed starter can get to start after numerous tries any suggestions?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 216 Answers

Damaged / loose wire, " try to wiggle all primary electrical connections, bad connection, bad battery, ck ground cable, bad starter solenoid

Posted on Apr 21, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: 2000 izuzu rodeo

Wires on the wiring harness need to be replaced. The dealer will want you to get the work done for $1200.

Posted on Aug 27, 2008

  • 15 Answers

SOURCE: 1997 Isuzu Rodeo 4 wheel drive

j'aimerai entrer en contacte avec pour l'achat de votre vehicule

Posted on Nov 18, 2008

ourhowse
  • 2007 Answers

SOURCE: 2000 isuzu Rodeo wont start

Could be your neutral safety switch, or it's not all the way in park. Broken or loose wires in the starting circuit. Inspect all wires and connectors at the battery, starter solenoid, and ignition switch. Or your starter pinion is jammed in the ring gear. Remove starter and inspect. Last but not least, your engine is seized. You don't want that one. Good luck.

Posted on May 22, 2009

  • 137 Answers

SOURCE: rodeo won't start after driving until it cools down

it's probably a fuel injection problem. the seals wear or get some little bit of junk in seal surface and are unable to completely close. it's not a problem as long as the engine is running, the seals let in a little more fuel and the computer adjusts for it. after you shut it off the leaky seals let the fuel into the cylinders and then if you try to start it up it is for all intents and purposes a flooded engine. if you don't try to start it again for a good while the fuel that leaked into the cylinders evaporates or runs down into your oil pan. anyway, it's not there and so your engine is not flooded and it starts like it's supposed to. obviously i haven't looked at your vehicle and that's just a guess but it's based on vehicles i have seen. hope that helps

Posted on Jun 03, 2009

snownbird33
  • 120 Answers

SOURCE: 2002 isuzu rodeo won't start

Good day;
the clutch switch is located on the clutch pedal support, if you put your hand on the clutch pedal run your hand up and the switch will be at the top. now if you are going to replace this switch I would try to adjust the switch first the amount of time it takes and this would confirm that it's the switch. ensure clutch pedal is fully returned, disconnect the electrical connector from the switch. loosen lock nut and tighten clutch switch by hand until switch is firmly against clutch lever. back the switch out 1/2 turn, the switch plunger should extend .02-.06" (.5-1.5 mm).
hope this helps

Cheers

Posted on Jul 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Replaceing ignition switch 2004 izuzu rodeo


The lock cylinder or the actual starter switch?

Jun 26, 2016 | Cars & Trucks

1 Answer

Izuzu trooper v6 gas enginewont start when hot?


Starter is probably going bad you can have it checked

May 21, 2014 | 2001 Isuzu Rodeo

1 Answer

Check engine light comes and off 1994 Izuzu Rodeo


Intermitent fault it needs diagnostic tool pluged in while driving,

May 04, 2010 | 1994 Isuzu Rodeo

1 Answer

1996 izuzu rodeo wont stay running


Its not getting fuel then. Do you hear the fuel pump? It makes a humming sound

Mar 02, 2010 | Cars & Trucks

3 Answers

Have a izuzu rodeo 2000 i cant start de ingine i


If you only hear a click sound when attempting to start your vehicle it means that the starter solenoid is defective or the battery connections are loose. Some times the battery connections can be loose enough that the starter will not operate but the lights will.

Nov 02, 2009 | 2000 Isuzu Rodeo

1 Answer

1995 Izuzu Rodeo passanger window wont go down


Sounds like failed window switch.Local repair shop should be able to help.

Mar 31, 2009 | 1994 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...