SOURCE: I am seeking location of
Disconnect Car Battery
I replaced the ignition switch in my wifes 2000 intrigue. (ignition mounted in front dash). I had to take off the knee bump trim and the trim around the instrument housing and remove the instrument cluster. Leave it connected and just lay it on the dash. You also need to remove the radio to get to one of the screws that hold the ignition switch module. Once you get that loose you can pull it out so you can disconnect the wires going to it.
If you need to replace the ignition module insert the key and turn to accessories, there is a small metal button to push in, then your key and the lock part will fall out to install into your knew ignition module. At that time you can also remove the cruise control cable.
I am not a mechanic and the whole process only took me an hour or so.
I replaced my ignition module to fix the heater and AC operation. It also fixed the cruise control that hadn't worked for a year.
SOURCE: I need a spark wire diagram for a 1998 3.8 olds
Viewing the front of the engine, going from the front to the back, the left side cylinders are 2, 4, and 6.
The right side cylinders are 1, 3, and 5.
The firing order is 1-6-5-4-3-2
SOURCE: diagram for removing a tensioner from 99 Olds Intrigue 3.8
Either in the center of the tension pulley or on the arm that the tension pulley is bolted to there is a square hole that is the size of the square on a 1/2" ratchet. Take a 1/2" ratchet and stick it in that hole and I think most of them you put it in the tighten position and pull on the ratchet. the tension will release and you can remove the belt.
Good Luck
SOURCE: is it a timing belt on olds intrigue 2000, 3,5L?
this engine uses a timing chain, chains require no replacement unless the engine is being repaired or the chain or spockets fail
Testimonial: "Thanks."
32 views
Usually answered in minutes!
×