Question about BMW 325

1 Answer

Not getting fire not getting fuel - 325 BMW Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 143 Answers

Buy a Toyota.
Sounds like a power relay problem.

Posted on Jun 19, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I put a new fuel pump in rear tank and fuel filter but not starting.im getting fire at fuel pump but no fire from relay .i put new relay still nothing


Fuel pump will usually only run when on Crank. When engine fires up then it stays running. This is so it won't pump in a crash.

Jan 31, 2015 | Cars & Trucks

2 Answers

Why would a cylender not fire if the plug has spark and all other cylenders are firing?


What test told you it is not firing?

You may have valve damage &
little compression

Jan 09, 2013 | Cars & Trucks

2 Answers

My car will start, run for 2 or 3 seconds and then shut off. It does not chug or anything. Just looses power and turns off.


in this car there is a chiped key that sends a signal to the pcm, and if its not there you only get a few seconds of run time, there are bypass modules to fix this problem permenantly, much cheaper than getting a bunch of new electronics installed

Mar 28, 2011 | 2000 Buick Regal

1 Answer

The jeep has power and starter been replace but the jeep still wont start?


You need three things for an internal combustion engine to work, air, fuel and fire.
Is it getting all the above? Is there fire getting to the plugs? Is there fuel getting to the cylinders? Is it getting air?
If the answer is yes to all the above, then it should turn over and fire.
Possible causes for it not starting... Not getting air - Check air filter, or just take it out. Not getting fuel - Check your fuel pump, check your fuel filter, check your gas tank. Not getting spark- Check wires, check plugs, replace as necessary.
If all the above is GO, then I'd have someone check the timing.

Aug 02, 2010 | 1994 Jeep Cherokee Country

1 Answer

Trouble shoot 1994 GMC will not start


The only two things that can cause an engine not to run is fuel and/or fire. Check the plugs. Pull a wire and ground it to see if it is getting fire. If it is getting fire then its a fuel problem. Anything from a fuel pump, to an ignition fuse. Coils, sensors etc. Fuel or fire.

Apr 06, 2010 | 1994 GMC Suburban

1 Answer

It hasnt been started in a year. it gets fire i replaced the coil thinking it wasnt getting enough fire. i can smell gas so i guess it gets fuel. it turnes over and over but never hits a lick. took out...


well if its getting both it could be a number of things....there is a lil check valve on the fuel rail looks like were u put air in the tire...turn the truck over and stick a little screw driver in it fuel should shoot out....if it is getting fuel to it then replace your cranksensor...let me know how it goes...hope it helps

Mar 28, 2010 | 1996 Mazda Pickup

1 Answer

Wont start getting fire and fuel it just runs over til the batter dies


ok since you didn't give alot of information like the year and the engine
i'm going to assume that it is fuel injected
i know you said it is getting fuel did you check the fuel pressure
i know you said it has fire did you use a spark tester it may have spark but not enough to fire a spark tester
and if all that is ok fuel pressure and it will fire a spark tester then check the compression
next time the more information you can give the better chance we have of helping you

Nov 11, 2009 | GMC Yukon Cars & Trucks

3 Answers

Good spark -- fuel supply line has fuel -- will not start -- either sprayed into air intake -- car immediately fires -- why are cylinders not getting fuel?


possibly a bad pressure regulator or injector module not letting the injectors fire. check out both more than likely the injectors are not firing.

Aug 30, 2009 | 1989 Buick Riviera

2 Answers

97 z71 vortec 5.7 replaced fuel pump.getting fuel but won't start


The # 5 cylinder is miss firing. not getting fuel. Could the injector just be stopped or the crankshaft sensor in gone.

Jun 26, 2009 | Chevrolet Silverado 1500 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...