Question about 2010 Toyota Land Cruiser

Open Question

Land cruiser 4lo

Engine sign, 4 lo lights on

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Benimur
  • 6966 Answers

SOURCE: Toyota Land Cruiser check timimg Belt

Hi,

I am assuming that you have a series 80 diesel engine and that it has run for about 100,000 kms hence the warning light and the changing of the timing belt. Based on the instructions of its repair manual you need to "remove the grommet off from the speedometer and turn off the lamp by pushing the warning light reset switch, then replace the grommet." Alternately, you can try to reset the entire computer of the vehicle by removing the battery cables for a couple of minutes. Pls note that some car radios/head units would revert to security default (ask for a code) when power is completely removed.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

Posted on Jun 24, 2008

Ad
  • 132 Answers

SOURCE: quantity of engine oil used in 1 HD engine toyota land cruiser

if you have just bought the car change the oil and the filters asap on the grounds that the oil and filters may have not been changed for quite a while also change air and fuel filters also and grease any steering and tail shaft joints check brake fluid and water levels also and for any leaks around brakes gearbox and differential then every 5000km change oil and every 10000 change filters and spark plugs start with 4liters of oil let settle check level and keep topping up until close to full mark fill oil slightly under than over too much oil will build up pressure and burst oil seals in motor the more expensive the oil the better the quality its a bit like scotch whiskey best of luck glenn.......

Posted on Nov 12, 2008

  • 109 Answers

SOURCE: toyota land cruiser unknown warning light

Try calling these guys and see if they can help.
(818) 882-1238

Posted on Mar 29, 2009

  • 599 Answers

SOURCE: - I have this code on my 2008 land cruiser (4LO),

this sounds like the the indicator for the four wheel drive system make sur it is set for 2wd not 4 LO

Posted on May 03, 2009

  • 507 Answers

SOURCE: 2004 toyota land cruiser airbag light is on

You may have upset the sensor on the chassis rail which has set off the light,it can take a while to set off ,the damage is minimal and the sensor is slow to crack internally or fail,you can try to disconnect the battery for 1 hour or so but no guarantees on that but even so it can work ,if the light comes back on you may need to see a dealer ,check at the front of the rails under hood for damage of any kind

Posted on Nov 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a B2281 code where should I start


Right turn switch short to ground. B2281 OBD Code Description

Feb 06, 2015 | 2011 Toyota Land Cruiser

1 Answer

Land cruiser 4lo


could be either. possibly just switch on gearbox stuck. do you think it is actually in 4wd or is it just the light? when you turn on a hard road do you hear the tyres scuffing? if it is in 4wd it is possibly the electric actuator jammed, especially if you drove through water/mud a while back

Jan 02, 2014 | Cars & Trucks

1 Answer

4wd low warning light on and now the car isn't working properly! Had a real problem getting home last night! Help!!


I would think the car is in 4Lo . You need to get it out of 4 Lo before trying to drive it on the road because you will blow it up trying to achieve high way speedsin 4 Lo. use the knob on the dash to get it out of 4=Lo

Nov 28, 2013 | 2003 Kia Sorento

2 Answers

My 2005 Yukon will not switch out of 4wd low.


I'm assuming you have operated your 4WD before, and you know the tranny has to be shifted into neutral to engage and disengage 4LO (I'd try that first). Other than that they are bad for the 4wd Switches failing, (but usually one or more lights are flashing) and if its locked in 4LO you probably have a TCCM (Transfer case control module) problem. For the record there is no need to ever use 4LO, unless you are extremely stuck in the bush somewhere, there is no advantage on the street.

Feb 23, 2011 | 2005 GMC Yukon

1 Answer

I was driving my 99 Grand Cherokee limited in 4Lo then it just popped out of 4Lo into neutral and will not re engage! When i put it into 4Lo it just revs and grinds when i step on the gas and truck wont...


Try putting the truck into reverse before going into neutral, then put it into 4-lo. Sounds like the transfer case linkage might need to be adjusted, nothing major. I've owned NUMEROUS Jeeps, and every one with an auto tranny was a PITA to get into 4-lo. And if it isn't engaged completely, it will pop out every time.

Nov 20, 2010 | 1999 Jeep Grand Cherokee

1 Answer

97 ford explorer battery alternator and battery just replaced. Engine light is on and 4w drive lo and high lights keep blinking, what's wrong?


might have a bad o2 sensor wich is tripping your check engine light and a vacuum leak wich is causing your 4lo 4 high light to blink

Nov 02, 2009 | 1997 Ford Explorer AWD

3 Answers

- I have this code on my 2008 land cruiser (4LO), can help and explain what this means.


this sounds like the the indicator for the four wheel drive system make sur it is set for 2wd not 4 LO

May 02, 2009 | 2001 Toyota Land Cruiser

1 Answer

98 K1500 suburban, can not engage 4wd, HI or Lo runs otherwise


your doing it right but your accuater is bad 59.00 auto zone easy install

Feb 23, 2009 | 1998 Chevrolet Suburban

3 Answers

Quantity of engine oil used in 1 HD engine toyota land cruiser


The Landcruiser 1HD engine uses 9.3 liters of oil with the filter. The oil is replaced every 5000Kms.

Nov 12, 2008 | 1994 Toyota Land Cruiser

Not finding what you are looking for?
2010 Toyota Land Cruiser Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...