Question about 2007 GMC Sierra Classic

1 Answer

Need to take front lens out of a 2007 gmc.

Front left lens is cracked. Do I have to remove the grill to do this?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 58 Answers

No you do not need to remove the grill. If its the headlight, there should be 2 pins/rods that you would need to pull up and out and the whole assembly will simply pull out. If its the parking/driving/turn signal assembly, it is easier to 1st remove the headlamp assembly, then there should be a plastic squeeze connector toward the side of the vehicle. Simply squeeze that and pull gently.

Posted on Jun 19, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I change the High Beam on a 97 GMC Yukon? Do I have to take the grill off the front to getto it?


You should be able to get to the bulbs by reaching in from the engine compartment side and twisting the headlamp sockets to the left. If you need more room to work and want to remove the healamp housing assembly, you can remove the 2 long bolts that go down through the radiator support and pull the headlamp assembly forward. It is not necessary to remove the grille.

Sep 03, 2011 | 1997 GMC Yukon

1 Answer

I have a 2006 Savana GMC 1 ton van that the both front turn signal housings need to be replace, how do you remove and install the housing?


Take a large (1/4" or wider) flat tippped screwdriver and insert in the outside edge of lens and gently pry off, there is a a plastic tip that holds the lens into the grill housing, once it is loose then move forward and outward. The inside just has a tab that holds the lens in. Mike Thompson ASE Master Tech. Fleetwash Atlanta Shop Manager

Jul 26, 2011 | 2006 GMC Savana

1 Answer

How to change a 2004 GMC envoy front light


Drivers side- stick your hand down by the alternator and over behind the headlight. You'll feel a 3" round rubber boot, just pull this off. Twist the bulb out and replace it.

Passenger side- remove the air cleaner top, at this point, you'll have a lot of room to remove the rubber boot and replace the bulb.

The other method is to remove the grill, but pulling on this can break or crack the grill easily, so I choose this way.

Feb 27, 2011 | 2004 GMC Envoy

1 Answer

I called my local gm dealer about replacing a front head light for a 2007 GMC Acadia and was told that you have to remove the front end to replace the bulb. Is that right?


that is absurd, it is tight but you can do it yourself.........

directly behind the light is a black cap, turn that counter clockwise, and pull back......
the bulb is on the end, simply reinstall in reverse........

I am assuming the dealer misunderstood, I hope........
that you needed lens replaced.... then again they are a dealer.......

good luck hope this helps, it is tight but you can do it.....

Feb 15, 2011 | 2007 GMC Acadia SLE

1 Answer

How to remove front grille


The first thing you do is get close to the grille an look there should be eather bolts in the center or the left side or right. The other ones are on the top or inbehind the head lights

Apr 10, 2010 | 2007 Toyota Camry

1 Answer

My 1991 gmc sierra front side turning light bulb burnt out. I need to replace it. How do I replace it?


On the front turn signal cover there are 4 phillips head screws (1 on each corner) holding it onto the grill. Unscrew those 4 screws and pull the cover out some and you will see that there are 2 turn signal harness attached to the back of the lens. Push in the little plastic arm on the side of the harness and twist them to the right I think. This will unattach the harness from the back of the lens allowing you to pull it out. To get the bulb out of the harness, hold the harness and twist the bulb to the right or left and pull it out. On the bulb there is a little notch that will only allow you to turn it one way. Hope that helps.

Oct 06, 2009 | 1991 GMC Sierra

1 Answer

I have a left front clearance light out how do you get it out 1


Signal and Marker Lights REMOVAL & INSTALLATION Front Turn Signal and Parking Lights
  1. Disconnect the negative battery cable.
  2. At the rear of the front bumper, turn the bulb socket 1⁄4 turn and remove the socket from the parking brake housing.
  3. Remove the bulb from the socket; if necessary, replace the bulb.
  4. If lens replacement is necessary, remove the retaining bolts and remove the lens from the bumper.
  5. To install, reverse the removal procedures. Check the turn signal/parking light operations.
Fig. 1: Common front turn signal/parking light mounting

d16c14b.jpg
Fig. 2: Twist and remove the bulb socket from the back of the turn signal/parking light lens

8b774bd.jpg
Fig. 3: If lens removal is necessary, loosen and remove the retaining bolts

09f4811.jpg

Jul 24, 2009 | 1992 GMC Sonoma

1 Answer

Left front turn signal lens cracked.


Check this info KJ-2002-Liberty-Service-Manual-PDF-Secc-08-Electrical-Systems ( 8L-1 page 165 and next) about headlight remove instructions.

Good luck!!!

Jul 19, 2009 | 2006 Jeep Liberty

2 Answers

How to replace the headlights on my 2003 GMC envoy.


no the battery does not have to come out the grill in front must be removed .yhis grill runs through the headlight lens there ore 2 sqaure clips that hold the lens pull up on them slid out lens and get to the bulb should be 9007 bulb number.

Jan 30, 2009 | 1999 GMC Jimmy

Not finding what you are looking for?
Cars & Trucks Logo

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...