Question about 1999 Toyota RAV4

Open Question

Location for a ignition control module in a toyota rav4

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 80339 Answers

SOURCE: ignition on a 1993 Toyota

Stick a 12 volt test lite in the coil negative side, it should flash while the engine crank's, it will be dim, more like a pulsing glow, if this is not present the Crankshaft position sensor may be defective or the wiring to it. Make sure to check around the engine for any damaged wiring, places where the eng moves the most or the harness runs over something.

Posted on Nov 29, 2008

  • 101 Answers

SOURCE: Where is the Air Fuel Sensor Located on 1999 Toyota RAV4?

The air fuel ratio sensor is located in the exhaust manifold before the convertor. It looks like a o2 sensor.

Posted on Apr 17, 2009

  • 1 Answer

SOURCE: po607

toyota corolla 2007, automatico control module performance p 0607 donde se encuentra en el auto

Posted on Jan 05, 2010

  • 11 Answers

SOURCE: how to change transmission fluid on a 1993 toyota rav4

Ok without knowing the RAV intinmately, below is the link with pics.

You will need a basic tool kit and drain pan and if its your first time a little bit of patience!

Good luck!

Posted on Mar 06, 2010

  • 913 Answers

SOURCE: How I can replace cabin air filter in toyota rav4?

the cabin filter is behind glove box, open glove box an release it so it opens farther to get to filter ( should be release clips at sides of glove box)

Posted on Apr 26, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the location of egnition module for rav4 1999

There is no separate ign module on this. Ignition is controlled by the engine ECU.

Aug 27, 2017 | Cars & Trucks

1 Answer

Uo131 toyota rav4 code

this indicates Lost Communication with Power Steering Control Module (PSCM)
Check all fuses that power up the PSCM module on this vehicle. Check all grounds for the PSCM module. Locate where the ground attaching points are on the vehicle and make sure that these connections are clean and tight. If you have to, take them off, get a small wire bristle brush and baking soda/water solution and clean each one, both the connector and where it connects.

May 07, 2017 | Toyota Cars & Trucks

1 Answer

Location of airbag module 2004 TOYOTA RAV4?

If you're not certified to work on the airbag system then don't mess with because you can. KILL YOUSELF OR SOMEONE ELSE LEAVE IT ALONE

Mar 27, 2015 | 2004 Toyota RAV4

1 Answer

1996 toyota camry ignition module location

Hi there:
Keep in mind that the Igniter is the same thing as ICM (Ignition Control Module), it is located by the brake boostr, I will post a picture showing its location...


Zoom Image link HERE

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day

Aug 24, 2012 | Cars & Trucks

1 Answer

Where is the ignition modulator located in a 1984 toyota truck

Ignition "modulator"??? I assume you mean "ignition module" or "Ignition control module". If this is what you mean, it is mounted on the ignition coil assembly. Toyota refers to this part as "transistorized ignitor".

Jun 13, 2012 | 1984 Toyota Pickup Deluxe

1 Answer

Where is the throttle body fuse on 2008 toyota rav4

There is no "fuse" for the throttle body. The throttle body gets all of its power and ground from the Powertrain Control Module. If your throttle body (or accelerator) is not functioning properly, you need to scan your PCM to find out why.

Mar 06, 2012 | Toyota RAV4 Cars & Trucks

1 Answer

1999 Rav4 Idot now How set it to 4 weel Dr pleas tellme How

1999 Rav4 has a 2-Wheel drive option. If you have 4-Wheel drive (check with dealer) there is no need to set it to 4-Wheel drive as the 4-Wheel drive mode is controled by the Powertrain Control Module (On-Board Computer) as needed.

Jan 30, 2011 | 2008 Toyota RAV4

Not finding what you are looking for?
1999 Toyota RAV4 Logo

Related Topics:

170 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

80263 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides