Driver side door panel
SOURCE: Drivers side door handle won't work
Some linkage maybe broken on the door handle. Door panel removal instructions are availablel on line www.carstereohelp.com/strford.htm but determining the problem will have to be found on your own.
SOURCE: How do remove drivers side door panel
First you need to remove the door handle and window crank by pushing back the ring and releasing the handles. Also the arm rest will have screws into the steel door frame that must be removed. The panel itself has plastic snaps that are pushed into holes in the doors steel frame. The trick is to slide a pry bar or even two is better, one on ether side of the clip and force the pin out. You need to be patent and do one at a time. The door panels are made of a less than hard strong material and will brake apart easily especially if they are older. The clips go all the way around the lower three sides and the top will lift off the sill.
SOURCE: Remove F150 door panel
They Are NO Fun thats for Sure There is a TOOL For the SNAP-ON Plugs on sides and Bottom, But the Top From Handle Up, there are A number of hidden HIDDEN Screws, at times with Interior Matching PLUG COVERS that Must be REMOVED to Gain Access to the Screws. It is TEEDIOUS and Nerv Racking to Remove Them But Just Have A GOOD EYE For the Fasteners and You Will Do Fine with it.
SOURCE: Replace Passenger Side Mirror on 2002 Ford F-150
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
SOURCE: how to remove front driver side door panel (2000 ford expedition)
There is a triangular piece, at top corner, covering a screw behind the mirror. Remove that screw. Remove the piece that covers the handle and remove the screw holding the handle to the door. Look through, where door handle was and remove another screw just above where the handle was. This screw is holding the panel to the actual door. Pop the cover off for the automatic door locks and disconnect them. Lift the panel in an upward direction.
437 views
Usually answered in minutes!
×