Question about 1997 Toyota Camry
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Yes, you have to remove the door panel.
Remove the 2 plastic protectors on the front edge, and remove the 2 brass colored screws. Next, remove the push pins from the latch side. Push in, and pull out the whole thing. Next, under the armrest, remove the screw. Lift up the power windoe control, being careful to not break the plastic retainer tab. Remove the screw under the window control. Starting at the bottom, pull out the panel, and, when all of the clips are loose, pull the panel straight up. It is best to do this with the door panel as warm as possible, like in a heated garage. Doing this outside in the cold will break all of the plastic retainer clips; they are quite brittle whn cold.
I hope this helps
Thanks for choosing FIxYa for assistance. A FIxYa rating (4 blue diamonds) would be greatly appreciated.
Posted on Feb 23, 2009
That code is for the evaporative emmisions system. Here is a link to an open forum you can go to, this will help you understand what it is, and why. The vehicle on the site is a van, but the code, and parts involved are one in the same, so don't worry about the difference in vehicle. The van is a toyota, and this is the information on the p0446 code. Hope this helps you.
Posted on Mar 08, 2009
SOURCE: removing a drive axle from
if you already have the ball joint dissconnect and the axle out of the steering knuckle just pry out the axle at the transaxle assembly. if it doesnt wont to come out try pushing it in and pry it out vary qiuck pull on the pry bar but they are only held in place with a colasable c-clip just giver.it will come dont worry it wont break
Posted on Mar 22, 2009
Tips for a great answer:
Oct 10, 2015 | Toyota Cars & Trucks
The power window/door fuse is located behind the coin tray on the bottom left of the dash? "You have to remove the coin tray. There is a fuse panel behind it. Next to that fuse panel are three bigger square fuse blocks. Two blue 40 amp fuses and a pink type C 30-amp rectangular block fuse. The power window fuse is the pink one. Unless you have very tiny hands you can't reach it. Now you have to remove the lower dash panel that is held on by four 10mm screws. Pop out the two square plastic caps on each side of the steering column to get to the two top screws." Good Luck!
Jun 10, 2014 | 1993 Toyota Camry
May 19, 2014 | 1996 Toyota Camry
Nov 26, 2012 | Cars & Trucks
Jul 10, 2012 | 1998 Toyota Camry
Start by removing the coin tray on the left side of the steering wheel. Next remove the socket that the coin tray sits in, it should be fairly apparent how it comes out, there are just a couple screws holding it in that are visible as soon as you remove your coin tray. After you get the coin tray holder out, another couple screws become visible, remove them, along with 2 others on the left side of the steering wheel (we are removing the entire lower dash panel under the steering wheel). The top screw on the left side is hidden under a small pop-out blank cover, the lower screw you will be able to see by simply bending down under the bottom of the dash section. This whole panel should come off as soon as you have all of these screws removed. If it doesn't want to come off, you missed a screw or 2, look harder.
Once this panel is off, look at your fuse box. Now look to the right of the large group of fuses in the main panel, behind the A/C air duct. You should see 3 square fuses, 2 green and one pink. The pink fuse is in the middle between the green ones and is your power window and door lock fuse.--------------
Remove and replace this fuse with new fuse.Its easily available fuse from local auto part store.Its a 30 amp fuse.---------
But if you replace the fuse and still the problem, then its a possibility that window switch is faulty and it has to be replaced.----------- Check the fuse for 12 volt.--- This will help.Thanks.Helpmech.
Jul 04, 2011 | 2003 Toyota Camry
Sep 09, 2009 | 1997 Toyota Camry
Jul 15, 2009 | 1994 Toyota Camry
May 10, 2009 | 1997 Toyota Camry
15 people viewed this question
Usually answered in minutes!