Question about Volkswagen Beetle

Open Question

Automatic locking program - Beetle Volkswagen Cars & Trucks

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Lexus es300 2001 Doors get locked after i shut the even when I do not Lock the door. When I reopen the door with the key, the alarm goes up and will not stop until I start the engine again


Check your owners manual,you may have different programming modes for the locks ,such as automatic locking time etc.If you have different lock programming,reset the locks to a program you like.Also,sometimes just the action of shutting the door makes the lock button contacts touch inside the button and the doors lock,try shutting the door softly to check for this.

Jun 18, 2017 | Lexus Cars & Trucks

1 Answer

My 1997 Jetta power windows automatically engage and


yes this does happen,try disconnecting the battery and joining the leads together ,this often resets it other than that its either a new drivers door lock or the dealers to have it re programmed

Mar 20, 2010 | 1997 Volkswagen Jetta

1 Answer

Door automatically lock


the idea was to lock the car when moving(passenger safety,kids falling out etc),but it was too expensive to fit movement sensors,so,they fitted autolock,engine starts, car locks.simple......but sometimes a pain in the a???.

Feb 08, 2010 | 2000 Volkswagen Beetle

1 Answer

Replaced battery now having problems with automatically locks


Synchronization
When
Key buttons operated repeatedly while vehicle out of range and system becomes inoperative.
How
Press key lock or unlock button for approximately 1 second. Manually lock or unlock vehicle. System should now lock or unlock vehicle. If not, carry out programming procedure.
Programming
When
Key added or replaced. System malfunction.
How -

98MY
Keys can only be programmed using diagnostic equipment.
NOTE: A maximum of 4 keys can be programmed.
How - 99MY

Switch ignition ON. Insert key to be programmed into driver's door lock. Lock vehicle manually. Press lock or unlock button. Wait at least 1 second. Press lock or unlock button again. Vehicle horn sounds to indicate correct programming. Keys can also be programmed using diagnostic equipment.
NOTE: A maximum of 4 keys can be programmed.

Feb 05, 2010 | 2002 Volkswagen Passat

2 Answers

NEED TO REEPROGRAMING A REMOTE CONTROL FOR A MALIBU 1998 HOW '?


1. Make sure ignition is in the OFF position.
2. Locate the Programming Connector in the trunk (center of rear shelf). It is a plastic connector with
two wires leading up to it. The connector is not plugged into anything. You may have to pull back
trim to access the connector.

3. The programming connector should have two terminals. Connect both terminals with a suitable
jumper wire. The Keyless Entry Module will lock then unlock all the door lock motors once. Make
sure the terminals remain connected throughout the programming procedure.

4. Press and hold the LOCK and UNLOCK buttons on the transmitter simultaneously for at least 15
seconds or until the vehicle automatically locks and unlocks the door locks. Your new remote has
been accepted and all existing remote codes have been erased.

5. Repeat the previous step for each transmitter to be programmed. Do not remove jumper wire in
between programming of transmitters.

6. Remove the jumper wire from the Keyless Programming Connector.

Dec 15, 2009 | 1998 Chevrolet Malibu

1 Answer

Automatic door locks / 2001 Chevy Suburban


Your book should give you program options for the door locks If your fob wont work either you got a relay for the door lock bad it is located in the fuse panel push the door lock button and find the one that is clicking

Apr 11, 2009 | 2001 Chevrolet Suburban

1 Answer

Door key pad, won't unlock door


  1. Enter the permanent factory remote keyless entry (RKE) keypad code.
  1. Press the 1/2 button within 5 seconds to activate the programming mode associated with the memory position 1 settings. Holding the 1/2 button for more than 2 seconds after activation erases the stored personal code.
  1. Within 5 seconds, enter the new 5-digit RKE keypad code. The door locks lock and unlock to confirm the new code is programmed and associated with the memory position 1 settings. Entering any new personal code automatically erases the old personal code.
  1. Press the 3/4 button within 5 seconds to activate the programming mode associated with the memory position 2 settings. Holding the 3/4 button for more than 2 seconds after activation erases the stored personal code.
  1. Within 5 seconds, enter the new 5-digit RKE keypad code. The door locks lock and unlock to confirm the new code is programmed and associated with the memory position 2 settings. Entering any new personal code automatically erases the old personal code.
  1. Press the 5/6, 7/8, 9/0, 7/8 and 9/0 button within 5 seconds to activate the programming mode or allow the system to timeout.
  1. Within 5 seconds, enter the new 5-digit RKE keypad code. The door locks lock and unlock to confirm the new code is programmed. Entering any new personal code automatically erases the old personal code.

Jan 23, 2009 | 2005 Ford Freestyle

1 Answer

The battery in my 2006 pontiac vibe went dead. I recharged it; however, the setting for the door locks changed. It now unlocks automatically when I turn the car off instead of when I put the car in park. I...


The 2006 Vibe no longer has that feature. It was discontinued after 2005. I have the 2005 so I know how to change it. If your 2006 is able to change then here are the directions from my 2005.
Programmable Automatic
Door Locks
If you have an automatic transaxle, your vehicle is equipped with an auto door lock/unlock feature which enables you to program your power door locks.
Your vehicle left the factory programmed to Mode 4.
The following is a list of the available programming options:
Mode 1: All doors and liftgate lock when the shift lever is moved out of PARK (P) with the ignition on and all doors and liftgate closed. There is no automatic door unlocking.
Mode 2: No automatic door locking or unlocking.
Mode 3: All doors and liftgate lock when the shift lever is moved out of PARK (P) with the ignition on and all doors and liftgate closed. All doors and liftgate unlock when the shift lever is moved to PARK (P) with the ignition on.
Mode 4: All doors and liftgate lock when the shift lever is moved out of PARK (P) with the ignition on and all doors and liftgate closed. All doors and liftgate unlock when the ignition switch is turned from ON to ACC or to LOCK.
To change the mode you are in, do the following:
1. Set the interior lamp control dial to the door position.
See Interior Lamps Control on page 3-16.
2. Move the shift lever into PARK (P) and close all doors and liftgate.
3. Turn the ignition to ON.
4. Within five seconds after the ignition is turned to ON, press and hold the power door lock switch in
the lock position for about five seconds.
5. The interior lamp will flash to indicate that the mode has been changed. For example, if the lamp flashes once, the function has been changed to Mode 1.
If the battery is disconnected or run down, the mode is changed to the initial mode which is Mode 4.

Jan 22, 2009 | 2006 Pontiac Vibe

1 Answer

1999 DODGE DURANGO AUTOMATIC DOOR LOCKS.


That feature is called rolling locks.
In order to program the rolling door locks you will need to do the following procedure (listed on page 10 of the owners manual).
1. Close all of the doors.
2. Place the key in the ignition and cycle the key from the OFF to the ON position for a total of 4 to 5 times, ending in the ON position, do not start the engine.
3. Press the driver's side power lock switch to LOCK the doors within 30 seconds of cycling the key.
4. You will hear a single chime when programming is complete.
5. To cycle the feature on/off repeat the procedure.

Jan 11, 2009 | 1999 Dodge Durango

1 Answer

Auto door locks not working


DOES THIS HAVE KEY LESS ENTRY IF SO MUST BE PROGRAMED , TO LOCK CHECK OWNERS MANUAL FOR PROGRAM PROCESS

Nov 24, 2008 | 2008 Chevrolet Hhr

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76673 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...