Question about 2001 Jeep Grand Cherokee

Open Question

P1038grand cherokee fault code p1038

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fault code P0107 in 2001 grand cherokee


Code 107 means the MAP sensor signal is low. The problem could be the sensor, the wiring, or a major vac leak.

Aug 04, 2014 | 2001 Jeep Grand Cherokee

1 Answer

PO137 02 sensor of 1998 grand cherokee


Google it & read up

Oxygen Sensor Code

Codes don't tell you what to replace,
have use code to diagnose the fault

Mar 27, 2013 | 1998 Jeep Cherokee

1 Answer

1991 jeep cherokee 4.0 L lareado engine in a 1991 jeep cherokee will not start why


You need to do a fault code test and check the fuel pressure. To run the fault code test and see the code definitions go here.

Oct 16, 2012 | Jeep Cars & Trucks

1 Answer

Check engine code 55 jeep grand cherokee laredo v6 1997. transmission wont shift properly also pulling code 21 and i figured out that one is for the throtle position sensor


These are the fault codes for your Jeep below;

Jeep
11 IGN reference signal.
13 Fault in the map sensor pneumatic circuit.
14 Fault in the map sensor electrical circuit.
15 Fault in the vehicle speed sensor circuit.
17 Engine running too cool.
21 Problem in the oxygen feedback circuit.
22 Fault in the coolant temperature sensor circuit.
23 Air temperature sensor.
24 Fault in the throttle position sensor circuit.
25 Fault in the IAC motor drive circuit.
27 Fault in injector driver interface circuit.
31 Purge solenoid circuit.
33 Fault in air conditioning cutout relay circuit.
34 S/C solenoid circuits.
35 Fault in fan relay circuit.
41 Fault in the charging system or no field current.
42 Fault in the ASD relay driver circuit.
43 Fault in ignition coil control circuit.
44 Battery Temp Voltage.
46 Battery voltage is too high.
47 Battery voltage is too low.
51 Lean condition is indicated.
52 Rich condition is indicated.
53 Internal problem in module.
54 Fault in the distributor high data rate pickup circuit.
55 Completion of fault code display.
62 Unsuccessful attempt to update EMR mileage.
63 Unsuccessful attempt to write to an EEPROM location by the controller.
76 Fuel pump resistor by-pass relay circuit

Mar 08, 2011 | 1997 Jeep Grand Cherokee

1 Answer

Jeep Grand Cherokee 1997. Getting check engine light signal 12 14 43 55. Car symptoms are stalling rough idle.


Code 12 = Recently disconnected battery

Code 14 = Coolant sensor high resistance or shorted

Code 43 = Knock sensor or Electronic spark control circuit fault

Code 55 End read code.

Hope helps (remember rated this).

Jun 12, 2010 | 1997 Jeep Cherokee

2 Answers

I have a jeep grand cherokee limited 1995. the check engine light flash. How to have the fault code?And how to solve the problem?


You will need a OBD 2 scan tool to retreve your code.If you hve not one go to a garage they will retreve the fault code for you.However you might consider makeing the purchase of one through a car part store near you.

Dec 24, 2009 | 1995 Jeep Grand Cherokee

1 Answer

Need to know what trouble code 55 is on the 1993 jeep cherokee country 4.0 l


code 55 is the "end" code showing that the diagnostics have been completed. If you had no other codes, then there is nothing stored as a fault in the computer.

Oct 21, 2009 | 1993 Jeep Cherokee Country

1 Answer

2000 Grand Cherokee 4.0 liter 2wd


PULL THE TRANSMISSION PAN TO SEE IF THE IS ABNORMAL CLUTCH MATERIAL IN THE PAN. IF EXCESSIVE AMOUNTS ARE NOT PRESENT THAN THE PROBLEM SHOULDN'T BE TOO SEVERE. WAS THE FAULT CODE FOR VOLTS TOO HIGH OR TOO LOW?

Sep 25, 2008 | 2000 Jeep Grand Cherokee

1 Answer

1999 jeep grand cherokee 6cyl.check engine light stays on.


Extracting Fault Codes:
Turn the ignition switch ON, OFF, ON, OFF, ON and observe the CHECK ENGINE LIGHT. The CHECK ENGINE LIGHT should begin to flash a series of codes. The flashes will be separated by short an long pauses. The long pauses separate the "ones" and "tens" positions, and each code from the next. A code 55 will be displayed at the end of the test.

Read the Fault Codes:
Here you can find the ODB Codes

Good luck!!!

Aug 01, 2008 | 1993 Jeep Grand Cherokee

Not finding what you are looking for?
2001 Jeep Grand Cherokee Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...