Question about 2000 Jeep Grand Cherokee

1 Answer

Some what the same problem

I don't have a remote start on my 2000 jeep grand cherokee but we had a bad storm also and right after the storm i went to leave and i turned the key and my key security light was flashing and all of my gauges were completely dead... Vehicle turns but i noticed i didn't hear my fuel pump come on in the back and from what i've found out after doing alot of homework on the net is that it may be the skim module. Check to see if ur light for the key is coming on and if it does then we have the exact same problem!!! Thanks and hope this helps u out!

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 365 Answers

I had a Chysler product do the same thing.The computer thought the car was stolen and would not fire.
After 10 tries it did run and ran for quite some time until nothing would help.I then had to change the computer.
See if there is a recall on this!

Posted on Jun 19, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I was trying to jump start my jeep and connected the jumper cables wrong. Now its doing all sorts of funny stuff. What should I do to fix this problem?


I had a battery die on my 02 grand Cherokee, all the gauges went wild, needles bouncing from left to right crazily! You need a new battery!

Sep 06, 2013 | 2000 Jeep Grand Cherokee

1 Answer

1994 Jeep Grand Cherokee that will start sometimes.


you can have a bad coil you can have a bad crank sensor a bad cam sensor a bad throttle posistion sensor etc. if you can have someone do a diagnostic on the car to see if any codes are stored this will give you a good starting point.

Jun 18, 2010 | 1994 Jeep Grand Cherokee

1 Answer

The 4 wheel drive on my 2000 jeep grand cherokee


The ticking noise is most likely your tranfer case chain. the chains in this case...overtime....will stretch, causing the chain to have enough slack the hit the bottom of the case.

Jan 21, 2010 | 2000 Jeep Grand Cherokee

1 Answer

2000 jeep grand cherokee air conditioning


sounds like the clutch field on or bearing on the front of the compressor went bad take a closer look at the pulley on the comp. and see if there is any debris or melted plastic coming out behind the pulley,if so the clutch,field and bearing should be replaced,hope this helps

Sep 13, 2009 | 2000 Jeep Grand Cherokee

1 Answer

2000 Jeep Grand Cherokee front end howling


still sounds like bad tires to me.  is it an engine or belt noise?  Is it a whistle?

Apr 03, 2009 | 2000 Jeep Grand Cherokee

1 Answer

Jeep wont start


The crank position sensor is on the bell housing of the transmission, very hard to see, on passenger side, below the valve cover, depending if it is an early 2000 or a later 2000 model.

Mar 31, 2009 | 2000 Jeep Grand Cherokee

1 Answer

2000 Jeep grand cherokee limited remote start


higher end starters will have the lock/unlock/panic buttons built onto their fob. as for the seats... I dont know why it would interfere with your settings, but who knows... better to ask the seller of the remote start system.

Mar 18, 2009 | 2000 Jeep Grand Cherokee

1 Answer

Both of my keyless entry remotes just stopped working any ideas


sometimes you have to hold the lock and unlock at the same time and stand close to your jeep until the locks unlock and lock agian if that works then they are reset if not than try to change the batterys in one remote and retry

Mar 11, 2009 | 2000 Jeep Grand Cherokee

1 Answer

Jeep grand cherokee power seats


Try hitting the seat motor with a small hammer while you move the seat switch.

Oct 10, 2008 | 2000 Jeep Grand Cherokee

Not finding what you are looking for?
2000 Jeep Grand Cherokee Logo

153 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...