Question about DAF 44

Open Question

Heater controls on DAF 45 130

The lever controlling the heat level won't move up and down. How do I fix it

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 83 Answers

SOURCE: location of heater control valve 2005 grand prix

i don`t think there is a heater control valve.you may have an air pocket in system.

Posted on Jan 06, 2009

Just_Bobz
  • 448 Answers

SOURCE: 2004 Chevy Tahoe seat controls not working properly

Time to replace that switch. The rocker inside maybe coming apart. If you find this helpful, please post as such. TY

Posted on Jan 18, 2009

emissionwiz
  • 75797 Answers

SOURCE: 1997 F150 heater problem

your problem is caused by the air temperature control blend door actuator motor being defective, the little motor moves the door that gives either hot air or cold air or a blend of the 2.

Posted on Feb 21, 2009

  • 1 Answer

SOURCE: Lancer 2002, change heater control switch

contrary to what the dealership tells you you don't have to take out the entire dash to fix the heater switch, all you have to do is first locate a heater switch which I thought was imposible to find too, but I found one online for 165 bucks from a used autoparts store, then all you do is take off the molding that surrounds your stereo, then take out your stereo, then you will see a blue cable on the right side and a black one on the left carefully disconnect those and the two wireing harnesses in the back the upper one is white the lower is black, then pull the unit out and put the other back in the same way, now it's still going to stick cause of those moron engineers so if you kneel on the ground and look next to your gas pedal you will see to pieces of white plastic that is why you can't switch to heat that flimsy cabel has to push that gear forward, that gear is sticky so it won't go forward, there is a replacement gear to fix that problem that should be about 18.00 from the dealership. it took me about an hour or less to do the whole operation. I just literally finished it 20 minutes ago in my wifes lancer which i broke that knob off of. Good luck if you havent figured it out yet.

Allen

Posted on Apr 22, 2009

  • 1129 Answers

SOURCE: heat problem

If memory serves me these cars use a vacuum operated heater control switch follow the heater hoses back to the fire wall the switch should be located somewhere in line with one of the hoses have someone activate the heat temp control and check to make sure the switch is getting 18 lbs of vacuum. Vacuum gauges are fairly inexpensive purchase one to check. If there is less than 18 lb at full temp. setting on controls the check valve must be replace and the hoses source connection must be checked make sure it is not broken or dry rotted. Hopefully the electronic controls on the dash are not malfunctioning.

Posted on Oct 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My mitsubishi galant temp control lever won't switch to heat


that happened to me the heater core went out ive read alot of different things about 03 galants most of them have the same problem it started with a grinding noise turning the temp contol, its actually the heater control motor value it causes the heater core to go out

Dec 27, 2012 | 2003 Mitsubishi Galant

3 Answers

Heater puts out heat only briefly then blows cold


Check that the coolant level in the radiator is full. Check that the engine has a working thermostat and is reaching temperature. Often if the thermostat is faulty or has been removed the heated will warm whilst at the trafic lights then cool off as the car is driven. The heater core on an older vehicle especially if it has not had coolant in it at some time can become blocked. You could pull the heater hoses off and back flow the core with a hose to flush it. Also check that the heater tap and vent flaps are working properly. If this has been helpfull please vote Jeff

Mar 08, 2011 | 1978 Pontiac Bonneville

1 Answer

No heat engine warm fan works on all levels directional control (defrost@floor) stuck on cold. ?temp control .


your heater core could be plugged if your anti-freeze color is a brownish colour , most likely your heater core is plugged also when you move the direction for heat control can you hear the blendoor move if you can then again your heater core may be plugged and if it is plugged flushing most likely wont fix it, if you don't hear the blendoor motor move the blendoor motor or the door may be damaged

Dec 09, 2010 | 2002 Ford Taurus

2 Answers

The heater blows cold looking for heater fuse or selenoid to try to fix


if the heater is blowing cold then it is not a fuse
it is probably your thermostat or heater core
but i will change the thermostat first
and bleed the heating system also

Dec 05, 2010 | 1983 Chevrolet S-10

1 Answer

'87 cressida. No heat: New radiator, fresh coolant, coolant level good, Reverse flushed the heater core. Under dash I can manually move the actuator lever and get heat. When I slide the dash control to...


Try changing your thermostat. A bad thermostat will not let the fluid heat up. if its your controls your cables might be stuck so they won't operate. Maybe need new control . Maybe try a used auto wrecker to get used parts if you can't buy new.

Mar 14, 2017 | 1987 Toyota Cressida

1 Answer

1999 ford windstar heater lever will not turn on front heat


Check on the heater control valve. It is probably close to the firewall behind the engine. There will be coolant lines attached to it. This valve should have an arm on it that opens and closes a valve inside, either shutting off or allowing hot coolant to flow into the heater core. The arm should be attached to a cable coming from inside the car. See if the arm moves when you move the heat temperature level inside the car.

Oct 18, 2009 | 2001 Ford Windstar

1 Answer

Heater not blowing warm air. Thermostat has been


Check the water control valve behind the engine close to the firewall. This valve opens and closes to allow hot coolant to enter the heater core. It is usually connected to the heater controls with a cable. When you adjust the heater control for heat, a cable activated lever on the valve should move and allow coolant to move through the valve. The cable from the heater control can come loose from the lever, or the valve itself can become corroded and hard to move.

Oct 16, 2009 | 1993 GMC Sierra

2 Answers

1987 ford ranger 4cyc heat not working water level fine could it be thermostat


Does the coolant temperature gauge show the same level that it always has? If so, it's likely not the thermostat.

A common problem involves the water valve that allows hot coolant to flow into the heater core. This valve is usually located close to the firewall behind the engine. If this valve does not open, you will have no heat. These valves can get corroded, and the cable from the heater control can sometimes come lose. See if the arm on the valve moves when you move the heater control to heat. It should.

Oct 16, 2009 | 1987 Ford Ranger

2 Answers

Heater is blowing air but does not get hot


I looked at my friends 1997 mark viii for no heat. Found info on fixing it online. It involved taking the dash completely apart. Like six hours. The problem most lincolns had, seemed to be black plastic lever for mix door cracked. You can not see this lever, but can access the gray lever it works with, I moved the gray lever and got heat.He Got lucky and found his problem was different. Disconnect battery for a minute or so and this should reset computer for climate control. Seems if mix door was not moving due to some sort of computer glitch. Has heat for now. Hope this can help someone and its not a broke lever.

Oct 15, 2009 | 1997 Lincoln Mark VIII

1 Answer

My heat doesn't work on and speed


It can be several things, 1st to check is coolant level. If the level is too low, it won't circulate thru the heater core, and no heat. 2nd, check the thermostat. If it's stuck open, your car will not heat up and u will not have heat. 3rd is the dash control that calls for heat. If u have trouble w/ the vacuum control when turning lever to heat, it won't open the valve to allow the hot engine coolant into the heater core. 4th a plugged up heater core, due to corrosion buildup, coolant can't circulate, no heat. That should cover the possibilities, start w/ the easy cheap stuff, and work your way down the list. Let me know what you find, and if this doesn't fix it, we can continue on.

Nov 26, 2008 | 2002 Chrysler Sebring

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top DAF Experts

David Harrelson
David Harrelson

Level 3 Expert

5313 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Ralph Koozer

Level 2 Expert

166 Answers

Are you a DAF Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...