Question about 2008 Peugeot 207 Sport

Open Question

Anti pollution fault showing on dashboard

Fault light and engine management light staying on

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 636 Answers

SOURCE: 307 fuel fault blocked filter and pollution fault on dash HELP

Try disconnecting your battery , this should reboot it and remove the code .

Posted on Jul 26, 2009

Ad
  • 215 Answers

SOURCE: my car says 'anti pollution fault' when I start it

If you drive your car more likely for short distances then engine will not get hot enough to start the regenerating process to clean the cloged particulate filter resulting in a antipollution fault.

Drive your car to a motorway or empty dual carriage way (best in nights). The temperature meter should be showing above 60°C when you begin with this process. Place 3rd gear and drive your car at 3000-3500 rev /min for 15 to 20 minutes to let the ecu to kick the regeneration process. Keep driving car for 15 minutes in this state will be enough to clean your catalytic converter and your problem will be solved. But if it doesn't then the problem is with your catalytic converter and more probabily you need to change it.

Posted on Feb 10, 2010

Testimonial: "thanks!"

alicantecoli
  • 22265 Answers

SOURCE: 407 SW 136 diesel engine intermittent misfire/ hunting.

the rear exhaust box has filter in it and the sensor is showing it as blocked ,which i think it could be as their is a problem with this model and it has been modified ,i would be inclined to just fit a rear box with no fancy filter and try to do something with the sensor as it will continue to throw up the light which means it will not pass its inspection ,now the dealer might not be inclined to change this box as its expensive i think about 700+euros the last time i had this problem i fitted a normal box and shoved a shunt resistor across the sensor terminals ,but i dont know what the resistor value was as i took a load of old resistors out of an old tv and i tried then one at a time till teh light stayed out ,i know it had a gold band on it but thats about all

Posted on Jul 30, 2010

alicantecoli
  • 22265 Answers

SOURCE: I have a Peugot expert van and the anti pollution

best advice i can give is to make a coca can gasket for the ERG valve so it blocks the hole off ,then it will run ok promise ,you do not this device and it will pass the mot without it ,nobody will even know its blocked off

Posted on Dec 26, 2010

  • 51 Answers

SOURCE: anti pollution light, ESP ABS, engine warning

Those are multiple problems. ABS is antilock brake system. Normally this comes on when you need to replace your brakes. Also replace the engine oil in your car and have your car tuned. The check engine light will more than likely go off. If not then the mechanic will tell you what needs to be done to make it go off. Hope this helps

Posted on Jan 18, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine mangement light stays on


When the CEL light is turned on by the on board computer system it means a fault has occurred in the system it monitors and or controls. You must have the fault code read with a special tool called a scanner to see what fault has occurred and then do the diagnostics to repair it.

Aug 15, 2016 | Cars & Trucks

1 Answer

1999 beetle Volkswagen the engine stays on.what do I have to do to make the check engine light go off


The engine check light will come on to signal the management computer has detected a fault that would affect emissions and has switched to a get-you-home programme.

An obd code reader or scanner will be needed to help identify the fault and clear the code after the repair.

Jun 01, 2016 | Volkswagen Cars & Trucks

1 Answer

Low fuel light comes on and stays on but tank is full.


run the fault codes to check for a sensor problem. the ford service manager sold you a product that you didn't need as that was not the problem. He should have suggest the fault code reading.

Feb 08, 2015 | 2010 Mercury Mountaineer

1 Answer

1998 terrano immobiliser fault wont start


hi, i have nissan terrano wen i switched on engine light flash and start engine its start then go of.nissan terrano patrol engine

Sep 06, 2012 | Nissan Sentra Cars & Trucks

1 Answer

Engine management warning light on


Engine management warning light on ?????? What DTC'S - diagnostic trouble code's stored in the PCM - engine computer ? Should have DTC'S stored

Oct 14, 2017 | 2006 Saab 9-3 Convertible

1 Answer

I have a Mitsubishi 2007 Triton Cab/Chassis vehicle,I would like to shut off the engine management light permanently if possible. It comes on at start and stays on some of the time and then at other times...


Hi Barry,
I'm afraid you may have misunderstood my ad. I do not have any "magic fixes" that will get the light to turn off. I only offer help with performing diagnosis and repair to those who would like to save money. Diagnostic time at a shop is expensive, as you probably already know. The way I can help you is to avoid the diagnostic time at the shop and diagnose the problem yourself and perform the repairs necessary to correct the problem with your engine management system without replacing a bunch of UNNECESSARY parts trying to GUESS what the problem is.

Here is the next problem. I need to know which engine your Triton is equipped with and which fault code numbers you are getting. There is no way to look up the correct diagnostic procedure or wiring diagrams or anything else we may need without this information.

Also, Triton is not sold in the USA. The Triton platform is sold in the USA as a Mitzubishi Raider. I have diagnostic and repair information for the Raider, but none for the Triton. They are probably very similar, but I won't know for sure until we get into diagnosing your truck.....wire colors, component locations, etc., may be a lot different.

If you would like to continue and see if we can get your truck fixed, let me know.

Feb 17, 2012 | Mitsubishi Cars & Trucks

2 Answers

What is wrong when the check engine light comes on


One or more of about 500 different things. The vehicle needs to get scanned for a proper diagnosis.

Jul 15, 2009 | 2002 Kia Rio

2 Answers

My audi a4 2001 model engine management light comes on whats wron


impossible without putting it on a computer for a code,that will give you an idea of the fault !!!!

Dec 08, 2008 | 2001 Audi A4

1 Answer

Some of the warning lights stay on.


so all the lights that come on when you first turn the key on stay on? maybe your alternator is not working properly? or not connecting to your dash panel correctly? or maybe the engine management system has a fault in it? more likely to be a dodgy connection to your dash board.

Jul 12, 2008 | 1994 Isuzu Amigo

Not finding what you are looking for?
2008 Peugeot 207 Sport Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

mike hayward

Level 2 Expert

279 Answers

Wahs Team

Level 2 Expert

215 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...