Question about Ford Fusion

Open Question

Car will start with jump only battery good ford fusion 2007

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
warlock61
  • 659 Answers

SOURCE: No transmission fluid Dipstick on my 2007 Ford Fusion

depending on which trans it is there is a small dipstick on the trans at the front on the bottom these transmissions take a specific fluid so be careful

Posted on Nov 22, 2008

Ad
  • 1 Answer

SOURCE: my 2007 ford fusion wont start

ford has a fuel shutoff switch in the trunk
It sound like it needs reset
open the trunk and check it out on the left side

Posted on Nov 27, 2008

gordanddar
  • 477 Answers

SOURCE: Ford fiesta fusion 2006-2007 the clutch starter

You would have to bypass the switch............or roll start the car.

I assume you mean the safety switch that won't allow the starter motor to go unless your foot is on the clutch.

Switch is about $ 60 ( what a rip off )

Posted on May 10, 2009

  • 5520 Answers

SOURCE: our ford fusion wont start then battery goes flat

Check the Inertia switch and push the reset button for 3 seconds. This switch is usually in the rear area of the vehicle. It can activate if a door or trunklid is slammed too hard.

You should hear the fuelpump running for several seconds when you turn the key on. If this does not work you need to determine if it is a spark or fuel problem. Also look at the front of the motor if it is a 4 cylinder to see if the timing belt broke.

Posted on Nov 30, 2009

speedwagen
  • 491 Answers

SOURCE: corroded positive battery teminal 2007 ford

It's best to replace the entire cable.
There are seperate repkacement terminals, but you need to make sure you get a good install on them

Posted on Nov 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Battery & alternator both good, but wont start without jump off, atleast once a day.


Your battery will not be "good" if you can jump start the car from another power source. If it is a 2014 model it will be the original battery.

Unless you have tested the cold cranking amps the battery is producing you cannot say if it will turn the starter motor or not. A good battery would kick the starter motor over. If you can jump start the car by connecting another power source to the battery terminals it will not be a wiring issue either.

If it's a 2014 it should still be covered by new car warranty (but not if the problem is just a failed battery which is subject to the applicable battery warranty)./

Jan 14, 2016 | 2014 Ford Fusion

2 Answers

2014 ford fusion engine wont crank after wreck


Ford fusion won't start - YouTube

? 2:01
www.youtube.com/watch?v=H0BhHWT2cyY
Sep 16, 2014 - Uploaded by mlmunoz21
Ford fusion won't start ... Published on Sep 16, 2014 .... 2004-2008 F150 Died Out No Crank Theft Light ...

Ford Fusion won't start - YouTube

? 0:32
www.youtube.com/watch?v=lmH7R6Ebmyc
Jan 9, 2015 - Uploaded by Nicholas A.
Any ideas why it won't start? 2007 ford Fusion awd 6 cylinder. ... And P1260 2007 Ford Fusion - Theft ...

Nov 02, 2015 | 2014 Ford Fusion

1 Answer

Starting


Charge your battery, clean your terminals and see what happens. If you don't have a charger, clean the terminals and try jumping it again. Make sure you have quality jumper cables.

Apr 01, 2014 | 2007 Ford Fusion V6

1 Answer

Ford fusion stuck in park, engine won't start


It sounds like you have a dead battery. have it tested.

May 30, 2012 | 2007 Ford Fusion V6

1 Answer

Corroded positive battery teminal 2007 ford fusion? what to replace with?


It's best to replace the entire cable.
There are seperate repkacement terminals, but you need to make sure you get a good install on them

Nov 30, 2010 | 2007 Ford Fusion I4 SEL Sedan

1 Answer

Why is my 6 disc cd changer in my 2007 ford fusion not working? it just says error. What should I do? Thanks!


Its possible that recently disconnected the battery and the LOCK CODE needed re-enter.

Check your owners manual to the procedure.

Good luck.

Jul 14, 2010 | 2007 Ford Fusion I4 SEL Sedan

1 Answer

2006 Ford Fusion will not turn over and the electrical is making noise along with dim lights. HELP


the battery is most likely low or the cables to the battery have become corroded. try a jump and clean cables. symtoms of low battery/corroded cables are a rapid click/buzz sound when turning key to start

Jun 05, 2010 | 2006 Ford Fusion

1 Answer

2007 Ford Fusion shaking when stopped


Sounds like a missfire, check spark plugs and HT leads from coil, they suffer from water damage from the windscreen washer jets. If water found you will need new coil, plugs Ht leads and revised washer jets from ford.

Good luck Davelee

Mar 15, 2009 | 2006 Ford Fusion

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...