Question about 1994 Ford F250 Supercab

2 Answers

Drain some tranny fluid

There is no drain plug on the tranny pan. what is the eaisest way to drain some fluid?

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Expert
  • 128 Answers

Buy some fish tank hose and start sucking from the dipstick hole.

Posted on Apr 20, 2014

  • dan lincoln Apr 26, 2014

    viscosity will prevent the fluid from flowing easily. must be removed by draining

  • marc w Apr 27, 2014

    Not if you use fat syringe or a pump.

×

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Expert
  • 157 Answers

Transmission cooler line... locate yours. hold both by hand. have helper start engine. first one to feel warm is the supply line. shut off.
remove and add a suitable hose. direct into a bucket or drainpan.
start and allow to pump the desired amount. use dipstick check to verify. shutoff. be careful not to run but a few seconds at a time.
after desired amount has been collected, run and correct fluid level.
note: some cooler lines require a release tool to detach. no way of knowing which setup yours has. some setups require resealing of the coolerline connector with o ring, others require replacement of the connector. if you find you would rather not because of intricasy of your setup, a suitable suction gun can be obtained from a hydraulic fitting and hose repair center. part stores often have catalogs to look one up, or , most ford dealers have one in their service dept !

Posted on Apr 26, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to drain and fill transmission fluid in 2012 chevy malibu?


GET NEW GASKET AND FILTER FOR TRANNY ALONG WITH THE FLUID (BEFORE YOU BEGINE)
GET A LARGE FLAT DRAIN PAN.
PUT CAR UP ON 4 JACK STANDS.
place drain pan under tranny pan.
undo tranny pan screws - allow one corner to hang lower than the other corner (to allow fluid to drain) slowly remove them all.
Its messy! empty tranny pan into drain pan. set tranny pan to the side. undo the filter clamp, carefully remove the filter - set into the drain pan, remove the gasket around the tranny body/tranny pan.
Clean tranny block surface with clean cloth. install new filter, install clamp tightly. Clean tranny pan, place gasket onto pan and then reinstall tranny pan. (this only change the fluid in the tranny body and pan) If you wan the fluid out of the torque convertor you have pull the pan under the torque convertor and turn the convertor so you can get at the drain plug. Allow fluid to drain into drain pan. Reinstall drain plug and pan. (you will need a lot of fluid) Check manual for qty. Place car back on to ground/floor. Refill tranny through filler tube. Do not start the engine until oil is at full mark, and when you do start it do not all it to run for than 4 minutes - stop and add more fluid and check full mark again (repeat until no longer sinks below full mark. gently test drive around you block -- come back and check level while engine running. Top up if needed.
Siphon out excess above full mark. Test drive around 3 block,
come back check full mark. Because the torque convertor was emptied it can take a while to get all the air out it.

Jul 19, 2014 | 2012 Chevrolet Malibu

3 Answers

Need to change transmission fluid, PLEASE assist. is there a drain plug or does it need to be sucked out with high power equipment?


While some vehicles are equipped with a transmission drain plug, most are not. The ones that are not equipped require you to drop the transmission pan to drain the oil, which is a good idea anyway because there is a filter inside the pan which should be changed when you change the fluid. Look under your car and locate the transmission pan. If it has a plug it will usually be located on the back side of the pan. If it does not have a plug, the easiest way to drain the pan is to remove the screws from all but one side of the pan. When you have screws left in only one side, steadily loosen the remaining screws a few turns at a time allowing to pan to tilt slowly downward releasing the fluid steadily and avoiding a big mess. While you have the pan off, be sure to replace that transmission fluid filter and pan gasket. They usually come in a set. Hope this helps you out. Have a good day!

Jun 07, 2011 | 2006 Kia Optima

2 Answers

I am going to attemp to change the tranny fluid in my '92 Taurus. Where is the drain plug underneath and is it true that it takes 12.8 quarts of fluid? Is there anything else I should know before I start?


well first theres no plug to drain fluid, you will have to remove the trany pan, the pan gasket and filter need to be replaced,next thing is that it doesnt hold 12.8 qts, thats only if it was dry empty,just dropping the pan doesnt get all the oil out, the converter is still full and the lines and cooler,i would replace the filter and pan gasket then take to a garage and have a bg trany service done, this service gets 100% of the old oil out,your doing a drain and fill, this only takes about 6 qts,good luck.

Mar 31, 2010 | 1992 Ford Taurus

1 Answer

TRANSMISSION SERVICING


remove the drain plug and measure the amount of fluid that u have drained out of the pan, remove the tranny pan and change the filter the pan has a reusable gasket wipe it off and reinstall the pan,i found it easy to fill the tranny pan halfway up before you put it back on,let the engine run until it get to operating temperature.in the center of the drain plug you removed theres a small star head plug in the middle of it remove the plug this is your fill plug you can use a fluid exchanger to fill the tranny while its running just be patient and if you measured the old fluid that u drained youll know very close to how much youll have to put back in just remember theres no level indicator so you need to put back what u drain out if you need any help let me know

Jan 19, 2010 | 2005 Ford Explorer

1 Answer

Where is the oil drain plug? How do you distinguish it from the transmission plug?


the oil drain plug is the 14mm bolt on the bottom of the the big black oil pan. on a tacoma the oil pan is more in the front and tranny sits behind motor- therefore trans pan if further back. I also think the tranny drain plug is more of an alan hex head type bolt. If the fluid comes out red you got the wrong one.

Nov 30, 2009 | 2008 Toyota Tacoma

1 Answer

Transmission on 2001 kia sephia has to much fluid added.Where is the drain plug on this tramission to remove the extra fluid


auto tranny,some have drain plugs,some dont ,have to remove tranny pan if theres no plug.on manual tranny drain plug is under tranny,both tranny plugs if equip. are under cars drivers side

Sep 05, 2009 | 1999 Kia Sephia

2 Answers

How do i change my transmission fluid is it a pan or a plug


IF THIS IS A FRONT WHEEL DRIVE THE PAN WILL NEED TO BE REMOVED TO DRAIN THEY DON'T PUT PLUGS IN THE PANS ANY MORE

Sep 05, 2009 | 1994 Honda Accord

1 Answer

How do I drain transmission fluid (2000 sable ls(dohc))?


On an automatic tranny, the tranny oil pan is removed to drain the tranny fluid - a somewhat messy job. Typically when this done the tranny filler is replaced. A new pan gasket is installed in this procedure.
On the manual tranny, there is a drain plug at the bottom side of the tranny to drain the oil.
I have used a home made setup using a suction pump with small diameter tubing to **** the fluid out from the tranny filler tube. This is when I was replacing the filter and I dropped the pan. I did the suction routine to avoid all that fluid dripping out when you loosen the pan.
Have you located the leak? Is it from the tranny oil pan or maybe from a tranny cooler line?

Aug 10, 2009 | 2000 Mercury Sable

1 Answer

00' Kia Sephia LS not shifting past 1st gear


first you need to buy transmission fluid new filter and new gasket.you need 11.4 pints of transmision fluid.raise front of vechicle.set parking brake.block both back wheels.besure support vechicle weight with jack stands. get a drain pan.if your transmission pan dont have a drain plug.loosen rear pan bolts a few turns.remove the front and side transmission pan bolts. let fluid drain.remove tranny pan. then clean old gasket material from transmission and pan carefully.dont scratch or damage surface.clean old tranny bolts using brake cleaner or buy new tranny bolts.you have to put a tiny film of rtv silicone on tranny bolts so they wont leak.carefully remove old tranny filter and put on new filter.clean all grease grim away from tranny pan it should be **** and span because.you might need a little gasket adhesive to hold gasket in place while putting pan back on transmission.to line up bolt holes.loosely put all bolts in you have to move pan a little to get holes line up.when all is finish put tranny fluid back in.besure you put 11.4 pints back in that about 6.5 quarts. make sure tranny fluid level is right before driving vechicle.l

Jun 19, 2009 | 2000 Kia Sephia

2 Answers

"is there a plug to drain tranny fluid on a 94 accord with auto


You must either drop the pan or have a transmission flush performed. The filter is only a screen so most people use a transmission flush for this issue.

Mar 31, 2009 | 1994 Honda Accord

Not finding what you are looking for?
1994 Ford F250 Supercab Logo

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5467 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...