Question about 1985 Chevrolet Monte Carlo

Open Question

How to remove rear brake drums on a 1985 monte carlo

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 20 Answers

SOURCE: 1985 monte carlo determination

Check your fuel pressure. For fuel injection, it should be 9-12 p.s.i. Your fuel pump is located in the tank. You might have to install an adapter fitting to hook up a pressure gauge. This can be installed inline at the throttle body or at the fuel filter. The fuel filter is mounted on the inside of the frame rail. You might just remove the fuel filter to see if you can blow through it. If you can't blow through it, it is plugged up and that may be your problem. You will need two wrench sizes to disconnect the filter 20mm and 16mm.

Posted on Aug 20, 2008

  • 1 Answer

SOURCE: need wiring diagram for 1985

i need the wiring daigram for my power windows on my 1985 monte carlo

Posted on Sep 10, 2008

losflip
  • 94 Answers

SOURCE: 2001 monte carlo ss. Rear wheel bearings making a grinding noise

It is pretty easy, there is not much labor involved if it has anti-lock brakes in the rear you will also have to un-plug the wire harness attached to hubs.

Posted on Nov 26, 2008

  • 1 Answer

SOURCE: 1998 monte carlo brake lights

I have the same problem,it's the switch inside the turn signal assembly.Unfortunately the entire assembly switch and all has to be replaced.
Hope this helps.

Posted on Dec 01, 2008

  • 1 Answer

SOURCE: 1998 Chevrolet Monte Carlo brake lights do not

I had to replace the turn signal switch in my 1998 z34.Now everything works fine.

Posted on Sep 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

I recently replaced a rear brake line on my 85 ss monte carlo. I went to bleed the line and nothing came out. I attempted to bleed the other side and no fluid came out. When I replaced the line fluid did...


It should not be a mystery. Loosen one of the fittings on your new line to see if brake fluid is present. If so, the problem lies downstream from that point! Good luck!

Oct 23, 2014 | 1985 Chevrolet Monte Carlo

1 Answer

Bleed rear brakes on a 1979 monte carlo


It should be the same as any other car, you find the bolt on the brake pad or drum that connects the line to the system (it will look like a nipple) then loosen it,. This is a lot easier if you have another person. You have the second person push down on the brake peddle three quick times and then slowly push it in until brake fluid squirts out from the bolt. Then tighten the bolt back up and repeat for all brakes. Note: you may need to put in more brake fluid when your done and the process may need to be repeated it all the air doesn't come out of the lines.

Dec 04, 2013 | Chevrolet Cars & Trucks

1 Answer

What is the firing order and distributer rotation for a 1985 Monte Carlo 4.3L V6.


1985 Chevrolet Monte Carlo 4.3 liter V-6 VIN "7"
and
1985 Chevrolet Monte Carlo 4.3 liter V-6 VIN "Z"

zjlimited_820.gif

Hope this helps and just keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa.
Jose.

Oct 26, 2011 | 1985 Chevrolet Monte Carlo

1 Answer

How to change rotor on rear 2001 monte carlo it has a drum parking brake inside of rotor


remove caliper & make sure u wind the parkbrake shoes right back so rotor spins freely then remove any locking screws rotor should come off

Sep 11, 2011 | Chevrolet Monte Carlo Cars & Trucks

1 Answer

Need to know the torque specs for a rear wheel bearing on a 1999 monte carlo?


Hub & Bearing 3.8L engine Removal & Installation To Remove:
Hub and bearing assembly mounting 88008g39.gif

All W-body cars are equipped with sealed hub and bearing assemblies. The hub and bearing assemblies are not serviceable. If the assembly is damaged, the complete unit must be replaced.
  1. Disconnect the negative battery cable.
  2. Raise and safely support the vehicle with jackstands.
  3. Remove the rear wheel and tire assembly.
  4. If equipped with rear disc brakes, remove the caliper, bracket and rotor.
  5. If equipped with rear drum brakes, remove the brake hose bracket and drum.
  6. If equipped, detach the ABS electrical harness.
  7. Unfasten the four hub/bearing-to-knuckle attaching bolts, then remove the hub/bearing assembly.
To Install:
  1. Install the hub/bearing assembly onto the knuckle. Install the four attaching bolts and tighten to 52 ft. lbs. (70 Nm).
  2. If equipped attach the ABS electrical harness.
  3. Install the rotor, caliper and bracket or drum and bracket, as applicable.
  4. Install the wheel and tire assembly.
  5. Carefully lower the vehicle.
  6. Connect the negative battery cable.

Jul 15, 2010 | 1999 Chevrolet Monte Carlo

1 Answer

Does dash have to be removed to install heater core for 1985 monte carlo


no- to make it easier to work on heater core remove glove box takes a couple of minutes

Nov 03, 2009 | 1985 Chevrolet Monte Carlo

1 Answer

Rear brakes grinding and squealing upon start up


the rear brakes may not be adjusted properly causing them to rub on the drum take it back to the mechanic and have him adjust them so there is some slack

Oct 29, 2009 | 1997 Chevrolet Monte Carlo

1 Answer

2003 Monte Carlo new brake pads, rotors,. Braking is fine but waffles


check the rear rotors(i assume it has rear pads not drums) they probly are worped ,if not have front end checked for worn parts and allighnment

Jun 28, 2009 | 2003 Chevrolet Monte Carlo

Not finding what you are looking for?
1985 Chevrolet Monte Carlo Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...