Question about 2003 Chrysler Town & Country

1 Answer

HESITATES AND DIES..RPM GAUGE JUMPS UP AND DOWN WHILE DRIVING. WHEN GIVING THROTTLE RUNS BETTER

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

If your running a car with injectors and not a carbeurator, it could be the cars computer is messed thus its sending the wrong ratio of fuel and oxygen giving the wrong amount of throttle. .

Posted on Jun 19, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1990 Chevy Van with a 350 small block that has a mind of it's own.


Try to get it running a bit to warm up the exhaust. Take a point and shoot thermometer and take the temp of the cat. If temps exceed 400 degrees I would start to suspect a plugged cat.

Mar 05, 2017 | Chevrolet Cargo Cars & Trucks

1 Answer

99 grand am v6 runs great then dies, driving and at idle. within seconds of starting it or even after driving for 45min. rpm gauge jumps up and down and hesitates when accelerating. no engine light, ...


Autos can be frustrating! I call it ghost in the machine...After all that, I would check the pressure at the fuel rail. My mother's Volvo turbo acted similarly and it was because of a worn fuel pump that was regulated electronicly. After 2 Volvo techs spent an hour on it + test drives, they told me that my diagnosis was correct, the fuel pressure at the rail was intermittently eratic and performed normally most of the time. No problems since the replacement 2 yrs ago. Let me know if you make progress and I'll check with my neighbor who has one and drag races as a hobby...MK

Oct 02, 2010 | 1999 Pontiac Grand Am GT

1 Answer

Hyundai xg300 engine dies when cold and sputters


If you were driving a voyager I'd suspect the fuel pump is starting to fail.

Feb 14, 2010 | 2001 Hyundai XG300

1 Answer

Car accelerates without my pressing the gas


.the control sensor throttle ,look on the opposite side to the cable and a little box thingy with a wiring connection ,unless its a later vehicle then this will use a fly by wire.But i do fell this type of fault is beyond the average weekend mechanic and i would advise you to visit a dealer

Jan 09, 2010 | 2000 Ford Focus

1 Answer

1989 pontiac bonneville going on its own.


try replacing the throttle position sensor

Oct 03, 2009 | 1989 Pontiac Bonneville

1 Answer

Will start but rpm gauge jumps up and down then it dies


The problem you describe has NUMEROUS causes. Most common of these is a COIL is going bad. The RPM gauge gets its signal from the ignition coil/crank sensor circuit (could be either one OR could be the wiring between the engine control module (ECM) and the engine components. Does the Check Engine light come ON when this happens? Whenever the "Check Engine" light comes on, there is always a DTC (Diagnostic Trouble Code) stored in the ECM (Engine Control Module). You'll need an OBDII (On-Board-Diagnostics) scanner to retrieve any codes recorded/set in ECM. Once you do this and let us know what, if any codes are set, then we can go from there.

Apr 21, 2009 | 2001 Kia Optima

1 Answer

My 97 LeSABRE stalls. AT LOW SPEED AND WHEN I PUT IT INTO PARK. RPM GAUGE JUMPS UP AND DOWN VOLT LIGHT COMES ON.


The only reason the voltage light comes on is because it is stalling and the reason the rpm gauge goes up is that is races up and then dies down..Sounds either you have a vacuum leak or a fuel issue..

Mar 11, 2009 | 1997 Buick LeSabre

1 Answer

2001 Ram 318


Some of these have two temp sensors, one for the gauge, and one for the computer.

Aug 01, 2008 | 2001 Dodge Ram 1500 Truck 2WD

Not finding what you are looking for?
2003 Chrysler Town & Country Logo

284 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...