Question about 1997 Nissan.5 Altima

Open Question

No power to fuel pump

Replaced fuel pump and filter ran a little now i have no power

Posted by Anonymous on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 77 Answers

SOURCE: xterra car quit running. had no spark @

Yes, there is fuel pump relay, which is generally located on the passenger side kick panel. But in your case, the fuel pump relay on 2002 model Xterra is indeed located under the dash around the steering wheel, but no you don't need to remove the cover just lay in floor and you can see it, it will slide off a bracket and you can remove and replace it.
Good Luck!

Posted on Jan 15, 2011

johnjnail
  • 1702 Answers

SOURCE: xterra car quit running.

the fuel pump fuse is fuse #1 15amp in the inside fuse box ( left side of dash behind fuse box cover ) the fuel pump relay is behind left side of dash ------- cavity #2 & #5 at the relay should have battery voltage in start and run cavity # 3 is the power out to fuel pump and cavity #1 is the ground that is turned on by the on board commputer.

Posted on Jan 15, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I ran my car out of gas 1995 geo tracker . Ran fine for two days after . Replaced fuel filter . Fuel pump is working. Now it won't start . It try's but then dies ? Any suggestion would be appreciated


so ran fine for 2 days
id bet it didnt have only 1 gallon there.
or did you run it dry again.?
the pump is fuel lubricated and cooled
ran dry invites wrecking a good pump.

Feb 02, 2017 | Geo Cars & Trucks

1 Answer

What could cause the engine not to stay running after the fuel filter was replaced? Even after fuel pump was replaced?


From remote site, it is hard to tell what is the root cause, and change pump was done in proper order -- you should post the problem before replacing fuel pump.
Here is what I will do, assume you can do a little by yourself.
Changing fuel filter should be easy by disconnect fuel hose (pipe) from the fuel filter . Since ASE mechanic did job in your house, I assume the old fuel filter is still in your hand. Change it back (replace new filter with your older one) to see if your car will work as before. This supposed to be done before replacing the fuel pump.
If older filter works, then you knew the new filter is the root cause. This could be resolved by replacing another new filter. If the problem appear again, leave the new filter in for over night to see if the new filter will work on the next day (you could use exiting new filter to avoid buying another filter, unless you will get a different brand one). If not, the choice is to use older one for a while when trying figure why new filter does not work.

If old filter does not wok either, then something is in forwarding fuel line between fuel filter and fuel ejection system. Then, that section needs to be cleaned. Assume the pressure is measured at connection between forwarding line and fuel filter.

Oct 05, 2014 | GMC Sonoma Cars & Trucks

1 Answer

1989 f250 460 engine fuel problem


if the fuel lines have any rubber fuel lines they could be sucking air. also try replacing the fuel caps, it may not be venting

Dec 02, 2013 | 1989 Ford F 250

1 Answer

Truck lost power and died, started and wouldnt gain power to run ribbed to 800RPM and died caughed a little. replaced fuel filter same problem. Disconected filter turned key on pump ran for a second ane...


Modern fuel injected vehicles will only run the pump for a couple of seconds to pressurize the fuel system at stat-up. The pump won't run after that until the engine is running or you are actively engaging the starter. The fuel pump and relay are doing exactly what they are supposed to do. Now, that doesn't mean the pump is building pressure like it should but the pump running for a second then shutting off after you first turn on the key is normal operation. You may have entered it, but I can see no information about what vehicle you are working on other than it is a truck. More information about the vehicle would help. In the mean time, I feel a compression check is an order and you should take a look at the oil to make sure there isn't any water mixed in. Some history would help as well, like if you have done any type of service in the last month, when the basic maintainence was done, how many miles are on it, etc.

Oct 30, 2011 | 2002 Chevrolet Silverado 1500HD

1 Answer

Ran out of gas, filled with gas still won't start


most likely a clogged fuel filter, all the impuritys laying in the tank got sucked in to the filter when you ran out of gas, and with air in the fuel pump it probably does not have the power to **** the fuel trough the clogged filter, replace the filter

Jan 22, 2010 | 2000 Dodge Stratus

1 Answer

I have a 1990 Chevy Astro van that stopped running on me while I was driving it. I towed it home. I replaced the fuel pump and it ran for a little while and started running very rough. So I bought another...


You say you replaced the fuel pump, what about the filter? If the filter is clogged it can cause this as can ignition. Since the car started for you after the fuel pump was changed the original problem was the fuel pump. But you should never change the pump without installing a new filter.

Oct 18, 2009 | 1990 Chevrolet Astro Extended

1 Answer

MY 1994 5.7 1500 RUNS FOR A LITTLE BIT AND THEN SHUTS OFF,I CHANGED THE FUEL PUMP FUEL FILTER,IGNITION MODULE.IT STARTED RIGHT UP AND RAN FOR ABOUT 20MIN.I THEN SHUT IT OFF & LET IT SIT FOR 5 MIN.IT...


You could have a fuel pump getting weak or fuel pump relay. One other thing to look into is the oil press. switch malfunctioning or loose connection. The fuel pump/relay get's it's power through this on some GM vehicles. If you have a haynes manual look at it's wiring diagram to verify.

Sep 25, 2009 | 1994 Chevrolet K1500

1 Answer

Car ran out of gas. put gas in it now it wont start


The fuel lubricates the fuel pump, so if you ran completly out you may have burned out the fuel pump. First you can do a fuel pressure test, it should be 41-47 psi, if low replace filter and check again. If still low verify pump is getting power then replace. Thanks

Jun 08, 2009 | 1996 Buick Skylark

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...