Question about Cars & Trucks

1 Answer

How do u replace wire harness under dashboard in 2001 chevy tahoe all my wires were cut from fuse box on side and under dashboard

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

Feel sorry for you bud,very very big job to replace it - have to remove entire dash - probably further ahead to splice them - colour match if you can get a used harness. wow that is terrible

Posted on Apr 20, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 163 Answers

SOURCE: Replacing the horn 2001 chevy silverado

behind your grille

Posted on Sep 23, 2009

  • 432 Answers

SOURCE: 2001 Chevy Tahoe, Heated seat back works but not seat bottom.

Open drivers side door and look at the end of your dash board that is faceing the door.You will see a little triangle shaped door that pops out.There are also more under the hood,drivers side in a big square box.Behind the batterie.




























Posted on Dec 30, 2009

2coolrick
  • 560 Answers

SOURCE: Have prodigy trailer brake control Have

When installing the trailer break controller, 4 things must be considered carefully and objectively . 1.Safety regarding the mounting of the controller with respect to the drivers ability to control the vehicle without any hindrance whatsoever . 2.The dirvers ease of access (and control) of the coltroller while actually driving.....not sitting in the driveway....and lastly.... 3. The expected and assured 100% faith in the controllers ability (by the driver) to function without failure (no exceptions allowed) AND as designed to function (not ***-u-med), by properly mounting the unit and performing the correct electrical aspects of the installation without "shortcutting or jerry rigging" (no exceptions allowed)
4. The trailer brakes themselves. Ie. Shoes, drums, actuators, mechanical and electrical components etc. And last.....but too often forgotten....axle bearings maintenance / checkups / and tires condition and proper air pressure attained with a reliable tire guage....Did I mention checking the trailer lights functions ??? Good Luck...Happy Safe Motoring..

Posted on Sep 05, 2010

  • 28 Answers

SOURCE: radio harness diagram for 95 chevy tahoe....rear

check wiring on passengers side near the rear hatch speaker, the rear door speakers are run through them also. i had the same problem and it was a unplugged connector at that location

Posted on Dec 12, 2010

  • 14036 Answers

SOURCE: I have 2002 Chevy Trailblazer and the wiring

YOU CAN GO SALVAGE YARD OR DEALERSHIP.I HAVE WENT TO SALVAGE YARD BOUGHT HARNESS WITH WIRES ATTACHED.

Posted on Oct 25, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2001 chevy tahoe wont go


Did you leave the emerency brack on,do you have a safety wire or something like that under your dashboard?

Mar 12, 2013 | 2001 Chevrolet Tahoe

1 Answer

How to remove the dash board fuse box from a 2001 chevy cavilier


If I remember right (which please correct me if wrong) but the whole plastic cover should just be held in by screws or plastic push rivets. Once you remove that you should gain full access to the entire fuse bus. Just remember to disconnect the battery before doing any such work. The bus should be held on by some screws and of course the connector for the wiring harness.

Apr 28, 2012 | Cars & Trucks

2 Answers

Where is the radio fuse located at on a 2005 chevy tahoe?


There is a diagram in your fuse box showing the exact fuse location.The fuse box is visible when you open the drivers side door. It is small triangle shaped plastic cover on the side of the dashboard next to the door frame, You cant see it with the door closed. The inside of the cover has a diagram that identifies which fuse is which.Check it.Thanks.Helpmech.

Nov 12, 2010 | 2005 Chevrolet Tahoe

1 Answer

How to wire box truck for tail and brake lights?


The wire harness for the back lights comes in 2 pieces. Undo the center bolt at the fuse panel on the engine side of the firewall and pull the left side wire harness off the fuse box. That is the one that goes to the back of the truck. There is one wire in it that you will have to cut because it doesn't go all the way back. The second connector is under the box near the rear bumper on the driver's side. It runs to the lights from the first harness. It is prone to corrosion and may be your problem. If it is just cut it out and splice the wires together, using connectors and heat shrink tube. Then tape over the tubing and you should be good. Chevy tail lights are also prone to chaffing inside the box at the tail light so if you are haveing trouble check for that. Just tape them up and repostion them so they don't chafe. Also check the ground wires at the back. They very often rot off or stop making a good connection from years of road crud. The light sockets are available at any auto parts store if you need them. Hope this helps.

May 08, 2010 | 1983 Chevrolet C3500

1 Answer

2001 Chevy Tahoe, Heated seat back works but not seat bottom.


Open drivers side door and look at the end of your dash board that is faceing the door.You will see a little triangle shaped door that pops out.There are also more under the hood,drivers side in a big square box.Behind the batterie.




























Dec 30, 2009 | 2001 Chevrolet Tahoe

1 Answer

How to remove the fuse box under dashboard to left of steering column


You're walking into a hornets' nest that you want no part of. The fuse box looks simple from the front but when you pull it off the firewall it's going to get hairy. If you've never done this type of job, I wouldn't recommend starting with an '07. It gets crazy enough on "simple" hot rods. If you only need to unmount it without removing the wires you should be able to see the mounting hardware inside the box. If not then it's bolted from the engine side through the wiring harness.

Nov 25, 2009 | 2007 Chevrolet Tahoe

3 Answers

2001 PT Cruiser - blower and power windows stopped


I fixed the problem. A fuse had burned out. Find the Fuse Box under the hood and replace fuse #3.42a98338-d15c-4335-92e0-61a7348b3d95.jpg
The fuse that I purchased had a darker green color, which you can see on the below picture (Upper Row; If you start from the right, it will be the third fuse).
6788180c-8cd5-48b2-a1b6-155691da5f0b.jpg

Jun 24, 2009 | 2001 Chrysler PT Cruiser

1 Answer

Is there a huel reset on 2001 chevy tahoe


Sorry there is no fuel pump reset on the Tahoe. If you have no fuel pressure, check the fuses and relay,and wire harness to the fuel pump from the inside frame rail on the drivers side. If you can hear the fuel pump working, check the fuel pressure at the shredder valve and there should be 60 to 66 PSI, if you don't you can try checking for 12 volt at the fuel pump wire harness at the frame rail. Good luck and keep me posted, be glad to help.

Jun 06, 2009 | 2001 Chevrolet Tahoe

1 Answer

2001 tahoe will not shift from second gear


this is known as "limp mode"

there should be a fuse in the dashboard fuse panel, or possibly the one under the hood.. one will be labeled trans or tcm - something of the like...test ALL fuses in the fuse boxes for good measure, and change the fuses if you find any blown.

ALSO....

Did you recently have a remote start system installed? If so, they need to hook up the smaller white wire in the ignition harness to turn on with the ignition power from the remote start unit. If the ignition wire and the white wire (transmission control) are not powered at the same time, the trans will go into limp mode.

Dec 18, 2008 | 2001 Chevrolet Tahoe

1 Answer

Driver side power seat 2001 Chevy Tahoe


as long as nothing is stuck in track and you hear no noise when using switches, look for broken wire at connector or in harness. ck fuse first of course, if blown, something may be stuck in track causing it to stop and blowing fuse

Nov 15, 2008 | 2001 Chevrolet Tahoe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...