Question about 1995 Jeep Cherokee

Open Question

Jeep starting problems

Wont fire up no spark

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My jeep is turning over but wont start. I replaced the coil and it will occasionly spark and attemt to start only to soon die then it wont get another spark at all. How do i fix this??


Jeeps most common problem is with these particular vehicles are the crank sensors. May also have a bad reluctor. which is part of the flywheel. What you need to do first, Need to first remove the crank sensor which is on top of the bell housing. Remove it and inspect for cracks if you see any cracks replace it. and reset gap. You can use a small piece cardboard like the thickness of an oil filter box,tape it to the tip end of the sensor,and reinstall. After inspection or replacement of the sensor, start vehicle,Also keep an eye on your tachometer . Your tachometer should slightly come up when cranking. If not replace sensor.The crank sensor is a part of the ignition system, the pcm needs to see where top dead center is or where #1 cylinder is to determine when to spark, simply put. So the pcm knows when to fire.

Jul 11, 2015 | 1999 Jeep Wrangler

1 Answer

Why wont my 2011 jeep grand cherokee wont start


Okay, the possibilities are great. need to narrow it down a little.
If it fails to crank over it is likely the battery.
If it cranks over ok, but fails to start it is either lack of fuel or lack of spark.
the Quickest way to identify lack of fuel or lack of spark is to spray in a 2 second dose of starting fluid into the air intake. If it fires up then dies in this test it is lack of fuel most common suspect is fuel pump relay or fuel pump.
If it fails to fire up on the starting fluid test it is lack of spark. Electronic ignition trouble shoot procedure from your shop manual for your VIN number will be required.

Jul 05, 2014 | 2011 Jeep Grand Cherokee

1 Answer

I got a 1996 jeep grand cherokee laredo wont fire got new crank senser new pick up coil in distributor and new spark coil still wont fire what is the problem


Their is a computer chip behind the antifreeze bottle check the second wire harness play with that while someone turns the key it happend to mine the same thing and started right up

Aug 14, 2012 | 1996 Jeep Grand Cherokee

2 Answers

My 1996 jeep limited grand cherokee wont start up. It turs over, but wont start


Fuel, fire and exhaust. Pull a plugwire and check for spark. If it is firing check fuel system for pressure.

Jun 24, 2011 | 1996 Jeep Grand Cherokee

1 Answer

My 1996 jeep laredo wont fire up


check all the spark plugs, plug wires, the rotor, if it is getting fuel or not to the spark plugs, or if it is flooded then try pressing the gas pedal all the way to the floor when trying to start it, this will cut off the fuel supply and you will only fire off what is already in the engine, then let off the pedal when it is running, or if you were pressing this to the floor all the way when trying to start it the first time, then leave the pedal alone to get fuel in the engine so it will have something to fire off of.

Dec 28, 2009 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
1995 Jeep Cherokee Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...