Question about 1993 Mitsubishi Montero

Open Question

1993 mitsubishi montero fuel pump relay location

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: flasher relay

Hi

Follow this link for fuse box & relay locations for Montero/Pajero/Shogun 1995
Hope this helps it does clearly show the flasher relay.

Rob

Posted on Oct 02, 2008

Ad
mjvgamer
  • 7 Answers

SOURCE: how to change the fuel pump on a 1994 Mitsubishi Montero LS 3L V6

just for you REMOVAL & INSTALLATION
See Figures 1 and 2
WARNING In almost every case, replacing the Mitsubishi electric fuel pump requires removal of the fuel tank. Please refer to the fuel tank removal and installation procedure at the end of this section.

  1. Lift or move aside the carpet in the rear cargo area.
  2. Remove the oval cover plate from the access hole.
  3. Disconnect the fuel pump harness connector at the rear of the fuel tank.
  4. Start the engine, allowing it to run until it runs out of fuel. This relieves pressure within the fuel system.
  5. Turn the ignition switch OFF and disconnect the negative battery cable.
  6. Remove the fuel filler cap.
  7. Drain the fuel from the fuel tank into suitable container(s), each with an airtight lid.
  8. Carefully, and using two wrenches on the fittings, disconnect the high pressure fuel line and the main fuel line from the pump. Remove the high pressure fuel hose at the body-side main pipe connection, unfasten the pump-side connection. Wrap each joint in a rag before loosening; some pressure may remain within the system.
  9. Remove the fuel pump retaining nuts and carefully remove the pump from the tank.
The fuel pump may still contain liquid fuel. Drain it into a suitable container with an airtight lid before performing any tests or inspections.
To install:
  1. Carefully install the pump into the tank and install the 6 retaining nuts onto the studs. Tighten the nuts evenly and in a crisscross pattern to 12 ft. lbs. (16 Nm).
  2. Reinstall the high pressure and supply line to the pump.
WARNING Take great care when connecting the threaded high pressure lines. Start the threads by hand, then, while holding the hose side to keep it from turning, tighten the flare nut to 27 ft. lbs. (37 Nm).
  1. Connect the pump wiring harness.
  2. Connect the negative battery cable. Turn the ignition key to ON but do not start the engine. You should hear the pump running. Allow it to run for about 10 seconds to build line pressure, then start the engine.
  3. After the engine has run smoothly for a minute or two, shut the ignition off and check the work area for any trace of leakage. Attend to any fuel leaks immediately, remembering that the system has repressurized and must be handled safely.
  4. Reinstall the cover on the access hole and replace the carpet in the cargo area.
0900c152800547c3.jpgFig. 1: Components of the fuel pump and fuel tank 0900c152800547c4.jpgFig. 2: Components of the fuel pump-all models similarTESTING
When diagnosing engine problems, particularly a "no start" condition, the fuel pump function should be checked. Because of the difficulty in reaching the fuel pump connections, Mitsubishi automobiles have a conveniently located test connector under the hood. V6 Monteros have the connector taped to a wiring harness inside the right front kick panel, near the ECM and relays.
This connector bypasses all of the controls in the system (ignition switch, pump relay, etc.) and sends voltage directly to the pump. When power is applied to the pump you should be able to hear it running, although the in-tank pumps require you remove the fuel filler cap and listen at the filler.
To use the test connector, make certain the ignition is OFF. Great damage may be caused if the system is tested with the key on. Locate the test connector in the engine compartment (on later Monteros it is located under the right-hand side of the dashboard)-it is generally on a short lead out of a wiring harness and looks like a plug that isn't connected to anything. Once found, use a jumper wire to connect the test terminal to the positive battery terminal. Listen for the fuel pump; if it runs, you know the pump motor is good. While the pump is running, gently squeeze one of the fuel lines and confirm that the pump is delivering fuel pressure. If it does not run, the pump itself is most likely defective OR the connector to the pump is faulty.
When the pump is removed from the tank, it may be checked by applying battery voltage (+) to the connector and grounding the housing. Only run the pump for one or two seconds during this test; the pump can be damaged by running without liquid.
CAUTION Make certain the pump has been drained of residual fuel and is free of fuel vapors. Connecting and removing the test leads will cause sparks which can ignite any vapor in the area.

Posted on Jan 18, 2009

garputo22
  • 127 Answers

SOURCE: location of fuel pump relay on 01 montero

See attached pictures

Notes Overall View 89248255 Notes View Q 89255354

Posted on Jun 05, 2009

  • 88 Answers

SOURCE: fuel pump relay for 2000 mitsubishi mirage

most newer veichles your feul pumps in your gas tank

Posted on Aug 22, 2009

  • 192 Answers

SOURCE: WHERE IS THE FUEL PUMP RELAY LOCATED ON THE 2000

the relay is located on the left upper engine compartment. it is the first relay to the right of the fenderwell.

Posted on Oct 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 Mitsubishi Montero won't start. Replaced the starter and fuel pump and filter.


Does vehicle engine turn over. If yes, then pay attention to fuel system. Check for good power and ground at fuel pump connector. If no power check fuel pump fuse, relay and for open wires (power, ground) to fuel pump.

Feb 07, 2016 | 2002 Mitsubishi Montero Sport

1 Answer

2002 Mitsubishi Montero Sport (won't not 'want') start. Replaced the starter and fuel pump. Filter still not getting gas to the cylinders


If you already replaced fuel pump and filter and still no fuel pressure at injectors rail, your problem is more than likely electrical. Check for good power and ground at fuel pump connector. If no power at fuel pump connector, check your fuel pump fuse, relay and wiring for opens(broken) feed wire.

Feb 07, 2016 | 2002 Mitsubishi Montero Sport

1 Answer

1990 mitsubishi montero fuel pump relay is at


1991 Mitsubishi Montero fuel pump check terminal - YouTube

? 1:57
www.youtube.com/watch?v=ZrmcQHcW_1U
Jul 6, 2011 - Uploaded by jasonX223
Here is a 1991 Mitsubishi Montero. ... The fuel pump has voltage in the start position,. ... 1991 Mitsubishi Montero fuel pump check terminal .... Fuel Pump Electrical Test - Relay and Fuse check - Advance Auto Parts - Duration: ...

Oct 07, 2015 | Mitsubishi Cars & Trucks

1 Answer

Where is the fuel pump relay is located at in a mitsubishi montero 1990 V6 3500 24 valve


www.ask.com/mfg.name/make/model/year/location/fuel/pump/relay/

you can go to you local auto part store ask for help.

go to www.youtube.com/where-locate-fuel-pump-relay/
they may not have the model but similar cars or try putting the car info. in the statement question your asking.
--------------------------------------------------------------------------
it mite be on the firewall under the hood, in the fuse box area, where the fuel pump location, and inside the gas tank.

Oct 07, 2015 | Mitsubishi Cars & Trucks

1 Answer

Where is the fuel pump relay in a 1994 Mitsubishi Montero


Passenger side dash, below the a/c heater vent and to the right of the glove box door

Mar 01, 2015 | 1994 Mitsubishi Montero

1 Answer

Fuel relay


have a pressure test done on the fuel manifold as your problem may have been the regulator in the manifold.

Jun 09, 2013 | 1996 Mitsubishi Montero

2 Answers

I check all relay and don't receive direct electricity to the fuel pump and no start the car


You will never have direct electricity to fuel pump only when running then once you shut off ignition that shuts engine off fuel pump to automatically shuts off.I would change the fuel pump sit in car turn key Th start position do not crank engine if you do not hear a grrr,,,grunt sound i would say fuel pump not functioning therefore fuel pump malfunction replace.

Dec 19, 2010 | 1995 Mitsubishi Montero

Not finding what you are looking for?
1993 Mitsubishi Montero Logo

Related Topics:

195 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...