Question about 1991 Chevrolet Cavalier

Open Question

NO PULSE ON FIAT PALIO 1200 8V

THERES FUEL PRESSURE AND SPARK.JUST NO PALSE ON INJECTORSRED WARNINING INJECTOR LIGHT FLASHES ON DASH OR SHOWS ON DASH.IS IT ECU OR IS IT JUST A FAULT TO BE CLEARD

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
tripletauto
  • 1450 Answers

SOURCE: shows ABS fault on dash and ABS light stays on

Check your abs connectors they might have pulled a wire loose

Posted on Nov 11, 2008

Ad
Molson02536
  • 3854 Answers

SOURCE: 1993 s10 2.8 tbi the fuel pump fails to pressurize

There needs to be 60 PSI of fuel pressure in the system to have the fuel injectors to work. There is also a fuel pump relay on the fire wall just left to the brake booster, There is two relays there, i just can not remember which relay is which but try switching the relays with one another. Also check the fuses to the fuel pump and ECM, and the fuel pressure from the shredder valve. Good luck and keep me posted, not a bad Idea to also replace the fuel filter, and that is located at the inside frame rail under the drivers side.

Posted on Jun 03, 2009

redbeard00
  • 957 Answers

SOURCE: no power tp the fuel pump, injectors not pulsing, no fuel.

Check out your oil sending unit, fuel pump and relay, check for power (might be a fuse), the ignition control module (which if you remove it, can be tested for free at AUTO-ZONE), any related wiring, pick-up coil (inside the distributor), and possibly the ignition switch. If I can be any more help just as away.

Posted on Jun 06, 2009

  • 3 Answers

SOURCE: 2007 chevy aveo does not start, Iam getting fuel

Switch ignition relay with power window

Posted on Feb 12, 2010

  • 6 Answers

SOURCE: no injector pulse

what vehicle? injector pulse controlled by computer. the computer recieves a pulse from crank angle sensor, or distributor pick up, etc.
then controls injector pulse. Mass air flow on some vehicles determines spray pattern

Posted on Jun 29, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fiat palio 16v 2001 injector light stays on and checked every thing replaced injectors and nothing works and its very rich on fuel


Fuel mixture is nowadays controlled by the ECM and length of time injector is open. See if there is setting for this parameter

Aug 26, 2017 | Fiat Cars & Trucks

1 Answer

Truck shuts off while driving


Check the fuel pressure with a fuel pressure gauge, when the truck stops See if the fuel injectors are getting a pulse with a niod light plugged into the harness "while cranking. motor". IF you get no pulses (NO flashing noid light) see if the security light is ON, on the dash. If the security system "kicks on" it will kill the pulses to the injectors.

Jul 27, 2014 | 1999 Chevrolet Silverado 1500

1 Answer

Jurking of my fiat palio


Check fuel pressure maybe fuel pump

Nov 25, 2013 | 2005 Fiat Palio Weekend

1 Answer

Fiat palio 1.2 2003 is overfuelling after replacing 3 x injectors. petrol is seeping out of the manifold and exhaust.


Try checking fuel pressure regulator or...... Your cold start injector is pouring fuel out if fitted to that model

Oct 23, 2013 | Fiat Cars & Trucks

1 Answer

Fiat palio 1.2 16 valve does not rev up until you block the return fuel line. the fuel pump has been replaced because it was showing signs of fuel starvation. the fuel regulator was also checked and is...


Did you clean your injectors lately this sounds lick a pressure problem and injectors will not function unless they get the proper pressure or due to your former problem you may need to have a sensor reprogramed

Aug 16, 2013 | Fiat 500 Cars & Trucks

1 Answer

I have a 2003 Oldsmobile Alero 3.4L that wont start. I have done fuel pressure test 50-55 psi and plugs have good spark. However when done light test on injectors there is no response so there is no pulse....


Is the security light staying on ?
Usually the engine will not crank and you have no power to the fuel pump if the security system is disabling the car.
No injector pulse but spark would point to the computer since both use input from the crank and cam sensors.

Dec 22, 2012 | Cars & Trucks

1 Answer

My 95 buick lesabre will not start , I have change to a new fuel pump and a new cam shaft sensor. The gas is getting to the fuel rail, I have spark on all six cylinders . If i spray gas in through the mass...


Thee are a couple of things left to check. One is to hook up a fuel pressure gauge to the fuel rail and see how much pressure your getting and compare it to specs. It maybe getting fuel there but not enough pressure. To see if the injectors are being pulsed you wil need a set of noid lights. You will unplug an injector and plug in the noid light. It will flash everytime that injector is pulsed. If it never flashes your injector drivers on the ecu are bad.

Sep 20, 2010 | 1995 Buick LeSabre

Not finding what you are looking for?
1991 Chevrolet Cavalier Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...