Question about 2005 Ford F-150

Open Question

Fuse for trailer pig tail 08 ford ranger - 2005 Ford F-150

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
samson-1
  • 153 Answers

SOURCE: 2002 explorer tail light for trailer

There is a small black plastic box under the hood that contains several circut breakers. The breaker for trailer towing is located here.

Posted on Oct 09, 2008

Ad
jaysonemanme
  • 500 Answers

SOURCE: trailer light problem

sounds like something is up with the wiring on the trailor. you can also check the harness connector for the trailor, i have seen them actually corrode and short to other wires in the connector

Posted on May 20, 2009

sscullys
  • 984 Answers

SOURCE: how to factory wire fog lights on a 2000 ford

This is a common problem on 97-00 MY trucks, regardless of the trim level ( XL, XLT, Lariat ).

If you install the fog lamp fuse in the BJB ( aka Battery Junction Box, Engine Compartment fuse panel ) Fuse # 9 ( 15 A fuse ) and jumper the normally open contacts in the fog lamp relay socket ( see diagram below ) the fog lamps should illuminate ( to confirm what you have doing on ).
8491ddd.jpg
The problem usually is the main headlamp switch to the BJB is not in place ( this is the yellow wire from the main headlamp switch connector to the relay socket pin #1 ).
One easy route is to make an aux lighting relay & harness, or purchase one online. With this, you can cut the factory ends and attach them to the harness you purchased. There is an air inlet next to where the steering wheel column runs through the firewall. This would give you an easy route to the fog lamp switch. The fog lamp switch, you can buy the factory one, and change the yellow wire from the connector to your added relay, or just add a switch for this function.
This will give you an idea of what the DIY relay and harness would look like.
5954a15.jpg

Hope this helps, more than confuses at this point

Posted on Nov 13, 2009

  • 1 Answer

SOURCE: Tail lights not working

THE SOLUTION WAS THE HEADLIGHT SWITCH. IT TURNS OUT THIS IS A COMMON PROBLEM ON THIS PARTICULAR MODEL. THE BROWN WIRE USUALLY BURNS UP. CHECK ALL WIRES AND CONTACTS BEHIND HEADLIGHT SWITCH. TO PULL SWITCH, THERE IS A RELEASE BUTTON ON THE BACK SIDE OF THE SWITCH. PRESS THAT BUTTON AND IT WILL REALES THE PLUNGER. PULL THE PLUNGER ALL THE WAY OUT AND YOU WILL BE ABLE TO PULL THE HEADLIGHT SWICH OUT. i JUST REPAIRED BROWN WIRE AND CLEANED CONTACT. VOILA.. RUNNING LIGHTS ARE NOW ON. THAT RELEASE BUTTON ON THE SWITCH IS A BOOG TO GET TO THO. GOOD LUCK

Posted on Jan 24, 2010

gandergmm
  • 145 Answers

SOURCE: fuse diagram for 2000 v6 3.0 ford ranger

http://www.fleet.ford.com/maintenance/owners_manuals/default.asp

Posted on May 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1994 Mazda B4000 abs light flashes 16 times, dash light does not work, and tail lights do not work. No blown fuses for the lights. Unhooked trailer wire harness.


93 ranger 2wd xl abs light blinking 16 times and rear brake light fuse blows when lights on and u hit the breaks but if the lights are off and u hit the brakes it fine i just installed today also the plug and play trailer harness but i didnt think that has anything to do with it.

i drive a 1994 ford ranger 2wd reg cab 4 cyl 2.3

Jan 03, 2017 | Mazda Cars & Trucks

1 Answer

Trailer Lights, I have a polarity problem. The LED tail lights on my trailer only work if I reverse the plug-in, any idea on how to fix this polarity problem.


Possibly the person that borrowed your trailer changed some of the wires. Old-type bulbs don't care about polarity, but LEDs do.

Oct 18, 2015 | Cars & Trucks

1 Answer

Changed fuses fow tow connector. #3 and # 7. Now the left trailer light,signal, brake,etc works while only right tail light on trailer still works. On right side, the tail works, but not the brake,or...


I would recommend taking out the tail light. Get a test light, have an assantant step on brake. U will see the bulb in tailamp light up. Probe the wire w/your test lamp. That is brake wire. Repeat that process for blinker.. Drop down those two wires. Hook that to the same side on trailor. Repeat for left and you should be all set.

Dec 13, 2014 | Cars & Trucks

1 Answer

My headlight want wor.k on my 87 ford ranger


Try checking the pig tail connector wiring with a 12V electrical tester. Look for missing pin connectors due to corrosion will have a light green color in the connectors if they are corroded.

Feb 27, 2013 | 1987 Ford Ranger

1 Answer

System is not charging. Have replaced Altrenator and Starter. Both tested bad at parts store. Charging was intermittent at first but now not charging at all. With Engine running, remove Neg battery...


You need to check the pig tail that plugs to the rear of the alternator it could be burnt Ford had several problems with these pig tails .Thanks Klay

Sep 22, 2011 | 1994 Ford Ranger Supercab

4 Answers

F150 Ford 1998 is there a fuse for a trailer and where is it located? Thank you


There are a few fuses for the trailer tow adapter.

1st, is theodd location on the 97-98, engine mini fuse panel has a 20 A fuse forthe stop / turn lamps. Have seen it covered in tape from the factory onsome 97-98 MY trucks.
This is on page 142 in the owners 1997 manual, all the revisions for the 1998 owners manual I have seen do not include this fuse box for some reason.

Download a PDF version from Ford, for the 1997 MY at :

https://www.fleet.ford.com/maintenance/owners_manuals/default.asp

This is a picture of the Power Distribution Box, additional relay box and engine mini fuse panel with the covers off. The 20A in the upper right panel with the red base, is the trailer stop/turn fuse.
3b8aa6c.jpg

The others :
1. Power Distribution Panel / engine compartment fuse panel
Fuse #1 - Trailer tow back-up and tail lamps
Fuse #16 - Trailer tow battery charge and stop/turn lamps
Fuse #28 - Trailer tow electronic brake

2. Instrument Panel Fuses ( cab fuse panel by hood release )
#23 - trailer tow battery charge relay

Nov 11, 2009 | 1998 Ford F150 Regular Cab

1 Answer

Trailer lights will not come on


IT SOUNDS LIKE PROBLEM IS WITH TRAILER WIRING,NOT THE TRUCK..IF NOT BLOWING FUSE UNTIL YOU PLUG IN TRAILER,CHECK TRAILER WIRING FOR SHORTS IN WIRING,CHECK FOR CORRODED LIGHT SOCKETS,BAD GROUND CONNECTIONS..LET ME KNOW WHAT YOU FIND

Jul 27, 2009 | 2008 Dodge Ram Pickup 1500

1 Answer

1996 Ford Ranger No Tail lights. I have brake lights, but no Tail. I changed the bulbs, checked the fuses, nothing.


If you happen to have a trailer wiring adapter plugged into the harness, remove it first and see if they start working. I've more than one of those mess up the rear lights. If you have the three-bulb tail lights, use a test light to see if there is power to the tail bulb sockets. If there isn't, replace that fuse just to be sure, then trace back the harness to find the break in the wiring.

May 04, 2009 | 1996 Ford Ranger SuperCab

Not finding what you are looking for?
2005 Ford F-150 Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...