Question about 2000 Hyundai Accent
I have the car in a neutral position with the emergency brake on
You know the instruction how to open the hood is under the hood :)
Grab a pliers and pull on the cable to open the hood
inspect the battery terminals for good connections and make sure the battery is fully charge. jump start and using a volt meter check for good charge from alternator 13.5V-14.2V
post more information to get more help
Posted on Apr 21, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Next time just disconnect the battery until you get it towed as this is a warranty item. I'll bet some wondered if this was a prank question like I did, right?
Posted on Nov 22, 2008
there is a tsb for the brake switch in 06 sonatas. it must be adjusted or replaced by dealership. is your check engine light on, if so its probably code p0504
Posted on Jun 29, 2008
SOURCE: 3rd brake light
This is how i did it on my 2006 Sonata
1.) unplug the connector in the trunk (its a small white plug running up to the third light, there should be a small clip you squeeze).
2.) remove the 2 gold-colored screws from inside the trunk. They can be seen from the trunk. 1 is thru the larger square opening where the wire connects to the 3rd brake light. The 2nd is on the right side thru a small (screwdriver width) hole covered by a piece of foam tape stuff I had to punch me screwdriver through the foam to get to it.
3.) after removing the 2 screws, go inside the cabin and the brake light housing pops up.
4.) disconnect the bulb from the housing while inside the cabin (I had to do this with me two forefingers since the housing only pops up and inch or two).
5.) in the trunk remove the wire and bulb. (it's about 5 inches long. the wire from the connector to the bulb socket)
6.) reverse steps to install.
It is a pain and reqiuires a bit of time only because there isn't a lot of room to move around, but it beats taking it to the dealershio!
Posted on Oct 29, 2008
Tips for a great answer:
Dec 15, 2013 | 2005 Hyundai Sonata
Nov 30, 2013 | 2006 Hyundai Sonata
Feb 09, 2010 | 2006 Hyundai Sonata
Aug 31, 2009 | 2006 Hyundai Sonata
Nov 17, 2008 | 2006 Hyundai Sonata
102 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: