Question about 1999 Toyota Celica

Open Question

Toyota celica convertible top

Where is the hydraulic fluid reservoir for the convertible top located

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1861 Answers

SOURCE: HYDRAULIC PUMP FOR CONVERTIBLE TOP

Call PRECISION FLUID POWER Inc.

1-800-728-5168

They might be able to help you.

Posted on Sep 24, 2008

  • 1 Answer

SOURCE: 1985 convertible celica fuse location

Check the harness connections located inside r-rear trunk panel. You will find power top motor & wire harness there.

Posted on Nov 03, 2008

  • 1861 Answers

SOURCE: 1999 Toyota Celica GT Convertible - Top not working

I sent you the .pdf this morning. Thanks for choosing FixYa!

Posted on Nov 04, 2008

  • 1861 Answers

SOURCE: I have a 91 Toyota 4X4 truck. the clutch is

There is a small "master cylinder", forthe clutch, located on the driver side of the engine compartment, below the master cylinder.

Posted on May 06, 2009

  • 5 Answers

SOURCE: My 99 toyota Celica convertible top does not

My '95 Toyota Celica has a switch in the trunk (behind a square pull out tab). The switch says "Manual" on it. I have the switch set on manual and then raise the top with the little handle in the center. But be gentle with it. The top has cast aluminum parts that can break if you pull too hard and force it. I'm guessing your '99 Celica has an identical setup.

Posted on Nov 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 Celica convertible soft top goes down but not back up?


Google search. Enter vehicle details and problem.

Nov 16, 2014 | 1996 Toyota Celica

1 Answer

How to check for convertible top fluid


The Convertible top hydraulic pump and fluid reservoir are located in the driver side of the trunk area, behind the side trim panel.

Jun 17, 2014 | 1999 BMW 325

1 Answer

The clutch in my 1998 Toyota celica has been slipping lately and I need to replace it. I was wondering if the clutch is hydraulic and what kind of tools I would need to replace it.


Most Toyota cars are hydraulic. To be sure you should see a fluid reservoir at the driver's side near the brake master. For getting the clutch out you need your set of wrenches, cross wrench to remove the wheels, jack and replacement parts.

Apr 17, 2011 | 1998 Toyota Celica

2 Answers

1996 audi cabriolet 2.8 V6 convertible top motor needs fluid how do i add the fluid to the convertible top motor?! and what type of fluid does it need?


Almost all power convertible tops are electric over hydraulic. The ecectric motor runs a hydraulic pump. The pump pushes fluid to the cylinders that work the top. Most are located behind the rear seat backrest. Either remove the rear backrest or access the motor/pump from the trunl. It will be shaped like a cylinder. At one is the electric motor, at the other end is the hydraulic reservoir. At the end of the reservoir is a rubber plug. With the top down, remove the plug and fill it with tran fluid till it over flows. replace the plug and cycle the top up and down as far as it will go. Repeat the process till it will take no more fluid. A turkey baster with a piece of vacuum line makes a good filler tool. With that said, you must find the leak. You may have a leaking pump, hydraulic line or cylinder. RNever replace one line. Do them all. Always replace cylinders in pairs.

Good luck, Karl at aoksales.com

Jan 20, 2011 | 1996 Audi Cabriolet

1 Answer

How do u bleed the clutch on a 1985 toyota celica


See instructions below from autozone.com. If the clutch still has air after following this procedure, try back bleeding by pushing the slave piston in while the bleeder is open, then closing bleeder before releasing the piston. This is similar to bench bleeding the slave, in case you didn't do that before the installation.


HYDRAULIC SYSTEM BLEEDING This operation must be performed any time the clutch master or slave cylinder has been removed or if any of the hydraulic lines have been opened.

WARNING Do not spill brake fluid on the bodywork of the vehicle; it will destroy the paint. If fluid is spilled, immediately wash the surface with plenty of clean water.

  1. Fill the master cylinder reservoir with brake fluid.
  2. Remove the cap on the bleeder screw on the clutch slave cylinder. Install a clear vinyl hose on the fitting; place the other end submerged in a clear glass jar partially filled with brake fluid.
  3. Have an assistant pump the clutch pedal slowly several times. After several pumps, hold the pedal down and open the bleeder, allowing fluid to flow into the jar. Close the bleeder valve almost immediately after opening it. Release the pedal only after the bleeder is closed.
  4. Repeat the process until the fluid in the hose contains no air bubbles. tube. When there are no more air bubbles in the system, tighten the plug fully with the pedal depressed. Replace the plastic cap.
  5. Fill the clutch master cylinder reservoir to the correct level with brake fluid.
  6. Check the system for leaks.

Nov 02, 2010 | 1985 Toyota Celica Supra

1 Answer

I m having problems with the convertible top . you could hear the motor runing on it but the top does not go up or down please help


the hydraulic fluid may be low. the pump is located in the right side of luggage compartment. it has a plastic fluid reservoir which often has hair line cracks near the mounting screws. fluid seeps through cracks. reservoir needs to be replaced.

May 26, 2010 | 1994 Audi Cabriolet

1 Answer

My 99 Celica convertible top started closing about 1-2 inches short of where it did yesterday. Seems like something must of gotten bent or something is now in the way. Instead of just closing the two...


The latches are adjustable.
The top will not come all of the way forward because you may below on fluid.
Behind the rear seat is your motor/pump/reservoir combination.
With the top down, fill the reservoir to overflowing with ATF.
Cycle the system a few times and repeat.
Do this till the reservoir will take no more fluid.
Check the lines and cylinders for leaks. The fluid must be going somewhere.
If you replace any lines or cylinders, always do them in pairs.
Karl at Topgunwon.com

Mar 19, 2009 | 1998 Toyota Celica

1 Answer

HYDRAULIC PUMP FOR CONVERTIBLE TOP


Call PRECISION FLUID POWER Inc.

1-800-728-5168

They might be able to help you.

Sep 24, 2008 | 1987 Toyota Celica

1 Answer

1985 convertible celica fuse location


Check the harness connections located inside r-rear trunk panel. You will find power top motor & wire harness there.

Jul 12, 2008 | 1985 Toyota Celica

Not finding what you are looking for?
1999 Toyota Celica Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...