Question about 2002 Kia Sedona

Open Question

How to adjust kia rondo parking brake - 2002 Kia Sedona

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
MNfisherman
  • 11896 Answers

SOURCE: parking brake for 2002 kia sportage

The park brake is the same on all vehicles. Usually on the driver side when you follow the cable, there will be an adjuster in the middle of the line. Turn to the right to tighten and left to loosten.

Posted on Apr 14, 2009

Ad
motor1258
  • 6674 Answers

SOURCE: not holding on slopes

Take a look underneath for cable running to each rear wheel & then come together at one cable going forward. Adjustment should be in that "Y" area.

Posted on May 10, 2009

techbuster
  • 5081 Answers

SOURCE: How do you adjust parking brake On A Kia Sedona

Underneath your vehicle, a steel threaded cable comes from the back of one hub and is joined by a short cable from the other hub--then the original cable runs to a threaded end with an adjuster nut in it--and one smaller nut on the end outside of that--(this is the equalizer bar)--you'll see it real close to your transmission.
You might have to jack-up the back of the vehicle???
Pull the parking brake lever up sharply and then release it.
Pull the parking brake lever to the second click and leave it there. You're looking for a slight drag of the brake shoes when you spin the wheels.
To increase the drag, get under at the equalizer bar and turn the adjusting nut to take up the slack in the cables. Get out and spin the rear wheels if you think it's to tight.
I will say don't be afraid to crank on it for a while as in this case, a little adjustment really does not go a long way. When you think you have the drag right, go back in the car and pull the brake up the the fourth click. At this point the wheels should be locked and you should not be able to turn them even when trying hard. If you can, tighten them up a little more.
Once you've done this, release the brake and make sure the wheels spin freely. If they are still binding due to the parking brake, back off the adjustment a little. And that's basically the whole adjustment procedure.

Posted on Sep 28, 2009

  • 77 Answers

SOURCE: adjusting kia sedona rear brakes

I think if the self adjusters are working properly you should be able to push the parking brake pedal (e-brake) to the floor once and release pedal. .

Posted on Jan 30, 2010

  • 5 Answers

SOURCE: The ESC off button of my kia rondo activates when

Rodos have an issue with the brake light switch which might cause the ESC light to turn on. Have the ABS system scanned, and if your car is still under warranty, then get the brake lights switch replaced.

Posted on Feb 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

08 kia carens/rondo I need instructions on installing breaks & rotors


Check this video out and be ready to jot a few notes. It's really well done. Good luck! https://www.youtube.com/watch?v=Cf24kUP7BPc How To Replace Front And Rear Brakes On Kia Rondo

Jul 04, 2017 | Kia Cars & Trucks

1 Answer

Kia rondo stuck in neutral


You have a bad brake switch or it is not adjusted properly. there is a recall on those.

Dec 22, 2012 | 2007 Kia Rondo LX V6

1 Answer

How do I replace a brake light switch on my 2007 kia rondo?


It's located on the brake pedal. you'll need a 14mm wrench. There are 2 14mm nuts that sandwich the switch to the bracket. take the bottom nut off and the switch will come off. Install reverse of removal but you need to adjust the switch depth once its on the bracket. then snug the bottom nut and plug in the switch.

Aug 06, 2012 | 2007 Kia Rondo LX V6

1 Answer

Kia Sedona 2008 - Parking Brake has no reserve travel


if it has rear drum brakes then yes the adjustment would be made by adjusting the shoes out tighter to the drum

Aug 04, 2012 | Kia Sedona Cars & Trucks

1 Answer

I have headlights and running lites, press brake pedal, no brake lites


Pull on your parking lights to see if they come on in the back.If the parking lights work and you still don't have brake lights then I would try replacing the brake switch and check all of your fuses just to eliminate any question of it being a fuse.The brake switch is located under the dash attached to the brake pedal.Also check the bulbs to also eliminate them.it sounds like your brake switch is bad.

Mar 13, 2011 | 2007 Kia Rondo LX V6

1 Answer

The ESC off button of my kia rondo activates when brake pedal is pressed.


Rodos have an issue with the brake light switch which might cause the ESC light to turn on. Have the ABS system scanned, and if your car is still under warranty, then get the brake lights switch replaced.

Jan 28, 2010 | 2006 Kia Rondo

1 Answer

How do i adjust e brake on 2006 kia rio


The Kia Rios (assuming yours is equipped with rear disc brakes) utilize a system that incorporates the parking brake into the rear calipers. What this means is there really isn't a way to adjust the brake itself, since it is part of your rear service brake. If you really wanted to you could adjust the cable at the parking brake lever. This would more than likely require removing your center console to get to it. The problem is if you over adjust, you will cause constant contact between the rear pads and the disc, causing premature padwear. You really shouldn't ever need to adjust the parking brake, but if your really wanted to, that would be how to do it.

Jan 14, 2010 | 2006 Kia Rio

2 Answers

Parking brake on my 01 kia rio(standard) no longer holds


parking brakes are adjusted at and with the rear brakes,..(drum brakes that is),.....as you adjust the rear brakes to have a slight drag as you spin tire, the parking brake is adjusted at the same time,...they work together with that one adjuster,....as you pull on the parking brake, it makes the brake shoes spread apart just as they do when you push the brake peddle,..by adjusting the rears you'll also find that the brake peddle feels better too.

Jan 06, 2010 | 2001 Kia Rio

1 Answer

Parking brake for 2002 kia sportage


The park brake is the same on all vehicles. Usually on the driver side when you follow the cable, there will be an adjuster in the middle of the line. Turn to the right to tighten and left to loosten.

Apr 14, 2009 | 2002 Kia Sportage

Not finding what you are looking for?
2002 Kia Sedona Logo

Related Topics:

241 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76848 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...