Question about 2006 Saturn Vue

Open Question

Removing panel under steering wheel - 2006 Saturn Vue

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is body computer


Under the dash , steering wheel side, The panel right under steering wheel has to be taken off, two screws an two clips . The end of the dash has to be taken off first ! There are three connectors going to the BCM .
Removal Procedure

showgif.do?image=348724

tif.gif
  1. Remove the IP cluster trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
  2. Move the IP extension rearwards. Refer to Instrument Panel Extension Replacement .
    showgif.do?image=348714
  3. tif.gif
  4. Remove the knee bolster screws.
  5. Unsnap the top of the knee bolster from the IP assembly

Jan 14, 2015 | 2002 GMC Yukon Denali

1 Answer

Kia sorento 2005 ignition switch how to replace?


steering wheel needs to come off and switch must be in accessory position to remove and install.mounting clip is under steering wheel.

Mar 19, 2014 | 2005 Kia Sorento

1 Answer

How do I remove left turn signal switch on 2002 silverado


if your bulbs are fine check connections at base of steering column it would be unusual for the switch to be bad this is a multifubction switch it controls not only turns but wipers bright dim controls washers ect if it is bad you'll need to disarm the air bag remove steering wheel remove access panel under steering wheel remove possibly remove pressure plate under the steering wheel if torq bolts aren't visible there will be three unbolt harness at block connector it bolts together remove two flat connectors for block connector rought wires through column then repeat process on reassembly

Jul 04, 2012 | 2002 Chevrolet Silverado 1500

1 Answer

How do i change the ignition cylinder if I have no key


Align the steering wheel so the tires are straight and then remove the ignition key from the Saturn.

  • 2 Remove the lower right side console trim panel to reveal the fuse box panel. The trim panel simply pulls off with a sharp tug. Locate the supplemental inflatable restraint (SIR, or air bag) fuse and then remove it with the fuse puller. Refer to the repair manual for the fuse schematics, if necessary.
  • 3 Open the hood and then disconnect the negative battery terminal from the battery, using a ratchet and socket. Isolate the cable so the terminal does not come into contact with the battery post during the repair.
  • 4 Loosen the four SIR retaining fasteners located behind the air bag module at the rear of the steering wheel using a ratchet and socket.
  • 5 Remove the inflator module away from the steering wheel carefully. Disconnect the connector position assurance (CPA) device from the module. Disconnect the yellow SIR connector at the base of the steering column. Unplug the wire harness from the module and then place the module in a safe place away from your work space with the trim panel facing up.
  • 6 Pry off the upper instrument panel retaining caps with a slotted screwdriver and then remove the trim panel retaining screws. Lift the trim panel upward to disengage the rear retaining clips. Disengage the front trim panel clips by lifting upward at each front corner. Remove the trim panel from the vehicle.
  • 7 Disconnect the CPA device from the passenger-side air bag module and then disconnect the yellow SIR wire from the wire harness pigtail located under the passenger-side dashboard.
  • 8 Disconnect the wire harnesses for the horn and cruise control (if equipped) from the base of the steering wheel. Remove the retaining clip at the center of the steering wheel (if equipped) and then remove the mounting nut beneath it. Pay attention to the alignment of the steering wheel locating notch for reassembly.
  • 9 Apply the steering wheel puller to the steering wheel and tighten the center nut of the puller to draw the steering wheel off the column slowly. Tape the SIR coil into position to prevent accidental coil damage from occurring.
  • 10 Remove the two retaining screws and then the upper steering column cover. Pry off the ignition lock bezel and then remove the two lower retaining screws and the lower steering column cover.
  • 11 Remove the SIR coil from the combination module. Disconnect the CPA device and the wires from the combination switch. Remove the combination switch retaining bolts and then remove the switch from the steering column assembly. If necessary, remove the instrument panel trim covers and center console trim to access the switch fasteners for removal.
  • 12 Disconnect the ignition switch connector and then remove the two ignition switch retaining screws. Disconnect the switch from the ignition module and then remove it from the steering column.
  • 13 Reverse the procedure to reinstall the new replacement ignition switch.
  • Nov 04, 2011 | 2001 Saturn SL

    1 Answer

    Need to locate flasher relay on a 2001 jeep cherokee so I can replace it. Whereis it?


    it is to the left of steering wheel, behind lower dash panel remove panel under steering wheel to remove old flasher. if you have any problems. call any auto parts store and they should be able to help. have a good holiday !!

    Dec 20, 2010 | 2001 Jeep Cherokee

    1 Answer

    How to remove a 1963 chevrolet impala steering wheel


    1. Disconnect the battery ground cable. Disconnect the chassis wiring harness from the steering column harness at the connector under the instrument panel.
    2. Remove the horn button cap or the center ornament and retainer. Withdraw the three screws from the receiving cup.
    3. Remove the receiving cup, belleville spring, bushing, and pivot ring.
    4. Remove the retaining circlip with a suitable pair of pliers, if applicable.
    5. Remove the steering wheel nut and washer.
    6. Using a steering wheel puller, carefully remove the steering wheel.
    7. Install the steering wheel using the reverse of the procedure above. Before installing the steering wheel, be sure that the directional signal control assembly is in the neutral position.
    I have pics but too many to post. What is your email and I can send them to you.

    Sep 13, 2010 | Chevrolet Impala Cars & Trucks

    1 Answer

    Does stering wheel have to be removed to install new dimmer switch? on a 1997 lincoln town car


    No. The steering wheel does not need to be removed to replace the dimmer switch. Remove the screws under steering column and remove the upper and lower panels.

    May 27, 2010 | 1997 Lincoln Town Car

    1 Answer

    1991 buick regal, i need instructions on how to replace a ignition switch


    key switch,remove center cap and pull steering wheel off with wheel puller.disconect horn,blinkers assembly.push pin remove ignition. ignition switch, remove panel under dash un bolt steering colum lower to seat un screw ignition from top steering colum un hook rod,un plug harnees put new one on put back together

    Feb 02, 2010 | Buick Regal Cars & Trucks

    1 Answer

    How do you replace the lamp in the instrument panel on a Toyota 2000 4 runner


    hi....
    Its not a quick job. You need to remove the instrument panel. Once removed the bulbs simple twice a quarter turn and you can replace them. removing the instrument panel varies on different cars, often you can do it without removing the steering wheel. You would normally take off the plastic under the steering wheel. lower the steering wheel as far as it will go. there should then be screws holding in the plastic around the instrument panel.

    Jul 03, 2009 | 2000 Toyota 4Runner

    1 Answer

    How to replace 1997 Toyota Camry dashboard lights?


    Not a quick job. You need to remove the instrument panel. once removed the bulbs simple twice a quater turn and you can replace them. removing the instrument panel varies on different cars, often you can do it without removing the steering wheel. You would normally take off the plastic under the steering wheel. lower the steering wheel as far as it will go. there should then be screws holding in the plastic around the instrument panel.

    Jun 15, 2009 | 1997 Toyota Camry

    Not finding what you are looking for?
    2006 Saturn Vue Logo

    Related Topics:

    16 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Saturn Experts

    yadayada
    yadayada

    Level 3 Expert

    76109 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8269 Answers

    Are you a Saturn Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...