Question about 2006 Toyota Sequoia

Open Question

HOW TO CHANGE TRANSMISSION OIL ON TOYOTA SEQUOIA 2006

HOW TO CHANGE TRANSMISSION OIL

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: how to reset 2006 toyota sequoia after change oil

Previous Post dead wrong...

Turn ignition to "ON" position. Make sure odometer is on trip setting not on total vehicle mileage setting.

Turn ignition OFF

Push and hold odometer button while turning ignition to "ON" position. HOld for about 4-5 seconds until maintenance light goes off. Turn ignition OFF. Start up vehicle. There should be no more maintanence light.

Posted on Jun 27, 2009

Ad
  • 8 Answers

SOURCE: how do i change spark plugs on a toyota seqoiua

You need to remove the coil packs that are located above the valve cover. It is important to get the correct spark plugs from toyota. Aftermarket plugs are not recommended.

Posted on Jan 11, 2010

  • 6 Answers

SOURCE: reset the service indicator light - 06 Toyota Sequoia

set the mileage when the odometer is showing. put the key to off position. press and hold the reset button then turn the key to on position, do not start. then continue holding the reset button until the reading stops to zero or blank. turn it off, that should reset the light indicator

Posted on Feb 21, 2010

Testimonial: "thanks for the help! it worked like a charm. appreciate it! "

  • 2 Answers

SOURCE: how many quarts of oil we need in toyota sequoia

6.5 Qts. Use 5w/30 motor oil

Posted on Nov 01, 2010

  • 1252 Answers

SOURCE: IS THERE A FILL PLUG

Here's what i found on your Toyota.....michael_cass_169.jpgmichael_cass_170.jpgHope this helps you ??

Posted on Jun 23, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Remove rear door panel 2006 toyota sequoia


here is a video,hope it helps

https://www.youtube.com/watch?v=ht2GD4GvJ_c

Mar 04, 2015 | 2006 Toyota Sequoia

1 Answer

I have a 2006 toyota sequoia, while driving the A/T Oil Temp come ON.


This is an indication that the transmission is not in OD. run fault codes to see if the servo/ solenoid is operational. Check oil level . Have a tranny pressure test done to determine if there are internal problems . Replace the oil and clean the filter . have the bands and clutch packs adjusted . Lastly as most transmission coolers are in the radiator check the engine operating temperature as it may be close to overheat.

Mar 16, 2014 | Toyota Sequoia Cars & Trucks

1 Answer

Change transmission fluid


This car does not have a drain plug, you must remove the pan on the transmission.

Jul 04, 2012 | 2006 Toyota Sequoia

1 Answer

IS THERE A FILL PLUG ON A 2006 TOYOTA SEQUOIA TRANSMISSION, 4.7L V8?


Here's what i found on your Toyota.....michael_cass_169.jpgmichael_cass_170.jpgHope this helps you ??

Jun 23, 2011 | 2006 Toyota Sequoia

1 Answer

How many quarts needed for 2004 toyota automatic


Transmission 2.1qts

Front diff 1.2qts takes 75w-90 Hypoid gear oil
Rear diff 3.9 qts of 75w-90 synthetic oil

Transfer case 1.3 qts of a Hypoid gear oil API GL-4 or GL-5

Jul 02, 2010 | 2003 Toyota Sequoia

1 Answer

Reset the service indicator light - 06 Toyota Sequoia


set the mileage when the odometer is showing. put the key to off position. press and hold the reset button then turn the key to on position, do not start. then continue holding the reset button until the reading stops to zero or blank. turn it off, that should reset the light indicator

Feb 20, 2010 | 2006 Toyota Sequoia

1 Answer

How do i change spark plugs on a toyota seqoiua


You need to remove the coil packs that are located above the valve cover. It is important to get the correct spark plugs from toyota. Aftermarket plugs are not recommended.

Oct 24, 2009 | 2006 Toyota Sequoia

2 Answers

How to reset 2006 toyota sequoia after change oil


Previous Post dead wrong...

Turn ignition to "ON" position. Make sure odometer is on trip setting not on total vehicle mileage setting.

Turn ignition OFF

Push and hold odometer button while turning ignition to "ON" position. HOld for about 4-5 seconds until maintenance light goes off. Turn ignition OFF. Start up vehicle. There should be no more maintanence light.

Apr 18, 2009 | Toyota Sequoia Cars & Trucks

Not finding what you are looking for?
2006 Toyota Sequoia Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...