Question about Chrysler Cars & Trucks
You probably have a broken brake line. Do you see where it leaking from?
Posted on Apr 19, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
have one person in the blazer pumping the brake pedal and then hold to the floor, crack the bleeder then tighten, release pedal, repeat till all air is out one side at a time, if this does not work then your ABS unit is bad witch if u follow your lines from your master cylinder u will find a black box with a motor on it, or the master cylinder itself is bad, it also can cause u to have no pedal, replace the master cylinder first, most likely cheaper.
Posted on Mar 11, 2009
you should be looking for the drivers side wheel (brake) cylinder it is inside the drum with the brakes at the top usually, look at the cylinder on each end there is a small black rubber cap, pull it back a little in one spot and see if brake fluid runs out, if so replace it. Also possible that the brake line is leaking, so check it out too.
Posted on Mar 23, 2009
Make sure all the caliper slides are free from rust and make sure they are lubed. It sounds like the caliper isn't floating on the bracket.
Posted on Aug 02, 2009
computer does that, or you have to have enough brake fluid preasure also, check for leaking lines (brake lines). make sure fluid is full.abs system has dump valves , if there was a problem abs light would be on. but abs might lite if not enough preasure hope this helps.
Posted on Oct 10, 2009
i will tell you right off this is a job for a qualified mechanic,the axle has to be pulled off first you jack up that wheel dismantle the brakes and rotor and behind the axle hub are four bolts that hold on the axle remove them and axle will come off the rear end cover does not have to come off and the axle fluid also does not have to come out,but now that axle is out you will notice that a wheel bearing is holding the seal in place this is pressed in you can buy these as a set at the dealer but must be removed by a pro. as not to harm axle and it has to be pressed back in
Posted on Feb 06, 2010
Tips for a great answer:
May 21, 2011 | 2000 Chevrolet Blazer
Jan 11, 2011 | 1984 Chevrolet Blazer
Dec 31, 2010 | Pontiac Vibe Cars & Trucks
Nov 12, 2010 | 1992 Chevrolet S-10 Blazer
Sep 09, 2010 | 1996 Chevrolet Blazer
Jan 15, 2010 | 2001 Isuzu VehiCROSS
Dec 06, 2009 | 1991 Chevrolet C1500
Jun 28, 2009 | 2001 Kia Sportage
Apr 12, 2009 | 2000 Chevrolet Silverado 1500
Nov 15, 2017 | Chrysler Cars & Trucks
26 people viewed this question
Usually answered in minutes!