Question about 1996 Jeep Grand Cherokee

1 Answer

No voltage from fuse box to gas pump - 1996 Jeep Grand Cherokee

Posted by on

  • alf0frances
    alf0frances Apr 19, 2014

    Hi Dee Reinbolt, I want to help you with your problem, but I need more information from you. Can you please add details in the comment box? What fuel / multi fuel/ high pressure side or tank lift pump what engine

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

It is likely supplied through a relay and not direct from the fuse box as fuel pumps are controlled by the engine management ECU via a relay

Posted on Apr 19, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1999 Chevy Venture van I ran out of gas and now it won't start I don't hear the fuel pump running so I was wondering is there a emergency shutoff switch to the pump


There is no shut-off switch. Check the fuel pump fuse in the under hood fuse block. Also check for voltage on the fuse circuit, hot all the time. At the fuel pump connector, gray wire is voltage, solid black wire is ground. Have a helper crank it while you check for good voltage and ground at the connector.

Aug 09, 2015 | Cars & Trucks

2 Answers

1988 Pont. Bonn.3.8 replaced fuel pump, relay, and replaced blown fuse behind glove box still pump doesn't work. Gas gauge is pegged on full does this mean anything


Did you check proper voltage and ground at fuel pump connector before replacing anything? Check with engine cranking. The gray wire is fuel pump voltage. The black wire is ground.

Did you check the proper fuse for voltage. Use a test light to check voltage.

Did you check for applicable trouble codes? Your obd1, you should be able to check some codes, yourself, if there are any?

Jul 12, 2015 | Cars & Trucks

1 Answer

Not getting gas


Most fuel pump fuses will be five amp or smaller if the fuses are good could be a ground or bad fuel pump or relay and in some cases could be the brain box or ECM box

Mar 08, 2014 | 1996 Ford Explorer

2 Answers

I am not getting gas or spark


The fuel pump and coil are on two different circuits.
The fuel pump is on the 20amp ECM fuse and the coil, ignition module, and injectors are on a 20amp fuse #10. But the ECM fuse could keep the coil and injectors from working.
You would need to test the fuses in the box in the engine compartment, and the fuel pump relay and coil for voltage and ground. The pump relay is grounded by the computer for 3 seconds when the engine is cranked.

Sep 16, 2012 | 1996 Chevrolet Blazer

1 Answer

No voltage to electric fuel pump relay?


voltage comes from fuse box, should have a fuel pump fuse, check for blown fuse, if not try jumping a fused wire from 12 volts to relay and see if fuel pump runs, hope this helps ?

Sep 03, 2012 | 2002 Kia Sportage

4 Answers

1998 gmc jimmie 4.3, 2 wd. wont start. getting no gas at the fuel bleeder valve. has new fuel pump and new fuel filter. started and ran fine after new pump and filter install. drove 15 miles and parked all...


Check to see if fuel is getting to the filter. Maybe too much dirt in lines & plugged filter? If fuel at filter, put hose in place of filter JUST LONG enough to see if fuel is getting to fuel rail.

Mar 15, 2011 | 1998 GMC Jimmy

1 Answer

Xterra car quit running. had no spark @ distributor. replaced crank sensor and got spark. no gas pressure. replaced fuel pump, new one do not work. no power to it. checked fuses/relays, no luck. ran...


the fuel pump fuse is fuse #1 15amp in the inside fuse box ( left side of dash behind fuse box cover ) the fuel pump relay is behind left side of dash ------- cavity #2 & #5 at the relay should have battery voltage in start and run cavity # 3 is the power out to fuel pump and cavity #1 is the ground that is turned on by the on board commputer.

Jan 15, 2011 | Nissan Xterra Cars & Trucks

2 Answers

Secondary fuel pump is going out what do i have to fix


Your 2000 Ford. only has one fuel pump, no secondary, if no fuel pump pressure, check fuse, if fuse good, check voltage at fuel pump connector, fuel pump sit in gas tank, check voltage there, will only have voltage for 3 -5 seconds, every time the key is cycle, from on to off, if you have voltage there, bad fuel pump, fuel tank will have to come off, to replace fuel pump.

Sep 01, 2010 | 2000 Ford Taurus

1 Answer

Gas cut off, if any and location ?


there is a fuse under the hood in the fuse box. check them all there is also a fuse in the fuse box inside the vehicle. check them all. toyota is notorious for not labeling correctly not all components are on the panel listing

Jun 28, 2008 | 1990 Toyota 4Runner

Not finding what you are looking for?
1996 Jeep Grand Cherokee Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...