Question about 1999 Mercury Sable
Vibration on gas pedal when driving
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
I hace a 19196 sable-the problem is the transaxle speed sensor-this part sends all speed info to the computer ..-First symptom(speedometer stops working and then transmission shifts erratacially and power steering becomes hard and engine light comes on..The computer on this all eletronic car cannot send proper signals to the speedo-trans-power steering and other functions without knowing how fast or slow the car is going..Have the SPEED SENSOR mounted on top of the tranaxle replaced and all will be well.Part is not to expensive.labor can vary depending whether you have 3.0OHV or DOHC engine-some cars have to have exhaust dropped to get at it-Good Luck All
Posted on Sep 15, 2008
will it sounds like the fuel filter is clogged, replace the filter, if that dont work your fuel pump is bad.. sounds like the filter.. good luck keith...
Posted on Mar 19, 2009
If it "RED" in color, like p/s fluid, and coming from the BOOT, then its your p/s rack assembly.The unit has to be replaced and alignment reset. ..also check the HOSES they are prone to leak also...hope this helped..GL
Posted on Jul 06, 2009
You has a vacuum leak on the engine.
In order to troubleshoot this, you must start with a clean engine wipe down.
The major offender parts are
air intake gasket on the manifold
air tube after the mass air flow sensor
rubber seal under idle air control IAC motor
Warm up the engine for 15-20 minutes (LEAVE THE engine at idle) then spray a little Barmen carburetor clear on the potential air leak location (ONE AT A TIME) and listen for a surge in rpm.
If the engine speed go higher that's mean the carburetor clean (ADDITIONAL FUEL) got into your engine and that's the gasket you need to change.
There may be multiple leaky spots so take your time and check all rubber gaskets,sensor and hose that are lead into the intake manifold.
When you finish fill up with one tank of Chervon to clean out the injectors.
Please post more information after your inspection.
Posted on Aug 31, 2009
Tips for a great answer:
Mar 19, 2015 | 1999 Mercury Sable
Oct 25, 2013 | 1998 Mercury Sable
Mar 25, 2013 | 1999 Mercury Sable
Mar 05, 2013 | 2004 Mercury Sable
Jun 08, 2012 | 1998 Mercury Sable
May 10, 2011 | 1999 Mercury Sable
Jan 03, 2011 | 1999 Mercury Sable
Feb 14, 2018 | 2001 Mercury Sable
Mar 19, 2009 | 1999 Mercury Sable
12 people viewed this question
Usually answered in minutes!