Question about 2000 Volvo S70

Open Question

Engine code cylinder #1 and would not pass maryland state inspection emission control

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 14036 Answers

SOURCE: emission code 0455

code CODE PO455 fuel tank large leak.replace it .dont cost much.if that not it you have a evaporative leak.

Posted on Apr 11, 2009

Ad

SOURCE: I have a volvo s70

We need to walk through a few things. What is the state of your transmission fluid. In good condition the fluid should a vibrant pink and be clear. The smell should be a pleasant almost fragrant light oil. If your fluid is brown and/opaque then this indicative of wear. The smell is an unpleasant over-cooked burnt aroma. The brown colour is from the band clutches slipping and the friction wears the lining down and overheats the material - brown and burnt basically. If the fluid is opaque filter some of it through a kitchen paper towel. If there is grey sludge this is likely to be aluminium alloy. Pass a magnet over the sludge paste, if particles cling to the magnet these are flakes of steel. If you remove the bottom tray to the gear box the frst thing you see is the underside of the metal filter. If you remove this you can see the sort of material trapped in it. If it is just over cooked fluid then a filter and fluid change would be good place to start. If there is particulate sludge this is an indication of imminent failure. You do not mention the code specifically. If it is a selector solenoid then this can be replaced without the huge expense of a new transmission. In the old days a mechanic would know what the the fault was and try to repair the part. Subsequently this has given way to just replacing the part, then to a strategy of replacing parts until it works, to finally a situation of lets replace the whole assembly!

Posted on Aug 22, 2010

  • 47 Answers

SOURCE: I have a 1996 volvo

The given code indicates that your car is running rich on back one. This is usually caused by a dirty mass airflow sensor. Clean or replace.

Posted on Jan 07, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 ford five hundred - engine code P0301. When first starts, no issues, but then idle gets rough and car loses power. Miles from home with no tools but willing to do whatever.


P0301 cylinder # 1 misfire !
P030x - Cylinder x Misfire Detected Description: NOTE: x represents cylinder number 1 through 9.
The misfire detection monitor is designed to monitor engine misfire and identify the specific cylinder in which the misfire has occurred. Misfire is defined as lack of combustion in a cylinder due to absence of spark, poor fuel metering, poor compression, or any other cause. Possible Causes:
  • Ignition system
  • Fuel injectors
  • Running out of fuel
  • EVAP canister purge valve
  • Fuel pressure
  • Evaporative emission system
  • EGR system
  • Base engine
Diagnostic Aids: The malfunction indicator lamp (MIL) blinks once per second when a misfire severe enough to cause catalyst damage is detected. If the MIL is on steady state due to a misfire, this indicates the threshold for emissions was exceeded and caused the vehicle to fail an inspection and maintenance tailpipe test. Application Key On Engine Off Key On Engine Running Continuous Memory All - - GO to Pinpoint Test HD . Could be an ignition coil !An to replace it the intake manifold has to come off !

Aug 01, 2015 | Ford Cars & Trucks

1 Answer

I have 99 Chevy Malibu. My check engine light came on. The original codes were for a cylinder misfire and a small emissions leak. I replaced the injector for the cylinder that was misfiring as well as all...


well if you get it scanned again, and you get a lean bank 1 and 2 code then you may have a intake manifold gasket thats leaking. I just worked on a van that had them codes. and I ended up changing the intake manifold gaskets to get it to pass the emissions test for inspection, I live in new york state, po171 and p0174 are the lean codes. we did the maf sensor, new 02 sensors, egr valve and still got this lean code. good-day and god blessyou. it was on a 99 ford windstar van.

Oct 03, 2011 | 1999 Chevrolet Malibu

1 Answer

I have a 2000 volvo s80 with the code p0455 what can i do and what does this code mean?


evap emission control system leak ( large ) vent line off of gas tank to engine is leaking gas fumes its best to go to a dealer for this or a shop with a smoke machine tester it pumps smoke into the line to show where the leak is you wont pass inspection with this if they do emissions testing in your state hope this helps

Oct 03, 2010 | Volvo S80 Cars & Trucks

1 Answer

Knock sensor replacement ....2003 kia rio....emissions ...obd II....failure...need to pass inspection...failure code P0325 (Knock sensor 1 circuit malfunction)....where vis the knock sensor located on a...


Turn ignition off. Disconnect knock sensor 3
-
pin harness connector. Locate knock sensor, on cyli
nder block.
On Optima 2.7L engine, sensors are located on both
sides of cylinder block. . Remove knock
sensor from cylinder block. To install, reverse rem
oval procedure.

Mar 19, 2010 | 2003 Kia Rio

1 Answer

Did not pass state inspection (vehicle)


First the fault codes,
U110C is No Fuel Level Bus Message
U0155 is No Cluster Bus Message.
Unfortunatly you have to be able to communicate with the instrument cluster with your scanner to diagnoise and I do not think an aftermarket scanner can do this.




Mar 02, 2010 | 2005 Chrysler PT Cruiser

1 Answer

Engine light on-trouble code P0452


EVAP fuel tank pressure sensor low output. It sounds like the charcoal -filled canister, it's near the gas tank in a cylinder shape.The canister may have cracks or a hose is leaking around the area and it will give a fault code of PO452. Are you smelling any odors or emission smell from the car?

Feb 26, 2010 | 2002 Ford Expedition

1 Answer

Same issue as above, except on a 2002 Taurus.


P1131 (Fault Location) Heated oxygen sensor (HO2S) 1, bank 1, bank 1-not switching, fuel trim (FT) weak mixture (Probably Cause) Wiring, intake/fuel system, HO2S, EGR system, oil level, camshaft timing, cylinder compression, ECM. Could be any one of these. Is your oil level ok on your dip stick?

Jul 31, 2009 | 2002 Ford Escape

2 Answers

2005 Dodge Grand Caravan codes P0456 and P0303. Engine light on. Changed Gas cap. Need to pass inspection. Please help with diagnosis.


p0456--emission control system leak(verysmall) leak, check all hoses to emission controls, cylinder 3 missfire detected. could be plugs, wires, or coil.this is code p0303,

Jun 04, 2009 | 2005 Dodge Grand Caravan

Not finding what you are looking for?
2000 Volvo S70 Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...