Question about Chevrolet Corvette

Open Question

How to turn off rear wiper Holden captiva 2006 problem engine running it run

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 365 Answers

SOURCE: Rear Windsreen wiper motor runs continuousley in

The "stop" function is in the motor of the wiper...remove the fuse and call it a day...You shouldn't use it anyway the rear glass is "soft" in these cars and the wiper action will damage the glass over time.
Sorry :o(

Posted on Jun 14, 2009

  • 2 Answers

SOURCE: problem removing rear wiper on 2006 honda pilot

You can't replace the wiper. But Parts department at any Honda dealer should sell the replacement blade (just the rubber part). I believe it was under $10. Good luck!

Posted on Aug 10, 2009

  • 632 Answers

SOURCE: Golf 4 rear wiper running on its own

Pull back the wiper stalk which is your wiper lever switch. Pushing it forward would set it to washer mode and wipe a few strokes.

Posted on Dec 27, 2009

  • 118 Answers

SOURCE: 2006 CRV rear wiper not working

Inspect the wiper where it attaches to the motor for any broken or missing parts. Also, examine the wiper itself for damage. If so replace it with another from your local auto parts store. Also if you ask, they will install it for you.

Posted on Apr 21, 2010

Testimonial: "Thanks for your help! "

  • 450 Answers

SOURCE: need directions to fit towbar

there is a standard tow bar and a 2000kg for genuine tow bars
you need to remove both tail lights,the bumper bar and reinforcement bracket, spare wheel and exhaust hangars on rear mufflers, remove the tie down bracket on LHS chassis rail(dont need this or the bolts that hold it on), so you can then bolt in place either of the 2 tow bars.
genuine wiring patch harness for trailer plug is my suggestion since its plug straight into vehicle and interfaces with vehicle, goes in right hand rear compartment remove lid then remove box, interface connector for trailer harness is there.
instructions can be printed out from dealers if you ask
some new kits dont come with instructions in kits because information is on dealer computers
there is a template to print out to cut hole in bumper bar for tounge area of tow bar, uses centre square dimple in bar but its a bit wider.

Posted on Sep 07, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Just wondering is there a dipstick to check transmission fluid in a 2006 Holden Captiva?

Hi Quick answer is no. The trans fluid is checked at a pre determined temperature under strict conditions. with a computer attached a plug is then removed from the trans and fluid should drip out. Because the fluid is extremely hot when test is run it is not advisable to be carried out other than by a qualified person as serious injury can occur. Good luck

Mar 13, 2018 | Holden Cars & Trucks

1 Answer

Replace rear reflector on Holden Captiva.

Nearly all reflector replacements are done from inside the trunk/boot. Sometimes you have to remove the rear lining near the reflector to access, or, sometimes the screws or nuts are accessible through holes in the inner skin.

Nov 09, 2016 | Holden Cars & Trucks

1 Answer

I got 2013 Holden captiva Diesel. Can't find the oil filter location. Can you please help me Thanks

It's a cartridge type filter that sits inside a vertical canister attached to an oil cooler that has (2) hoses coming out of it at the rear of the engine block behind the timing belt cover on the drivers side of the engine bay

Aug 28, 2016 | Holden Cars & Trucks

1 Answer

Traction control lights come on dash in Holden Captiva 2010 diesel lack of power

when the traction control is activated , there is a reduction of power from the engine to compensate for that lost traction control
run the fault codes , repair the reason for the traction control light and then reset the computer using a scan tool and the engine power will return

May 13, 2015 | Holden Cars & Trucks

1 Answer

I changed the spark plugs on my holden captiva took for test run. Now its idling rough when stationery.

Hi,if it was running fine before you put the spark plugs in just take them back out and with a feeler gage check the clearence of the spark plug it should then run ok.
(when the spark plug makes its jerny it gets thrown arrond a bit so always check the clearances,all the best.

Mar 17, 2015 | Holden Cars & Trucks

1 Answer

Remove the engine cover on a 2008 holden captiva?

not sure if you have answer to your oil filter. Diesel looking from front of vehicle left corner rear of engine , cover removed. 27 mm socket required . care taken awkward to remove oil will spill grab it with a piece of rag moving it down and under filter as it is removed. advise to suck out oil from lower filter body before refitting filter or oil will rise as filter is fitted and will spill over . Please also be aware which groove you remove the old oil ring from so as to fit a new o ring into the correct groove.

Dec 14, 2014 | Holden Cars & Trucks

3 Answers

Captiva inner door handle won't open door

Holden Captiva 2006 cx model,doors won't open but the driver door does, how do I get the other three doors to open have put it in to electrician and they don't know what's wrong with it.

Nov 19, 2012 | Holden Cars & Trucks

1 Answer

How do you reset the engine light on a Holden Captiva

With car in off and all doors shut turn key to on position then within 5sec press the accelerator pedal 3 times

Aug 10, 2012 | Holden Cars & Trucks

2 Answers

Holden captiva is lacking in power, check engine light comes on and traction control lights come on and decline ascent light on dash shortly followed by service light and a large clunk sound. The motor...

I got a same problem in Holden Captiva diesel 2010 model as soon as you accelerate on traffic light the traction control light comes on engine light on dash, engine lack of power, turn the engne off for few seconds and goes ok but engine light stays on dash. Checked with the tech tool, it comes fuel metering code, can bus code... What it could be????. I've already changed fuel filter and did general service, still comes on. ANY IDEA PLEASE. OR I BURN THIS CRAPTIVA

Oct 13, 2011 | Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

159 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

79851 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides