Question about 1992 Jeep Wrangler

Open Question

Transmission Quit pulling and won't shift into any gear including 4wd

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 6982 Answers

SOURCE: TRANSMISSION

sounds like either a bad speed sensor or controller. shift points are too high, should be at 2000 or slightly less. if fluid is good and clean and shifts do not flair, check those control units. Not sure about calibrate...could mean out of calibration...Id ask
another tech about that. (i don't know everything!)

Posted on Mar 12, 2009

Ad
  • 17 Answers

SOURCE: 2000 Jeep Cherokee Gear Grinding & 4WD Whine sound

Give a try by change your transmission/filters and Transfer case oil.

Posted on Oct 27, 2009

ZJLimited
  • 17970 Answers

SOURCE: Have a '93 Jeep Grand

If the transmission will not go into gear or has trouble finding gears and has the proper amount of fluid, the shifting linkage could be bent or misaligned, especially on automatic models. The linkage can be found on the driver side of the transmission, toward the top of the unit. Inspect it to make sure the components aren't bent or broken and have someone shift the Grand Cherokee while you watch from underneath. Most times, only minor adjustments are necessary.
Also, check Torque Converter and scanned the TCM (Trans Control Module) to know if some fault code is stored there.

Posted on Jul 21, 2011

  • 76 Answers

SOURCE: Transmission won't shift to low gear on take off.

you have a fuse to protect the transmission located under the hood.

Posted on Dec 08, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 ford explorer transmission won,t pull in any gear.


check make sure transmission fluid not too low or could have plugged transmission filter.or code scan for faulty transmission fluid pressure sensor or transmission range sensor bad or out of adjustment.transmission could have failed.garage has to run fluid pressure test see if transmission failed or you could have faulty shift solenoid..

Feb 26, 2013 | 2003 Ford Explorer Sport

1 Answer

Have a '93 Jeep Grand Cherokee, 4WD, 5.2L, 8 cyl, automatic that's not shifting. Transmission fluid looks good, no burnt smell, no metal bits in fluid, no grinding gears. Won't shift til you...


If the transmission will not go into gear or has trouble finding gears and has the proper amount of fluid, the shifting linkage could be bent or misaligned, especially on automatic models. The linkage can be found on the driver side of the transmission, toward the top of the unit. Inspect it to make sure the components aren't bent or broken and have someone shift the Grand Cherokee while you watch from underneath. Most times, only minor adjustments are necessary.
Also, check Torque Converter and scanned the TCM (Trans Control Module) to know if some fault code is stored there.

Jul 20, 2011 | 1993 Jeep Grand Cherokee

1 Answer

The speedometer quit working and the transmission won't shift out of 1st gear at the same time. How do you fix it?


sounds like a speed sensor to me. If you can make it to Advanced or Auto Zone have them pull the codes and see whats going on. Re-post if you need more help.
Good Luck and God Bless

Jun 06, 2011 | Chrysler Cirrus Cars & Trucks

1 Answer

1996 dodge ram 1500 4WD shifts into reverse fine starts off in 1st and will not shift into 2nd gear


Could be as simple as low transmission fluid, but it can also be your shift solenoids or gonked up valve body. Star with checking your transmission fluid level. On that vehicle its pretty simple. There should be a yellow dipstick. Vehicle needs to be on and on operating temperature. Gear selector in P or N. Pull the dipstick out and see what it reads.

Apr 11, 2011 | 1996 Dodge Ram

2 Answers

My 4x4 is stuck in four wheel low it is shift on the fly and i have already replaced the transfer case motor


Ok here is a long shot but sometimes it will work. Put the 4wd position switch to 4wd Lo, put your transmission in reverse and back up for about 50 yards, stop and put your transmission in neutral, then shift the 4wd to 4wd hi, wait a few seconds and shift the 4wd to 2wd hi, Sometimes the t-case will get stuck and this is how you reset the computer. I have known people that really got their t-cases messed up because they thought that shift on the go meant that they could shift the t-case into 4wd LO while moving but shift on the go is only for 4wd hi the gears will not mesh up fast enough for 4wd LO because the ratio is 1 to 1 . I hope this helps you.

Feb 08, 2010 | 1990 Ford Bronco

1 Answer

How do you shift to 4wd 99 wrangler


You can shift on the fly...as you are moving....into 4WD at speeds up to 40 MPH but simply grabing the 4WD selector and moving into the 4WD high gear. Low gear selection should be done at a stand still, with transmission in neutral position before proceeding in fwd. The low position is a "granny gear" that is for extreme situations where high 4WD will not suffice or get you out of a stuck situation.

Dec 31, 2009 | 1999 Jeep Wrangler

1 Answer

2000 Jeep Cherokee Gear Grinding & 4WD Whine sound


Give a try by change your transmission/filters and Transfer case oil.

Oct 27, 2009 | 2000 Jeep Cherokee

1 Answer

Automatic transmission wont shift.


smell the fluid, does it smell like burnt rubber, if it does you may have burnt the clutches. also if is 4wd make sure is not in 4wd.

May 28, 2009 | 1997 Chevrolet Blazer

1 Answer

1997 Blazer 4wd auto transmission


IT IS POSSIBLE THE FILTER CAME OFF and allowing it to **** air

Oct 06, 2008 | 1997 Chevrolet Blazer

Not finding what you are looking for?
1992 Jeep Wrangler Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...