Question about 2006 Chevrolet Equinox

Open Question

Replace rear shocks 2006 equniox

Replace the rear shocks

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

HOW DO YOU REMOVE THE SUPPORT TO FRAME BOLT ON THE REAR SUPPORT ASSEMBLY ON A PONTIAC TORRENT


Shock Absorber Replacement
Removal Procedure
Raise and support the vehicle. Refer to Vehicle Lifting
Remove the lower shock bolt.
For right side only, remove splash shield.
Remove the upper shock bolt.
Remove the shock from the vehicle.
Installation Procedure
Install the shock to the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.
Install the upper shock bolt.
Tighten the bolt to 110 Nm (81 ft. Lbs.).
For right side only, install splash shield
Install the lower shock bolt.
Tighten the bolt to 110 Nm (81 ft. Lbs.).
Lower the vehicle.


For complete step by step guide with diagrams click the link below:
http://carrepairworld.blogspot.com/2016/06/how-to-remove-rear-suspension-on-2006.html
This will help.
Thanks

Jun 02, 2016 | 2006 Pontiac Torrent

2 Answers

HOW TO REMOVE REAR SHOCK ABSORBERS 2006 RAV4




Difficulty: Easy-ish
Time: About 1 hour
Tools: Two 17mm spanners - ring and open. Long spanners may help.

As the chart below shows, it's quite normal for a shock absorber to have traces of oil around the top. However leaks like level 3 to 1 mean the shock absorber (SA) needs replacing.



Probably a good idea to replace in pairs.

As always, apply hand-brake, chock the opposite front wheel and without the vehicle raised, slightly slacken off the road wheel nuts.

Jack the vehicle up and place on an axle stand: Maintenance 4 3 Replacing Rear Shock Absorbers Rav 4 Club

Aug 13, 2014 | Cars & Trucks

1 Answer

Replace rear shocks


Your rear shock are self leveling and cost about 350 dollars each and should not need replacing and yes they are easy to replace

Mar 25, 2014 | 2006 Chrysler Pacifica

1 Answer

How to change rear shock absorbers for 2006 ford focus


I am sorry we have no diagram's of this type. You can access allthe cars repair info for a fee at his site: alldatadiy.com

Feb 16, 2012 | Cars & Trucks

1 Answer

How to change shock absorbers on a mg zt


Rear shocks would be in the boot or back seat - just unbolt and replace, you will have to remove both wheels. Front shocks may need a spring compressor if the shocks are inside the road spring, DO NOT ATTEMPT FRONT SHOCKS WITHOUT A SPRING COMPRESSOR YOU WILL GET SERIOUSLY HURT!!!

Feb 11, 2012 | 2006 MG ZT CDTi

1 Answer

Fluid leaking out of rear shock


it is most likely leaking through the seal, you will need to replace the shock absorber, it is best to replace the both of them so as they are both the same.....hope this helps.......cheers

Sep 07, 2011 | 2006 Chevrolet Uplander

1 Answer

Where do I put the supports when working underneath 2006 Chevy Malibu? I need to change my rear shocks


Look under the car - you'll see 2 long metal rails ( the frame rails) . Support each side with a 2 ton minimum jack stand fully extended approximately one foot ( 12" ) in front of the rear wheels. Now use your jack ( preferably floor style ) to lift one of the rear wheels to relieve the pressure on the shock. Remove fasteners securing the shock, then remove and replace the shock. If the new shock has a plastic strap attached, do not cut this strap until you have mounted the shock on the vehicle. If you do not have an exposed frame rail, you'll see a "pad" in front of the rear wheel close to the outside of the car - it should be about 10 inches in from the pinch weld and about 12 inches in front of the wheel. Use this pad for the stand and lift the vehicle by the c shaped bar that goes from 1 rear wheel to the other. Do not support the car with just the jack -it could let loose and drop the car on you.
Hope this helps!

Nov 15, 2010 | 2006 Chevrolet Malibu

2 Answers

How to replace rear shocks on a 2006 cadillac srx Have 125,000 miles on car and need to replace rear shocks


Your car should have different shocks from most cars, with the magnetic, electrical charge viscosity change. Be sure that the shocks are actually not functioning correctly.

Sep 13, 2010 | 2006 Cadillac SRX

1 Answer

No one makes air bags lifts for the Highlander 2wdr V6. How can you raise the rear to balance the load on the vehicle without changing the type of suspension. Which is a coil over-shock type? Bill Coker,...


Likely you can use monroe load leveler coil over shocks (check and see if they make them for yours) or you can replace stock rear springs with an aftermarket variable load spring.

Aug 06, 2009 | 2006 Toyota Highlander

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...