Question about 2001 Chrysler Town & Country

Open Question

Put blue devil to help stop transmissions front seal from leaking but didn't work any other sealants that may work without having to have a mechanic work on the transmission?

Transmission sealant that works for all seals that are leaking transmission fluid?

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 21 Answers

SOURCE: 1995 Chrysler Concorde transmission diagram

There are 3 places it could be coming from. (1) The outer rubber seal on the pump between it and the case (2) The metal clad seal in the center of the pump that seals against the converter hub (3) And, the 5 bolts that hold the pump in have washers under them. The seal around the outside likes to get hard and brittle with age, especially if it has gotten hot before, leading to cracks that leak. The converter seal will wear naturlaly from doing it's job and more so if the pump bushing is wore out. The bolts that hold the pump in can get loose because of vibration letting oil out around the threads and out into the world.

If you pull it out and don't find loose bolts or obvious signs of a leak, then I suggest changin out all the places I mentioned. If you take the trans out and tip it on it's ****, then the pump comes out with a couple slide pullers. Be careful not to let the clutch-pack(inputshaft) slide out any, this will make going back together easier. There is a gasket between the inside of the pump and the case that will most likely need replaced too so get that as well; it seals all the ports and passages around the pump. Replace the outer square "O"-ring and the metal clad seal in the middle, then lube the outer seal and set the pump in place. Line it up and drive it in with the handle of any hammer. Torque it down(23ft. lbs.) with new washers for the bolts or new bolts with integeral washers. Be sure to loctite the threads as well to prevent them loosening up. Wiggle turn the input shaft to double check it isn't bound up and then just put it back in the car.

It sounds like a pain and it can be, but, it's easy after you do a couple thousand. Just like falling off a log. Hopefully you just have to do it once.

Posted on Nov 13, 2008

  • 1 Answer

SOURCE: leaking transmission fluid

what kind of fluid uses about transmission .car lavita

Posted on Jan 04, 2009

c17hydro
  • 2984 Answers

SOURCE: Leaking transmission fluid took to transmission

Nothing listed for a recall or notice about your problem. There was one for a bad o-ring that would cause the transmission to shift out of gear but no defects for a recall.

It could have been material defect in the part in questioned. But, it sounds like you may have ran something over to start the damage or breakdown of the part. Do you remember hitting or driving over anything?

Posted on Dec 01, 2009

  • 1 Answer

SOURCE: fluid leak from the seal between the transmission

1996 Lincoln town car leak from engine transmission

Posted on Oct 19, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I installed a perma dry oil pan gasket on a Jeep Wrangler. It appears to drip out of the rear after engine is stopped. Wil your product seal the permanent dry?


we are not them, this is just public forum.....
what if it's was not the gasket, and the oil seal rear leaks.
or trans leaks.
is car opted with,,, a trans A/T or M/T (auto/stick?)
is the oil leaking (sniff sniff/ look)
engine oil (use engine dye to see it)
ATF (red) or GL3 (manual gear lub)
first is to make sure which lube is leaking, then fix that.
sealing pay, is 3 things, good gasket, good sealant, and skill putting it on (and letting the sealant cure per lable)

Oct 24, 2016 | Jeep Cars & Trucks

1 Answer

Does blue Devil oil sealant really work and will it harm your engine


Any oil sealant additive is designed to work with the existing oil. Most sealants are designed to "swell" seals and gaskets to help slow down oil leaks. All in all.... they don't work very effectively.

Jul 10, 2015 | Cars & Trucks

4 Answers

White smoke coming from exhaust slowly loosing radotor fluid


One of two things bad head gasket or a crack in the head or engine block or a warped head. Sorry three things

Mar 18, 2015 | 2004 Pontiac Grand Am

1 Answer

I had a mechanic come out and work on my Laredo about 8 months ago; it was leaking fluid from the rear main seal. He didn't fix the leak and since then the gear indicator doesn't match up, and I...


I don't know how you thought he could fix that leak when the trans has to come out? Take it to a transmission shop and stop guessing, and replacing perfectly good parts. Have the trans shop replace the rear seal while the trans is out.

Sep 12, 2011 | Jeep Grand Cherokee Cars & Trucks

2 Answers

Need to find a way to put in a rear main seal in my 1989 jeep cherokee 4.0 without pulling the transmission


The Rear main seal on a Cherokee with the 4.0L is a 2-piece seal and the transmission doesn't have to be pulled. You have to remove the oil pan and rear main cap. That's it. The transmission doesn't have to be removed. Hope this helps.

Best of luck

Jun 18, 2010 | 1989 Jeep Cherokee

1 Answer

Ford mondeo 1.8 td diesel, the problem is the power steering fluid is leaking, when i check it look like it was coming from the middle part of the radiator.how can i fix it and what parts do i need to get...


Have a look at the power steering fluid cooler it is just in front of the radiator behind the front bumper. The coolers corrode and leak. Also the seals can go, check for fluid leaking out of the boots at the track rods. Try this procedure :--- 1)Trace the source of the leak. Use a mirror on an extended handle to follow the puddle of fluid on your garage floor to the power steering system. Look on the hoses and gaskets to find from where the fluid could be leaking. 2) Add power steering stop leak additive to your power steering fluid. Lucas Power Steering Stop Additive is 100 percent guaranteed to stop seal leaks. In older cars, the seals shrink, causing leaks. The stop leak makes the seals swell to their original size. 3) Use gasket sealant if the gaskets are old and leaking. Sealant, such as Permatex, is resistant to engine fluids, and will help repair a leaky gasket. 4) Replace the gasket, if the gasket sealant does not work. Thanks. you can rate this solution and show your appreciation.

May 19, 2010 | Ford LTD Cars & Trucks

2 Answers

Leaking oil fro the bottom front I had the motor changed and they say its the main seal . But i want to do it myself


Its likley the Crank seal, also called front main ( rear main being the end that meets the transmission.

Its pretty easy to do you just have to remove the serpentine belt, and remove the crank pulley, then you can pry out the old seal with a pick or screwdriver, clean the area from dirt and debris. then put the new seal in place, you can use a large socket that fits the ring of the seal, and hit it in with a hammer, keep hitting evenly around the seal so it goes in straight

Apr 10, 2010 | 1994 GMC Sierra

1 Answer

Freeon only works for 1 day. Can,t see where it ie leaking.


A lot of times the leaks on Air systems is the front seal on the compressor. Sometimes it is very difficult to see. Are you sure it is leaking? Did you check your pressures?

Jul 12, 2009 | 1996 Chevrolet Cavalier

3 Answers

Newer oil pan gaskets for Ford, not like original..leaking again


try warming up the engine a little then re-tightening the bolts,if that doesnt work,mark where its leaking and pull the pan back off and apply sealant to that area a little heavier than the rest of the gasket surface,dont use too much on a new gasket,just a really thin coat...USE "ULTRA BLUE" sealant,NOT blue or black RTV silicone,silicone wears out and it can leak after a while..Allow the ultra blue sealant to dry for about 30 minutes before re-assembling it,and clean off all oil from the gasket before applying the sealant,its ok to apply it to both sides of the gasket,and add a glob to all 4 corners where the gasket meets with rubber seals around the crankshaft,but put those globs on right before you put the pan back in place,the sealant has to be wet to squish in enough..i hope this helps

May 09, 2009 | 1999 Ford Explorer

Not finding what you are looking for?
2001 Chrysler Town & Country Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...