Question about 1987 Chevrolet S-10 Pickup

Open Question

Free diagrams chevy s10

DRIVERS SIDE WINDOW FALLS FORWARD WHEN TRYING TO ROLL IT DOWN AND HAVE TO PUSH THE WINDOW BACK TOWARDS THE TRACK WHEN TRYING TO ROLL IT BACK UP. WHAT DO I NEED TO GET TO REPAIR IT?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 4 Answers

SOURCE: passenger side power window wont roll up

The problem may be in the wiring which if you pull up the carpet on the front passenger side by removing the door floor trim and lifting the carpet you will see the wiring underneath. Probably laying in water or has been. Look for splices in the wiring which will have corroded. Repair the wiring then check the fuse.
Another problem may be in the motor found inside the door. The brushes may have worn out. If so you need to replace the motor. Ususally the drivers side will fail first since it is the most used.

Posted on Dec 21, 2008

Ad
motor1258
  • 6674 Answers

SOURCE: 2004 chevy cavalier. the driver's side window

Try spraying silicone lube (generously) down the felt tracks on either end, as well as up sides, and see if that helps. Work window up & down.

Posted on Mar 05, 2009

  • 14 Answers

SOURCE: Chevy Venture Passenger side windo won't roll up

wiring harness on passenger door has a severed wire

Posted on Mar 15, 2009

  • 59 Answers

SOURCE: 2007 Chevy Cobalt driver side power window will not roll down

The most likely cause is that the window motor has gone out. Is the car still under warranty? One way to check the motor is to turn the ignition on, don't start the engine, then try to operate the window while watching the dome lamp. If the lamp dims when you activate the switch, it is most likely the window motor. If not then next likely cuplprit would be the switch.

Posted on Aug 27, 2009

  • 1 Answer

SOURCE: 94 chevy s10 blazer power windows not working

I had the same problem - driver side fine, passenger side front not working/slow or the back seat. You need to replace the window motor on the passenger side. Yes, there are two motors. It's pretty simple if you are handy with some tools. The hardest part is getting the 4 mounts that hold the window motor to the door off. The are factory riveted to the door, so I had to grind the outsides off and tap them out. Just watch the spring lever that holds the window bar for going up and down. I didn't pay attention and it snapped back - nearly broke my thumb.

Dani-Lynn

Posted on Oct 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Put drivers side window back on track


The track is probably broken, most of them are made of a plastic material and if they become stuck will break.

Aug 15, 2013 | 2005 Pontiac G6

1 Answer

1992 Toyota Pickup Window is hard to roll up


Gotta pull the panel back off and see what is happening inside the window track GUIDES.
There are 3 adjustments.
There are plastic rollers to guide the window in it's track.
You will see.

Mar 10, 2013 | 1992 Toyota Pickup

1 Answer

Dodge Neon Passenger Window off track


You have to remove the inner door panel, End then put it back into the track,

Nov 04, 2012 | 2003 Dodge Neon

1 Answer

While my driver's side window (2004 Honda Civic) was rolled down at a drivethru, I heard it fall and now it won't roll back up. I can hear the motor trying to roll it up when I press the button, so I...


it must have fallen off its track. you would have to pull the door panel off (usually two-three screws/bolts and about twelve little plastic tabs that break really easy so be gentle.) and carefully place the window back up on its track. be sure its not too far back or too far forward when you tighten it into place or it wont slide properly. be sure not to have you fingers in the way when you test it to be sure it tracks properly before closing everything back up. also be sure not to over tighten the holding brackets (especially in the cold) or you could crack the window.hope this helps

Dec 22, 2010 | 2004 Honda Civic

1 Answer

Driver power seat not working correctly . 1997 Chevy Tahoe. Driver seat will go up and down and starts to go back but stops and doesn't go forward make a zzzzzzzzzzznoise. Worked fine yesterday today it...


this can be a few things, you may have a bad motor, or a broken cable to motor or seat track and last maybe a broken track, the best way to diagnose would be to remove the seat flip it over while still conected,meaning; remove the bolts at the bottom of the seat then push seat back toward the rear seat this way you can see the track, now move the controls as you watch the track,it may go sideways instead of straight back or foward this will show you what side is not working from there you can see if its a cable broken or track or motor not turning .

Jul 26, 2010 | 1997 Chevrolet Tahoe

1 Answer

Driver's side power window will not roll up


Sounds like wear and tear on the guides/seals.

May 19, 2009 | 1995 Honda Accord

1 Answer

Windows defective


The window track is out of adjustment and the track lining is probably warn. You need to remove the door panel to gain access to the window track. Once in the door you will see the tracks and the adjusting nuts. Loosen the nuts and snug up the track, not too tight and not bent.Try the window a few times before reassembly. Great truck I hope he enjoys it, good luck.

May 08, 2009 | 1989 Chevrolet S-10 Blazer

1 Answer

Window on driver side falls down and makes a lous noise


probably worn out regulator,especially if you haer the motor when you press the button,try various nissan wreckers it should be $100 maybe $200 but thats it labour should be 1 to 2 hrs depends on mechanic,definately window reg problem

Mar 06, 2009 | Datsun Maxima Cars & Trucks

1 Answer

1990 Dodge Shadow driver and passenger windows fall of track.


i have a 92, same problem; the plastic tab on window is worn .dealer part 5 dollar part held on with brass rivet i used slip pliers to install also check guides to make sure they are not lose.

Feb 19, 2009 | 1990 Dodge Shadow

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...