Question about 2001 Toyota Opa 2.0

Open Question

Replacing the tail light - 2001 Toyota Opa 2.0

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tail lights don't work but brake lights do


In driver's side J/B1 where you found and replaced the 10A TAIL FUSE, you will find the TAIL-LIGHT RELAY.

Jan 30, 2014 | 2001 Toyota Sienna

1 Answer

Passenger tail light out the top one replaced tail light socket still not working bulb is 3157


These have a circuit board in the tail lights.They are prone to failure due to moisture The replacement boards are available after market from any parts store that sells dorman products

Jan 18, 2014 | 2003 Dodge Durango

1 Answer

The tail lights do not work. The headlights, blinkers, and brake lights work. I checked the fuses and they are all good.


It can be faulty tail light bulb or its issue with tail light control switch or its wiring's are short.

Check the voltage at fuse slot of tail light.Do you receive 12 volt there.If not,then it says tail light switch is not receiving power supply.


---------
There are few help links related to your problem.I suggest you refer the list and check the help links.Click the link below:-----
1994 Toyota Camry: Bypass Tail light Relay Circuit? http://whatisbyme.blogspot.in/2012/04/1994-toyota-camry-bypass-tail-light.html

-----------
2008 Toyota RAV4: Replace Tail light Lens Cover?


http://technoanswers.blogspot.in/2012/04/2008-toyota-rav4-replace-tail-light.html
--------
2003 Chevrolet S10 Tail light Fuse http://schematicsdiagram.blogspot.com/2012/11/2003-chevrolet-s10-tail-light-fuse.html
--------- Chevrolet Parking light and Tail lamp light Wiring diagram http://schematicsdiagram.blogspot.com/2012/11/chevrolet-parking-light-and-tail-lamp.html
---------- Car Tail Lights Not Working?

http://schematicsdiagram.blogspot.com/2011/12/car-tail-lights-not-working.html

----------
Turn Signal Not working http://technoanswers.blogspot.com/2012/11/turn-signal-not-working.html
---------- Right turn signal not working on Pontiac Car?

http://schematicsdiagram.blogspot.com/2011/12/right-turn-signal-not-working-on.html

--------
Only one side indicator light working on car?

http://schematicsdiagram.blogspot.com/2011/12/only-one-side-indicator-light-working.html

-----------
Turn signals not working on 1987 Jeep Wagoneer? http://schematicsdiagram.blogspot.com/2011/12/turn-signals-not-working-on-1987-jeep.html

-----------

SOLVE YOUR 4 WAY FLASHER RELATED PROBLEMS HERE
http://repairhelpcenter.blogspot.com/2012/11/4-way-flasherturn-signal-flashersignal.html

----------
Thesedetails will help.
Thanks.

Nov 23, 2012 | Cars & Trucks

1 Answer

How to install evo 5 tail lights


check see tail light lens has 4 screws holding it in place.if so remove 4 screws then remove rear tail light lens then replace tail light bulbs.if you have trouble replacing tail light bulbs the auto parts store sales person will help you free of charge and help you replace bulbs.i have seen auto parts stores sales person help people replace batteries,windshield wiper blades and light bulbs in vechicle if you have trouble fixin it your self.

Feb 06, 2012 | 1998 Mitsubishi Lancer

1 Answer

Change out a taillight


You want to change the tail light bulb?

The process for replacing tail light bulbs is the same in all models. If you have a burnt-out tail light bulb, you may need to replace the brake light, the reverse light or the turn signal. The procedure to replace each of the bulbs is the same.



    Instructions

    1. Open the Hummer's rear swing gate. This will expose the edge of the vehicle's tail light assembly. You'll see two small Phillips head screws that hold the tail light assembly in place. Put on your gloves.

    2. Remove the two screws from the tail light assembly. Pull the tail light out and inspect the back for two bulbs. The top bulb is the brake light and turn signal. The bottom bulb is the reverse bulb. Determine which bulb you need to replace.

    3Rotate the bulb's socket counterclockwise to disconnect it. Unplug the bulb from its socket.

    4Push the replacement bulb into its socket firmly. Insert the socket back into the tail light. Turn it clockwise to secure it in place.

    5Place the tail light into its cradle. Hold it with one hand and replace the Phillips head screws with the other.

Dec 03, 2010 | 2008 Hummer H3

1 Answer

How do i replace the tail light bulb?


to replace the GM tail light bulb, you will drop down the tail gate and you will notice 2 screws on the tail light assembly, you will remove those 2 screws with the proper screw driver, once you do that the whole tail light assembly will come off, then you will see onother 2 screws holding the light panel to the tail light assembly, or brackets holding the light panel to the tail light assembly remove either or and you will have access to the three bulbs on that light panel, replace the burnt one and follow the same intrunctions to put back.

Apr 06, 2010 | 2005 GMC Canyon

1 Answer

Replace tail light 2005 jeep liberty


REPLACING THE BULB IS EASY. OPEN THE LIFT GATE, LOOK TO THE SIDE THAT YOU ARE REPLACING. RIGHT BESIDE THE TAIL LIGHT THE ARE TWO SCREWS. REMOVE THEM AND TAIL LIGHT SHOULD JUST PULL OUT. MAKE SURE TO UNPLUG IT AFTER IT IS LOOSE TO MAKE IT EASIER TO REPLACE THE BULB.

Feb 26, 2010 | 2005 Jeep Liberty

1 Answer

Can left 2000 mustang tail light lamp be replaced


Call a different dealer I never heard of that on any left or right tail lamp.
center stop lights yes I have

Feb 04, 2010 | 2000 Ford Mustang

2 Answers

How to replace tail light


First you need to lift the hatch. There are two screws under plastic caps. Remove the caps and you will be able to unscrew these screws. Carefully using a flat screw driver to pry out the tail light assembly. It have to plastic pin that attached to the car body. do not break the pin. After you pry out the tail light assembly, you will be able to replace the light bulb. Replace everything in a reverse order.

Nov 17, 2008 | 1999 Lexus RX 300

Not finding what you are looking for?
2001 Toyota Opa 2.0 Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...